Avery Dennison Stacker Monarch 932TM Manual de usuario

Operating

Instructions

Operating

Instructions

23456

78901

Fishing Tackle

$40.00

23456

78901

Fishing Tackle

$40.00

23456

78901

Fishing Tackle

$40.00

23456

78901

Fishing Tackle

$40.00

Monarch®

932™ Stacker

Each product and program carries a respective written warranty, the only warranty on

which the customer can rely. Paxar Americas reserves the right to make changes in

the product, the programs, and their availability at any time and without notice.

Although Paxar Americas has made every effort to provide complete and accurate

information in this manual, Paxar Americas shall not be liable for any omissions or

inaccuracies. Any update will be incorporated in a later edition of this manual.

No part of this publication may be reproduced, transmitted, stored in a retrieval system,

or translated into any language in any form by any means, without the prior written

permission of Paxar Corporation.

WARNING

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own expense.

CANADIAN D.O.C. WARNING

This digital apparatus does not exceed the Class A limits for radio noise emissions from

digital apparatus set out in the Radio Interference Regulations of the Canadian

Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les

limites applicables aux appareils numériques de la classe A prescrites dans le

Réglement sur le brouillage radioélectrique édicte par le ministPre des Communications

du Canada.

Trademarks

Monarch®, 932, 9855, and 9860, are trademarks of Paxar Americas, Inc.

Paxar® is a trademark of Paxar Corporation.

Avery Dennison® is a trademark of Avery Dennison Corporation.

Avery Dennison Printer Systems Division

170 Monarch Lane

Miamisburg, OH 45342

TABLE OF CONTENTS

GETTING STARTED. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Unpacking the Stacker. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Installing the Stacker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Step 1 - Installation for the 9860 Printer . . . . . . . . . . . . . . . . . . . . . . . 1-2

Step 2 - Level the Stacker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3

Step 3 - Connect the Power Cord . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-4

Step 4 - Check the Alignment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5

Step 5 - Set the Tag Width. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-7

Step 6 - Set the Belt Speed. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-8

HOW TO OPERATE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1

Re-Loading or Changing Supplies. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2

Emptying the Stacker. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2

Stacker Full . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2

Stacker Running . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3

Clearing a Tag Jam. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3

Installing Riser Blocks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4

TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1

SPECIFICATIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-1

Stacker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-1

Supplies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-2

Minimum Stacked Tag Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . A-2

i Table of Contents

ii Table of Contents

GETTING STARTED 1

The Monarch® 932stacker works with a Monarch® 9860

printer. The stacker supports backfeed mode on the printer. There

is no power ON/OFF switch for the stacker. Once the stacker is

plugged into an outlet, it is on.

Unpacking the Stacker

uImportant: After unpacking the stacker, look through all

packaging material for parts. Keep all packaging material

for future shipping.

Installing the Stacker

Use these instructions when you first install the stacker or when

you need to move the stacker to a different location.

Before installing:

uFind a level work surface at least 52" x 22"

(1321 mm x 559 mm).

The 9860 printer comes with a knife attached.

uTurn off the printer before you install the stacker.

Getting Started 1-1

Step 1 - Installation for the 9860 Printer

1. Locate the screw hole on the stacker mounting plate.

2. Attach the adjusting bracket to the stacker mounting plate

using a flanged screw as shown (do not tighten all the way).

3. Gently lift stacker and center the guide tabs in the knife

opening.

4. Set the stacker locating pins (on bottom of stacker) firmly in

the adjusting bracket locating hole and mounting plate slot.

5. Tighten the adjusting bracket flanged screw.

6. Connect the stacker cable to the knife.

Stacker

Mounting

Plate

Adjusting

Bracket

Flangedscrew

Mounting

Plate

Slot

AdjustingBracket

Locating Hole

Guide Tab

Knife Opening

LocatingPin

1-2 Getting Started

Step 2 - Level the Stacker

1. Check the distance between the rollers and the knife. Make

sure the rollers are not touching the front of the knife or too

far from the knife. If incorrect, follow the steps below. If

correct, skip this step and move on to Step 3 - Connect the

Power Cord.

The ideal position for the stacker is with the

end of tray slightly down.

2. Loosen the locking nuts with a wrench.

3. Make sure the stacker’s feet are flat

on a level surface.

You can raise or lower the feet

by turning them.

4. Evenly adjust both feet.

If the stacker is

utouching the knife case, lower the feet.

utoo far from the knife, raise the feet.

5. Tighten the locking nuts.

Rollers

Knife

Locking

Nuts

Getting Started 1-3

Step 3 - Connect the Power Cord

1. Plug the power cord into the stacker’s AC inlet.

2. Plug the other end of the power cord into a grounded outlet.

Once the power cord is attached to an outlet, the stacker is

on. There is no power ON/OFF switch for the stacker.

ACInlet

1-4 Getting Started

Step 4 - Check the Alignment

1. Load supply in the printer. For more information about

loading supply, refer to the printer’s Operator’s Handbook or

Quick Reference.

2. Set aside the tag weight.

3. Widen the guide rails to maximum width by pulling and

extending the guide rails out of the grooves at the bottom of

the tray.

4. Slide the rod ends of guide rails by using both hands to the

outer position.

GuideRails

Grooves

Getting Started 1-5

5. Move tag stop up and down by using your thumb to pull out

slightly on the release tab and lift up until it stops.

Adjust the tag stop to the length of the tags.

6. Make sure the transport lock handle is in the locked position.

7. Make sure supply is loaded and the printer is turned on.

8. Press the Feed or Cut button on the printer or keyboard

several times.

The supply should feed through the knife and tags should be

cut and placed in the stacker tray.

TagStop

TransportLock

1-6 Getting Started

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Impresora de Avery Dennison

Avery Dennison

Avery Dennison Monarch ADTP1 Manual de servicio

Avery Dennison

Avery Dennison Wireless Ethernet Print Server Monarch 7411 Manual de usuario

Avery Dennison

Avery Dennison Monarch 9493 SNP Manual de servicio

Avery Dennison

Avery Dennison LOKPRINT 676 Manual de usuario

Avery Dennison

Avery Dennison SNAP 700 Manual de funcionamiento

Avery Dennison

Avery Dennison Monarch 9855 RFID Manual de servicio

Avery Dennison

Avery Dennison ALX 92x Manual de funcionamiento

Avery Dennison

Avery Dennison SNAP 500 Manual de usuario

Avery Dennison

Avery Dennison MONARCH 9416 XL Instrucciones de instalación y funcionamiento

Avery Dennison

Avery Dennison Monarch SIERRA SPORT4 9493 Manual de servicio

Avery Dennison

Avery Dennison Monarch 9419 Manual de servicio

Avery Dennison

Avery Dennison Monarch 9460 Manual de servicio

Avery Dennison

Avery Dennison Monarch Tabletop Printer 2 Manual de usuario

Avery Dennison

Avery Dennison Monarch 9485 Guía del usuario

Avery Dennison

Avery Dennison Monarch SIERRA SPORT4 9493 Manual de usuario

Avery Dennison

Avery Dennison Monarch ADTP1 Manual de usuario

Avery Dennison

Avery Dennison TrafficJet Manual de usuario

Avery Dennison

Avery Dennison ALS 104 Manual de usuario

Avery Dennison

Avery Dennison Monarch 9825 Manual de usuario

Avery Dennison

Avery Dennison Monarch 9419 Manual de usuario

Avery Dennison

Avery Dennison Monarch 9855 Manual de servicio

Avery Dennison

Avery Dennison 686 HT Manual de usuario

Avery Dennison

Avery Dennison Pathfinder 6057 Manual de servicio

Avery Dennison

Avery Dennison 9444 Manual de usuario

Manuales populares de Impresora de otras marcas

Lexmark

Lexmark 1400 Series Manual

Canon

Canon i70 Series Manual de usuario

Evolis

Evolis Elypso Manual de usuario

Kyocera

Kyocera FS-9530DN Manual de usuario

Canon

Canon LASER SHOT LBP-1210 Manual de usuario

Samsung

Samsung BIXOLON SRP-350plusF Manual de usuario

Canon

Canon PIXMA PRO-1 Series Manual de usuario

Canon

Canon PIXMA G3560 Guía de configuración

Dell

Dell Color Laser Printer 2130cn Manual de usuario

Tektronix

Tektronix Phaser 840 Manual de usuario

Epson

Epson ET-7750 Instrucciones de funcionamiento

Canon

Canon CLBR 460ps Manual de usuario

Eltron

Eltron P210 Guide Manual de usuario

Ricoh

Ricoh MD-P1 Manual de usuario

Epson

Epson SC-F7100 series Manual de usuario

Epson

Epson Stylus C40UX Manual de usuario

Canon

Canon imagePASS-A2 Manual de usuario

Canon

Canon S820D Manual de usuario