INSTALLATION-MANUAL
4-Colomn AL3044
AL4044
AL4044/VS
AL4044/VANS
AL5044
AL5044/T
ISSUED 22-7-2008
AUTEC Hefbruggen bv
INHOUDSOPGAVE PAG
1 Introduction 02
2 Packing, transport and storage 02
3 Safety specifications 02
4 Description of the lift 02
5 Installation 03
6 Connection to electrical mains 05
7 Safety checks 05
8 Goods received report 06
9 Electrical diagram 07
1. INTRODUCTION
CAUTION
This instruction manual is intended
for the assembly personnel who are
going to carry out the installation of
the lift.
2. PACKING, TRANSPORT
AND STORAGE
Every action involving the operation,
transportation or unpacking of the
equipment must only be done by
trained personnel who have a proper
knowledge of the lift, and who are
familiar with the contents of this
operating manual.
LIFTING AND MOVING THE
PACKING CRATES CONTAINING
THE EQUIPMENT
The wooden crates must be lifted and
moved with the help of a fork lift truck or
a lift crane. (Fig. 1)
Fig. 1
The equipment chosen must be
capable of lifting and moving the
equipment safely, keeping in mind
the dimensions of the vehicle, the
weight, the centre of gravity and
projecting and fragile parts.
STORAGE
The packed lift must always the placed
in a covered area at a temperature
between -10 oC and + 40 oC and must
not be exposed to direct sunlight.
OPENING THE CRATES
Check whether the machine have been
damaged during transportation, and
whether all the components as
mentioned in the Packing List are
physically present.
REMOVAL OF CRATES
The wood of the crates may be re-used.
It is strongly recommended
that you should first carefully read
the safety instructions.
3. SAFETY REGULATIONS
The manufacturer hereby refuses to
accept any responsibility for injury to
persons or damage to equipment or
property if it appears that incorrect
handling of the lift has taken place. This
instructions manual only describes the
operating- and safety aspects which
persons who are installing the machine
need to know. In order to understand
the terminology used in this manual, it is
necessary that the person performing
the installation work should have
specific experience in industrial work,
service, maintenance and repair
activities, and must also possess the
ability to explain the drawings and the
descriptions contained in this manual to
other people. At the same time he must
also be aware of the general and
specific safety regulations which apply
in the country where the lift is being
installed.
4. DESCRIPTION OF THE LIFT
(Fig.2)
The lift consists of the following :
Two platforms and four posts. The
columns are fixed to the floor with bolts.
The liftingsystem consists of a hydraulic
cilinder which converts the horizontal
movement by cabels and pulleys into a
vertical movement. The lift is controlled
by a controlbox mounted on the
controlpost.
Fig.2
CONTROL BOX (FIG.3)
The controlpanel of the controlbox
consists of the following:
11. Mainswitch
12. Lifting motion button
13. Descend button
14. Locking
Industrieterrein IJsselveld, Vlasakker 11, 3417 XT MONTFOORT, The Netherlands
en/TD-AL4044-02
