Avalla S-50 Manual de usuario
Air Conditioner
S-220S-50
Read this manual carefully before use and keep it for future
reference. Failure to do so may result in injury, property
damage and may void the warranty.
S-360
02
Contents
03 Quick start guide
• Hose connection and setup
04 Parts guide: S-50
05 Parts guide: S-220
06 Parts guide: S-360
07 Features and guidance
• Settings
08 Timer function
09 Remote Control
09 Specifications
10 Built-in automatic protections
• Automatic Defrost
• Overload Protection
10 Drainage
11 Maintenance and storage
• Cleaning the air filter
• Storage
• Disposal
12 Troubleshooting
12 Symbols from the unit
13 Health and safety
• General safety instructions
14 • Servicing safety precautions
15 • Connection to the power supply
Version 2.1.1
03
Quick start guide
Hose connection and setup
Place the unit on a level surface with at least 50cm of free space
around it, to allow good air circulation. Allow the unit to stand
upright for at least 24 hours after delivery or being stored on its side.
Attach the hose connector to one end of the
exhaust hose.
If using the window kit, attach the windows kit
adapter to the other end of the exhaust hose.
Extend the window kit to the height of your
window. Attach the exhaust hose to the
window kit.
Close your window to secure the window kit in
place.
Insert the fastening clasp into the window kit
and secure with washer and wingnut.
Attach the hose connector to the air exhaust
on the unit, then connect to a mains power
supply and turn the unit on.
Warning: Do not operate near combustible or explosive
materials, heat sources, or any objects that may block air inlet
and outlet. Keep the air inlet and outlet free of obstacles. Only use
in rooms that exceed the size stated on the unit rating plate.
04
Parts guide: S-50
Touch controls Display
01. Control panel
02. Adjustable cool air outlet
03. Filtered air inlet
04. Hot air exhaust
05. Drain outlet
01
02
03
03
05
04
Sleep
Timer
Up
Down
Speed
Mode
Power
Sleep active
Timer active
Low speed
High speed
Fan mode
Cool mode
Dehumidifier mode
Auto mode
05
Parts guide: S-220
Touch controls Display
01. Control panel
02. Adjustable cool air outlet
03. Filtered air inlet
04. Hot air exhaust
05. Drain outlet
Sleep
Timer
Up
Down
Speed
Mode
Power
Swing
Sleep active
Low speed
High speed
Auto mode
Cool mode
Dehumidifier mode
Fan mode
Power on
Lock active
Swing active
01
02
03
03
05
04
06
Touch controls Display
Parts guide: S-360
01. Control panel
02. Adjustable cool air outlet
03. Filtered air inlet
04. Air exhaust
05. Drain outlet
Sleep
Timer
Up
Down
Speed
Mode
Power
01
02
03
03
05
04
Sleep active
Timer active
Low speed
High speed
Fan mode
Cool mode
Dehumidifier mode
Auto mode
07
Features and guidance
Settings
Auto Mode - switches between cooling and fan mode.
• When the room temperature is above 24oC the unit will switch to
Cooling Mode
• When the room temperature is below 24oC the unit will switch
to Fan Mode
Cooling Mode – lowers the temperature of your room.
• Press Mode until the cooling light illuminates.
• Press Up / Down to adjust the temperature.
• Press Speed until the desired fan speed light illuminates.
• Press Sleep, if required, to enable sleep mode. The preset
temperature will increase by 1oC after 1 hour, and increase by 2oC
after 2 hours. The unit will operate for 6 hours in this mode.
Fan Mode – circulates the air in your room.
• Press Mode until the Fan mode light illuminates.
• Press Speed until the desired fan speed light illuminates.
Dehumidifying Mode – reduces the humidity level of your room.
• Whilst the unit is off, connect the drain hose to the drain outlet.
• Place the outlet of the drain hose into a bucket or drain,
ensuring that the end is not submerged in water as this may
cause an air lock. Make sure the hose is at an angle steeper than
20
• Turn the unit on and then press Mode until the Dehumidifier
light illuminates.
• The fan speed is not adjustable on dehumidifier mode.
• The exhaust hose is not needed. Dry air will blow out of the air
exhaust.
Note: Water will not drain from the outlet until the 0.4L internal
tank is full, this can take 4-5 hours.
If used without a drain hose attached, water will be collected in the
internal tank. Auto-shut off will occur when tank is full and ‘E4’ will
show on the display.
For optimal results, ensure the room temperature is above 18oC.
In dehumidifier mode; below 16oC the unit will enter defrost mode.
08
Child Lock (S220) - disables button use when enabled
• Press and hold Sleep mode until the lock symbol lights up.
• Press and hold again to disable lock feature.
Swing Setting (S220) - turns automatic louvres on or off
Timer function
The timer has two ways of operating:
To turn the air conditioner on (when power is off)
• Press the Timer button
• Press Up / Down repeatedly to set the delay ON time.
To turn the air conditioner off (when power is on)
• Press the Timer button
• Press Up / Down repeatedly to set the delay OFF time.
To cancel timer, press the Timer button twice or press Up / Down
repeatedly until display shows ‘0’
Note: Units represent hours. Eg ‘01’ equals 1 hour.
09
Specifications
S-50 S-220 S-360
BTU 3000 9000 10000
Circulation 150m/h 270m/h 270m/h
Temp’ range 15-31ºC 15-31ºC 15-31ºC
Input power 340W 950W 1100W
Remote Control
05 05
01 01
04
02 02
03 03
07 07
06 06
The remote control doubles up the functions of the control panel
for convenient operation at a distance.
01. Power
02. Settings - up/down
03. Timer - on/off
04. Swing setting - on/off
05. Mode select
06. Fan speed
07. Sleep mode - on/off
S-220 S-50 / S-360
10
Built-in automatic protections
Overload Protection
Automatic Defrost
When operating at low room temperatures, frost may build up on
the evaporator. If this happens, the Power LED will begin blinking
and the unit will automatically stop for a short time to carry out its
automatic defrosting procedure.
In the event of sudden power loss, to protect the compressor there
is an automatic 3-minute delay until the compressor will restart.
Drainage
The self-evaporating system uses the collected water to cool the
condenser coils, maximising performance and efficiency. There is no need
to empty the drainage tank for this cooling operation except when using
the dehumidifier mode or in high humidity conditions as typically the
condensate water evaporates into the exhaust outlet. If used for extended
periods of time, condensate may build up on the coils and excess water
will drain into the tank. Should the tank become full, follow the steps
below to drain.
For continuous or unattended operation, or operating in dehumidifier
mode, please connect the attached drain hose to the drain outlet.
Condensate water can be sent straight down a drain or collected in a
suitable bucket.
• Switch off the unit.
• For continuous drain: Remove the plug from the drain outlet.
When drainage tank full: Remove the plug from the drain outlet.
• Securely and properly connect the drain hose and make sure it is not
kinked and is clear of obstruction.
• Place the end of the hose over a drain or bucket and ensure that water
can freely flow out of the unit.
• Do not submerge the end of hose into water; otherwise it can cause an
air lock in the hose.
To avoid water spillage:
• Negative pressure may cause some water to remain. To avoid this,
ensure the drainage hose is at an angle steeper than 20.
• Straighten the hose to avoid a trap existing in the hose.
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Acondicionador de aire de Avalla
