AURES LCDWIDE 22' FP Series Manual de usuario

LCDWIDE 22’ FP Series

Touch Screen LCD Monitors

USER’s GUIDE

Rev.B

The information contained in this document is subject to change without notice.

This document contains proprietary information that is protected by copyright.All rights

are reserved. No part of this document may be reproduced,translated to another language

or stored in a retrieval system, or transmitted by any means, electronic, mechanical,

photocopying, recording, or otherwise, without prior written permission. Windows is a registered

trademark of Microsoft, Inc. Other brand or product names are trademarks of their respective

holders.

The test results show that this device meets the FCC rules. Those limits are set to protect

residential areas from the devices with harmful emission. This device will produce, use and

radiate radio frequency energy. In addition, failure to follow the user’s manual to install or use

this device might produce harmful interference with radio communication. Not withstanding

the foregoing, it does not guarantee that this type of harmful interference does not occur in

some special installations. The interference caused by this device to the reception of radio

or television signals may be veried by turning it on and off. Any changes or modications to

this TFT LCD would void the user’s authority to operate this device.

Table of Contents

Usage Notice

Precautions............................................................................................................................. 1

Introduction

About LCDWIDE 22’ FP Series............................................................................................. 2

Touch Screen for LCDWIDE 22’ FP ...................................................................................... 2

Package Overview ................................................................................................................. 3

Installation

Product Overview................................................................................................................... 4

Front View ......................................................................................................................... 4

Bottom View ..................................................................................................................... 4

Attaching the L-Brackets ........................................................................................................ 5

Side Mount for Your Monitor................................................................................................... 6

VESA Mount for Your Monitor................................................................................................. 8

Sealing foam installation......................................................................................................... 9

Connecting the Display (Figure 10.1)................................................................................... 10

(Figure 10.1)......................................................................................................................11

User Controls

Back Panel Controls............................................................................................................. 12

How to Use the OSD Menus ................................................................................................ 13

On-Screen Display Menus.................................................................................................... 14

Appendix

Troubleshooting.................................................................................................................... 15

Warning Signal ..................................................................................................................... 16

No Signal......................................................................................................................... 16

Going to Sleep................................................................................................................. 16

Out of Range................................................................................................................... 16

Product Dimensions ............................................................................................................. 17

Compatibility Modes............................................................................................................. 18

Touch Screen Driver Installation........................................................................................... 19

LCDWIDE 22’ FP Driver Install Instructions................................................................... 19

Usage Notice

! Warning - To prevent the risk of re or shock hazards, do not expose

this product to rain or moisture.

! Warning - Please do not open or disassemble the product as this may

cause electric shock.

Precautions

Follow all warnings, precautions and maintenance as recommended in this user’s manual to

maximize the life of your unit.

Do:

• Turn off the product before cleaning.

• Touch screen surface may be cleaned using a soft clean cloth moistened with mild

window glass commercial cleaners or 50/50 mixture of water and isopropylalcohol.

• Use a soft cloth moistened with mild detergent to clean the display housing.

• Use only high quality and safety approved AC/DC adapter.

• Disconnect the power plug from AC outlet if the product is not going to be used for an

extended period of time.

Don’t:

• Do not touch the LCD Display screen surface with sharp or hard objects.

• Do not use abrasive cleaners, waxes or solvents for your cleaning.

• Do not operate the product under the following conditions:

- Extremely hot, cold or humid environment.

- Areas susceptible to excessive dust and dirt.

- Near any appliance generating a strong magnetic eld.

- In direct sunlight.

Introduction

About LCDWIDE 22’ FP Series

The LCDWIDE 22’ FP Series is a 21.5" at panel screen with an active matrix, thin-lm

transistor (TFT) liquid crystal display (LCD).

This unit is to be used as commercial and light industrial equipment only.

Features include:

• Direct Analog signal input

• Direct Digital signal input

• Active matrix TFT LCD technology

• 1920 x 1080 resolution

• 21.5" viewable display area - 16:9 aspect ratio

• 31.47 ~ 82.3 KHz horizontal scan

• 56 ~ 75 Hz high refresh rate

• 0.24795mm x 0.24795mm pixel pitch

• Auto adjustment function

• Multilingual OSD user control

• 100 mm VESA mount

• Touch screen with USB controller

Touch Screen for LCDWIDE 22’ FP

• Projected Capacitive touch screen for nger input only

• Surface: Glare treatment

• Interface: USB controller

• Transmittance: 90±5%

• HID: Windows® 7/8

• Driver: Windows®, VISTA, XP, 2000, CE, XP Embedded,

Linux kernel 2.6.X(32 bit & 64 bit), Apple®Mac OS.

Package Overview

LCD Display Power Cord VGA Signal Cable

DVI-D CableUSB Cable ( A to B ) DC Power Supply

Touch Driver CD

Remote Key

(sold separately)

Side Brackets

Bracket Screws

Product Overview

• Front View

• Bottom View

VGA USB

DC IN

DVI

RJ Type

Attaching the Side Brackets

Depending on your mounting scheme, alternately, you may use the side brackets to mount

your displays onto your wall or device.

Find a suitable location for attaching side brackets.

A. The left and right sides

B. The Top and bottom sides

Note:

You will need a screwdriver to attach the side brackets.

Your kiosk touch monitor included four side brackets (and eight screws, M4x8).

This equipment is intended to be mounted in accordance with the proper hardware and the

installation instructions supplied with the product. Use of mounting brackets or screws other

than those specied in the installation instructions may cause a hazard.

Bracket

Side Mount For Your Monitor

This monitor can be mounted to the wooden or concrete wall with 8 screws and two pairs of

brackets on the opposites.

186.0

20.0

1.0

37.4

1.0

220.0

4.1

51.6

Customer panel material:

1. Wooden wall: Ø4.5mm thru holes for M4 screws w/nuts, or no thru holes, screws for wood

4mm.

2. Sheet metal: concealed head threaded studs M4 w/nuts.

IMPORTANT!

The wall mounting instructions are for the qualied wall mounting person only!

! Warning!

Please select the proper screws!

The distance between the back cover surface and the bottom of the screw hole

is 8 mm. Please use four M4 screws diameter with proper length to mount your

monitor.

Please note: the mounting stand must be able to support at least 13.2 lbs (6Kg).

(158.7 mm)

317.3 mm +1.0

0.0

(260.7 mm)

521.4 mm +1.0

0.0

4-R7.4

RECOMMENDED CUSTOMER PANEL CUT-OUT

(65.0 mm)

130.0 mm

170.0 mm

(65.0 mm)

130.0 mm

170.0 mm

(158.2 mm)

316.3 mm+1.0

0.0

(260.2 mm)

520.4 mm+1.0

0.0

4-R6.9

546.6 mm

342.5 mm

RECOMMENDED CUSTOMER PANEL CUT-OUT

(Front Mount Recommend gap size 2.0mm)

(Rear Mount Recommend gap size 1.5mm)

Tabla de contenidos

Otros manuales de Monitor de AURES

AURES

AURES Posligne OLC15 Manual de usuario

AURES

AURES OLC 15 Manual de usuario

AURES

AURES LCDSLIM Manual de usuario

AURES

AURES OLC 10.1 Manual de usuario

AURES

AURES OLC 8.4 Manual de usuario

Manuales populares de Monitor de otras marcas

Linear Acoustic

Linear Acoustic LQ-1000 Manual de usuario

AOC

AOC I2579V Manual de usuario

Gateway

Gateway FPD1520 Manual de usuario

Furuno

Furuno Mu 120c Manual de usuario

Asus

Asus VB171D - 17" LCD Monitor Manual de usuario

Dell

Dell S2230MX Instrucciones de uso

Philips

Philips 107C64 Manual de usuario

Dell

Dell S2409WFP Manual de usuario

EverFocus

EverFocus EN-7517E Manual de usuario

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manual de usuario

Dell

Dell Precision 7680 Manual de instrucciones

LG 50PM1M - - 50" Plasma Panel Manual de usuario

Bosch

Bosch DDU 9 Manual de usuario

Acer

Acer A231HL Manual de usuario

Philips

Philips 86BDL4152T Manual de usuario

NEC

NEC AccuSync LCD5V Manual de usuario

Emay

Emay SleepO2 Manual de usuario

IBM

IBM 6360 Instrucciones de instalación