CHARGING
To charge using USB, Mobius supports 1
Amp chargers and takes approximately
3 hours to fully charge when Mobius is
powered off. When plugging Mobius
into a wall-wart, make sure the red LED
is on to indicate that charging is in
effect. Some older wall-warts and USB
Hubs might not provide enough power
to charge Mobius. Instead, please use a
1 Amp charger. When Mobius’ battery
is low, Mobius will attempt to charge
using the USB cable simultaneously to
keep you in the action. If you have a
USB Hub or extender, Mobius will work
equally well with these, but once again,
some USB hubs might not charge
Mobius. Please check your hub specs.
3
WIRED CONNECTION –
ANALOG (3.5 MM)
If needed, complete a wired connec-
tion with your Analog AUX cable in the
same way you connected via USB
previously. The Analog input exists on
the bottom side of the left ear-cup.
Make sure you don’t plug your cable
into the microphone input. You
wouldn’t be the first one to make that
mistake. Mobius has a balanced ampli-
fier built-in, so you do not need any
external amps to power this star of a
headphone. Additionally, some PC's
might have a separate connection
input for headphone and microphone.
In this case, obtain a splitter for your
inventory to split the TRRS connection.
To charge using USB, Mobius supports 1
Amp chargers and takes approximately
3 hours to fully charge when Mobius is
powered off. When plugging Mobius
into a wall-wart, make sure the red LED
is on to indicate that charging is in
effect. Some older wall-warts and USB
Hubs might not provide enough power
to charge Mobius. Instead, please use a
1 Amp charger. When Mobius’ battery
is low, Mobius will attempt to charge
using the USB cable simultaneously to
keep you in the action. If you have a
USB Hub or extender, Mobius will work
equally well with these, but once again,
some USB hubs might not charge
Mobius. Please check your hub specs.
To charge using USB, Mobius supports 1
Amp chargers and takes approximately
3 hours to fully charge when Mobius is
powered off. When plugging Mobius
into a wall-wart, make sure the red LED
is on to indicate that charging is in
effect. Some older wall-warts and USB
Hubs might not provide enough power
to charge Mobius. Instead, please use a
1 Amp charger. When Mobius’ battery
is low, Mobius will attempt to charge
using the USB cable simultaneously to
keep you in the action. If you have a
USB Hub or extender, Mobius will work
equally well with these, but once again,
some USB hubs might not charge
If needed, complete a wired connec
If needed, complete a wired connec
tion with your Analog AUX cable in the
tion with your Analog AUX cable in the
same way you connected via USB
same way you connected via USB
previously. The Analog input exists on
previously. The Analog input exists on
the bottom side of the left ear-cup.
the bottom side of the left ear-cup.
Make sure you don’t plug your cable
Make sure you don’t plug your cable
into the microphone input. You
into the microphone input. You
wouldn’t be the first one to make that
wouldn’t be the first one to make that
mistake. Mobius has a balanced ampli
mistake. Mobius has a balanced ampli
fier built-in, so you do not need any
fier built-in, so you do not need any
external amps to power this star of a
external amps to power this star of a
headphone. Additionally, some PC's
headphone. Additionally, some PC's
might have a separate connection
might have a separate connection
input for headphone and microphone.
input for headphone and microphone.
In this case, obtain a splitter for your
In this case, obtain a splitter for your
inventory to split the TRRS connection.
inventory to split the TRRS connection.
