1
Sales 800-633-0405 www.productivity2000.com
Warranty: Thirty-day money-back guarantee. Two-year limited
replacement. (See www.productivity2000.com for details).
2000
WARNING: To minimize the risk of potential safety problems, you should
follow all applicable local and national codes that regulate the installation
and operation of your equipment. These codes vary from area to area and
it is your responsibility to determine which codes should be followed, and to
verify that the equipment, installation, and operation are in compliance with
the latest revision of these codes.
Equipment damage or serious injury to personnel can result from the
failure to follow all applicable codes and standards. We do not guarantee
the products described in this publication are suitable for your particular
application, nor do we assume any responsibility for your product design,
installation, or operation.
If you have any questions concerning the installation or operation of this
equipment, or if you need additional information, please call Technical
Support at 770-844-4200.
This publication is based on information that was available at the time it
was printed. At AutomationDirect.com®we constantly strive to improve
our products and services, so we reserve the right to make changes to
the products and/or publications at any time without notice and without
any obligation. This publication may also discuss features that may not be
available in certain revisions of the product.
Terminal Block Specifications
Number of positions 4 screw terminals
Wire Range
22-12 AWG (0.324 to 3.31 mm²)
Solid / Stranded conductor
3/64 in (1.2 mm) insulation maximum
Use copper conductors, 75°C or equivalent
Screw Driver Width 1/4 in (6.5 mm) maximum
Screw Size M3
Screw Torque 7-9 lb·in (0.882 - 1.02 N·m)
P2-01AC Power Supply
The P2-01AC Universal Input Power Supply
provides isolated power to the
Productivity2000 base from an external
100-240 VAC source.
Warning ............................. 1
Terminal Block Specifications ............ 1
Power Supply Installation Procedure....... 2
Wiring ............................... 2
General Specifications .................. 3
User Specifications .................... 3
Hot Swap Information .................. 3
