Atlas Equipment OH-10X Manual de usuario

Read this entire manual before operation begins.

Record below the following information which is located on the serial number

data plate.

Serial No.

Model No.

Date of Installation

Contents

Speciﬁcations . . . . . . . . . . . . . 4

Installation Requirement . . . . . . . 6

Steps Of Installation . . . . . . . . . 8

Exploded View . . . . . . . . . . . . 23

Test Run . . . . . . . . . . . . . . . 27

Operation Instructions. . . . . . . . . 29

Maintenance Schedule. . . . . . . . . 30

Trouble Shooting . . . . . . . . . . . 31

Oh-10X Parts List . . . . . . . . . . . 32

Warranty . . . . . . . . . . . . . . . 39

Specifications 4

OH-10X

Speciﬁcations

OH-10X Clearﬂoor Direct-Drived Model Features (See Fig. 1)

• Direct-drive design minimizes the lift wear on parts and breakdown ratio.

• Dual hydraulic direct-drive cylinders are designed and made on ANSI

standards utilizing oil seal in cylinder.

• Self-lubricating UHMW Polyethylene sliders and bronze bushings.

• Single-point safety release, and dual safety lock design.

• Clear ﬂoor design, provide unobstructed ﬂoor space.

• Overhead safety shut-off device.

• Symmetric arm design.

• Stackable adapters 1.5”, 3”, 6” are standard equipment.

Fig. 1

Specifications 5

OH-10X

OH-10X Speciﬁcations

Model Style Lifting

Capacity Lifting

Time Lifting

Height Overall

Width

Between

Columns

Minimum

Pad

Height

Gross

Weight Motor

OH-10X Clear ﬂoor

Direct-drive 10,000lbs 60S 74 1/4”-84” 151 1/2” 144” 117 1/2” 4 1/4” 1,730lbs 3.0 HP

Arm Swing View

Fig. 2

Installation Requirement 6

OH-10X

Installation Requirement

Tools Required

Rotary Hammer Drill (Φ19) Carpenter’s Chalk

Hammer Screw Drivers

Level Bar Tape Measure (25ft)

Crescent Wrench (12”) Pliers

Ratchet Spanner With Socket (28#) Allen Head Wrench (3#, 6#)

Wrench set

(10#, 13#, 14#, 15#, 17#, 19#, 24#, 27#)

Vise Grips

Fig. 3

Installation Requirement 7

OH-10X

Speciﬁcations Of Concrete (See Fig. 4)

Speciﬁcations of concrete must be adhered to the speciﬁcation as

following. Failure to do so may result in lift and/or vehicle falling.

1. Concrete must have 4 inches minimum and must be totally cured before lift

installation.

2. Concrete must be in good condition and must have a test strength 3,000psi

minimum.

3. Floors must be level and no cracks.

Fig. 4

Power Supply

220 volt single phase 30 amp breaker with minimum of 10 gauge wire

Steps Of Installation 8

OH-10X

Steps Of Installation

A. Location of Installation

Double check the installation site (concrete, layout, space size etc.) for the lift

installation.

B. Use a carpenter’s chalk line to establish

installation layout of base plate (See Fig. 5).

Fig. 5

C. Check the parts before assembly

1. Packaged lift and hydraulic power unit (see Fig. 6)

Fig. 6

Chalk Line

Steps Of Installation 9

OH-10X

2. Move the lift aside with a fork lift or hoist, and open the outer packing

carefully. (See Fig. 7).

Fig. 7

3. Remove the parts from upper inside of the column and set the parts aside.

4. Loosen the bolts on the upper package stand and take off the upper column

with a forklift or hoist and remove the package stand.

5. Move the parts aside and check the shipment parts list. (See Fig. 8, 9).

Fig. 8 - Parts in the shipment parts list

Fig. 9 - Parts in the parts box (77)

Top Connecting

Assembly

Parts box

Aluminum name plate

Shipment

Parts list

Steps Of Installation 10

OH-10X

6. Check the parts of the parts bag according to parts bag list (See Fig. 10).

Fig. 10

D. Position power side column

Set the columns vertically on the installation site parallel of each other. Position

the power side column according to the actual installation site (See Fig. 11).

Note: Figure 11 appears to have the columns lying down. They are supposed to

be in the upright position.

Fig. 11

Oil hose

Power side column

Car in direction

Offside column

Otros manuales para OH-10X

Tabla de contenidos

Otros manuales de Sistema de elevación de Atlas Equipment

Atlas Equipment

Atlas Equipment Garage Pro 8000 EXT Manual de usuario

Atlas Equipment

Atlas Equipment 90HSC Manual de usuario

Atlas Equipment

Atlas Equipment PV-15PX Manual de usuario

Atlas Equipment

Atlas Equipment BP12000X Manual de usuario

Atlas Equipment

Atlas Equipment 18K Manual de usuario

Atlas Equipment

Atlas Equipment 409-HP Manual de usuario

Atlas Equipment

Atlas Equipment BP12000X Manual de usuario

Atlas Equipment

Atlas Equipment ATEXH-PV-12PX Manual de usuario

Atlas Equipment

Atlas Equipment BP8000 Manual de usuario

Atlas Equipment

Atlas Equipment 408-SL Super Deluxe Manual de usuario

Atlas Equipment

Atlas Equipment LR10 Manual de usuario

Atlas Equipment

Atlas Equipment OH-10X Manual de usuario

Atlas Equipment

Atlas Equipment Atlas BP9000X Manual de usuario

Atlas Equipment

Atlas Equipment 414A Manual de usuario

Atlas Equipment

Atlas Equipment BP12000X Instrucciones de instalación

Atlas Equipment

Atlas Equipment Atlas PV-10PX Manual de usuario

Manuales populares de Sistema de elevación de otras marcas

morse

morse 82H-124 Manual de usuario

Braun

Braun NL955 Series Manual de usuario

haacon

haacon 1889.10 Manual de usuario

Protekt

Protekt AT 252 Manual de usuario

R. Beck Maschinenbau

R. Beck Maschinenbau HS 600 Manual de usuario

Nova Technology International, LLC

Nova Technology International, LLC NAS Series Manual de usuario

Genie

Genie Z-60/34 Manual de usuario

Screen Technics

Screen Technics INTERFIT Vertical Up Lift Manual de usuario

Mortuary Lift

Mortuary Lift ULTIMATE 1000 Manual de usuario

Custom Equipment

Custom Equipment Hy-Brid 3 Series Manual de programación

Custom Equipment

Custom Equipment Hy-Brid Lifts 2 Series Manual de programación

Hy-Brid Lifts

Hy-Brid Lifts HB-P3.6 Manual de programación

BERG

BERG BeNomic EasyLeaf Manual de usuario

Powermate

Powermate LiftGate LG-3 Manual de usuario

Snorkel

Snorkel TM12 Series Manual de usuario

Terberg

Terberg OMNIDEKA Manual de usuario

Harmar Mobility

Harmar Mobility AL625 Instrucciones de funcionamiento

Rotary

Rotary SPO16 Manual de usuario