Authonet Firewall F-10 Manual de usuario
Thank you for purchasing Authonet Firewall.
This Quick Start Guide will guide you through the installation and
configuration of your unit.
• Power Supply
• Ethernet/Internet Cables
To set up your Authonet unit, it only takes a few easy steps:
Connect an Ethernet cable from the WAN port of the unit to your
upstream network (modem or router)
Power on the unit by connecting the power supply provided.
Authonet is a business unit (DBA) of Fire4 Systems Inc., a Florida Corporation. Copyright © Fire4 Systems UK Ltd., 2018.
All rights reserved. Fire4, Authonet and the respective logos are registered marks of Fire4 Systems UK Ltd.
All other registered marks, trademarks, service marks and logos are the property of their respective holders.
Authonet
Firewall
F-10 Advance cybersecurity
POWER
RESET
LAN1 LAN2 LAN3 LAN4 WAN1
Collision
Power
Collision
Power
Connect an Ethernet cable from the LAN port to your computer. Open your browser and go to: https://ulogin.net
Once logged in, you will be redirected to the Authonet Firewall
overview page
The default admin login details are as follows:
Username: admin
Password: password
Wait 60 seconds for the Authonet Firewall unit to complete the
boot process.
On the first login the Introduction tutorial will load automatically on
the right hand side to guide you through the initial setup of your unit
The Authonet Firewall has a selection of tutorials available under the
support menu covering the operation of your unit
7. Use only the power supply shipped with the unit to prevent
damage.
Free online support available via our ticket system
https://www.authonet.com/support
All features of the Authonet units are documented online at:
https://www.authonet.com/docs
Collision
Power
Collision
Power
Otros manuales para Firewall F-10
1
Otros manuales de Cortafuegos de Authonet
