Avision DS8000C Manual de usuario
DS8000C User's Manual
ii
Trademarks
The brands and product names herein are trademarks or registered
trademarks of their respective holders.
Copyright
©2001 Avision Inc. All rights reserved. No part of this publication
may be reproduced, transmitted, transcribed, stored in a retrieval
system, or translated into any language or computer language, in any
form or by any means, electronic, mechanical, magnetic, optical,
chemical, manual, or otherwise, without the prior written permission
of the manufacturer.
Warranty
The information contained in this document(s) is subject to change
without notice.
The manufacturer makes no warranty of any kind with regard to this
material, including, but not limited to, the implied warranties of
fitness for a particular purpose.
The manufacturer shall not be liable for errors contained herein or for
incidental or consequential damages in connection with the furnishing,
performance, or use of this material.
DS8000C User’s Manual iii
The Federal Communications Commission Statement
Note this equipment has been tested and found to comply with the
limits for a class A digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may
cause harmful interference to radio communication. Operation of this
equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at
his own expense.
You are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void your
authority to operate the equipment.
The device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
CE Warning!
This is a class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to
take adequate measures.
iv
Table of Contents
1Getting Started.......................................... 1-1
PRECAUTIONS..................................................................................................1-1
INTRODUCTION...............................................................................................1-2
EXTERNAL VIEW......................................................................................1-2
THE FRONT VIEW ...........................................................................1-2
THE REAR VIEW...............................................................................1-3
CONTROL PANEL.............................................................................................1-4
2Setting up Your Machine .............................. 2-1
MINIMUM CONFIGURATION REQUIREMENTS..........................................2-1
CHECKING PACKAGE CONTENTS...............................................................2-1
UNLOCKING THE SCAN UNIT ......................................................................2-2
SETTING UP THE ADF (AUTO DOCUMENT FEEDER) (OPTIONAL)....2-3
CONNECTING THE CABLES..........................................................................2-4
CONNECTING THE PRINTER CABLE ..................................................2-4
CONNECTING THE ADF CABLE ...........................................................2-4
CONNECTING THE POWER AND TURNING ON THE MACHINE..2-5
3Operation................................................ 3-1
LOADING PAPER..............................................................................................3-2
NOTICE ON USING THE ADF................................................................3-2
PLACING DOCUMENT(S) IN THE ADF................................................3-3
PLACING DOCUMENT(S) ON THE GLASS.........................................3-4
ACCESSING COPY FEATURES ......................................................................3-5
CHANGING SCALING..............................................................................3-6
CHOOSING PAPER SIZE.........................................................................3-7
DS8000C User’s Manual v
SELECTING PHOTO OR TEXT..............................................................3-8
ADJUSTING DENSITY.............................................................................3-9
INCREASING COPY COUNT................................................................3-10
CHOOSING COPY QUALITY................................................................3-11
4Troubleshooting ........................................ 4-1
LCD MESSAGE DURING SCANNING AND COPYING................................4-1
INFORMATION CODES....................................................................................4-1
CLEARING A PAPER JAM...............................................................................4-2
CLEANING THE GLASS...................................................................................4-3
TECHNICAL SUPPORT....................................................................................4-4
Appendix ....................................................... A
QUICK GUIDE .......................................................................................................a
SPECIFICATIONS..................................................................................................d
INDEX......................................................................................................................e
DS8000C User’s Manual Getting Started 1-
1
1Getting Started
Precautions
•Keep the machine out of direct sunlight. Direct
exposure to the sun or excessive heat may cause damage
to the unit.
•Do not install the machine near heating or air
conditioning units.
•Do not install the machine in a humid or dusty place.
•Be sure to use the proper AC power source.
•Only use the AC adapter (model name ADP-50ZB made by
Delta Electronics, Inc.) included with the machine.
Using other AC adapters may damage the machine and
void the warranty.
•Place the machine securely on an even, flat surface.
Tilted or uneven surfaces may cause mechanical or
paper-feeding problems.
•Retain the box and packing materials for shipping
purposes.
Getting Started1-2
Introduction
Thank you for purchasing the Avision DS8000C. The DS8000C
provide you a fast and affordable access to color digital
copying by simply connecting the product to a color laser
printer. The new way to make digital copies is cost-saving
and it produces a dramatic high-quality copy result compared
to regular analog copier.
EXTERNAL VIEW
THE FRONT VIEW
1. Document Cover
2. Control Panel
3. LCD-display
1
2
3
DS8000C User’s Manual Getting Started 1-
3
THE REAR VIEW
1. Document Cover
2. RJ-45 Network Port (For updating
printer profile, and firmware)
3. Printer Port
4. ADF Port
5. Power Jack
3
4
5
1 2 3 4
5
Getting Started1-4
Control Panel
uScaling Area:
Used to reduce document(s) down to 25% or enlarge it up to
400%.
Increase scaling in 1% increment
Decrease scaling in 1% Decrement
Select scaling from the preset percentage
vPaper Supply Area:
Used to detect your original paper orientation (for A3, A4
portrait, A4 landscape only) and specify your output paper
size.
Used to indicate A4 Portrait.
Used to indicate A4 landscape.
u
v
w
x
y
DS8000C User’s Manual Getting Started 1-
5
wLCD-display & Moving Keys:
Used to display current operation and select your command.
Moving Keys and Others:
Used to move to up/down/left/right.
xThe Copy Count:
Used to enter copy count.
LCD
-
display
Tabla de contenidos
Otros manuales de Copiador de Avision
