14) UNPLUG TOOLS - When not in use, disconnect the tools from power supply (wall outlet) before servicing and when changing accessories
such as blades, bits and cutters.
15) REMOVE ADJUSTING KEYS AND WRENCHES - Form the habit of ensuring that keys and adjusting wrenches are removed from the tool
before turning it on.
16) AVOID UNINTENTIONAL STARTING - Do not carry the plug-in tools with a finger on the switch. Ensure switch is off when plugging the tool in.
17) USE OUTDOOR EXTENSION CORDS - When tools are used outdoors, use only extension cords intended for outdoor use.
18) STAY ALERT - Watch what you are doing. Use common sense. Do not operate the tool when you are tired or while under the influence of
alcohol or medications.
19) CHECK FOR DAMAGED PARTS - Before each use, the tool should be checked for damaged parts. Any damage should be carefully
checked to determine whether or not it will operate properly and perform its intended function. Check for alignment of moving parts, mounting
and any other condition which may affect its operation. Any part that is damaged should be properly repaired or replaced by an qualified
service person unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorized service facility. Do not
use the tool if the switch does not turn it on or off.
20) ACCESSORIES AND ATTACHMENTS - The use of any accessory or attachment, other than those recommended in this instruction manual,
may present a risk of property damage, personal injury or even death.
21) HAVE YOUR TOOL REPAIRED BY A QUALIFIED SERVICE PERSON - This electric tool is in accordance with the relevant safety
requirements. Repairs should only be carried out by qualified persons using original spare parts; otherwise it may present a risk of property
damage, personal injury or even death.
ADDITIONAL SAFETY GUIDELINES
•When the machine is in operation, keep hands away from the cutting area.
•The blade will not stop immediately when the machine is turned off. Exercise caution.
•Do not place the tool down after use until the saw blade has come to complete stop.
•Always use the correct blade recommended to cut material.
•Keep the power cord well away from the cutting area during use.Always position the cord so that it will not be caught in the workpiece when the
saw is in use.
•Do not operate the saw with guide shoe removed.
•Do not attempt to plunge cut metal.
•Some wood contains preservatives which can be toxic. Take extra care to prevent inhalation and skin contact when working with these materials.
Request, and follow, any safety information available from your material supplier.
•When cutting angle iron, H-beams, I-beams, channels, etc, start the cut on the surface where the greatest number of teeth will contact the work. To
make a pocket cut, drill a starting hole first.
•Always wear earmuffs, safety glasses and face mask while in operation.
•Before connecting the tool to the power supply follow the safety instructions to install the blades. Do not overtighten blade holder set screw, or
cracks may occur.
