AT&T 100 Manual de usuario

USER’S MANUAL

Part 2

AT&T and the globe symbol are registered trademarks of AT&T Corp.

licensed to Advanced American Telephones.

Printed in China. 850003047 Issue 1AT&T 5/00

Traditional

Telephone 100

Wall and Table

Please also read Part 1 —

Important Product Information.

PARTS CHECKLIST

Remember to save your sales receipt in case you ever need

warranty service, and make sure this telephone package

includes the items shown below:

TELEPHONE BASE

Table Model

TELEPHONE BASE

Wall Model

Coiled

handset cord Telephone line cord

TELEPHONE HANDSET

Receiver

volume

switch

Ringer

volume

switch

Dial Mode

This telephone has a selectable push-button dial and will

work with either tone or rotary telephone service.

1. Set Dial Mode switch

This product comes set in

the tone (TT) mode. Make

sure you choose the

correct dialing method

(TT/DP); touch tone dialing

will not work if you have

dial pulse service.

2. Connect line cord to

telephone and wall jack

Plug one end of the line

cord into the jack on the

telephone and the other end

of the line cord into a

modular wall jack. Make

sure it snaps firmly into

place.

3. Connect handset to

telephone base

Plug one end of the coiled

handset cord into the jack

at the side of the telephone

base and plug the other end

into the handset. Then

hang up.

4. Check for dial tone

Lift the handset and listen

for a dial tone. If you can't

hear a dial tone, refer to

“In Case of Difficulty” and

try to correct the problem.

TO DISCONNECT the line

and handset cords, squeeze the

clip on the modular plug and

pull it out of the jack.

TABLE/DESK INSTALLATION

Dial Mode Switch

1. Set Dial Mode switch

This product comes set in

the tone (TT) mode. Make

sure you choose the

correct dialing method

(TT/DP); touch tone dialing

will not work if you have

dial pulse service.

2. Connect the line cord

and install telephone on

wall jack

Plug the three-inch line cord

into the back of the telephone

and into a modular wall jack.

Then align the mounting

slots on the back of the

telephone with the studs

on the wall jack. Push the

telephone firmly against the

wall jack, and pull down

until it is held securely by

the mounting studs.

3. Connect handset to

telephone base

Plug one end of the coiled

handset cord into the

handset. Plug the other end

into the jack at the base of

the phone. Then hang up.

4. Check for dial tone

Lift the handset and listen

for a dial tone. If you can't

hear a dial tone, refer to

“In Case of Difficulty” and

try to correct the problem.

TO DISCONNECT the line

and handset cords, squeeze the

clip on the modular plug and

pull it out of the jack.

WALL INSTALLATION

Dial Mode Switch

OPERATION

Receiver Volume Control

The Receiver Volume Control can be adjusted for a comfortable

listening level. The switch has variable volume positions.

Redial

The telephone always stores in memory the last phone number

dialed. To dial the same number again, lift the handset and

press .

Erasing Redial

For privacy, you can erase the redial memory. Lift the handset,

then press any digit (1-9).

Mute

Hold down to turn off the handset microphone. You can

then talk privately to someone else in the room without the

person on the phone hearing you. You will still be able to hear

the other person, but anything you say will not be heard. When

you release the button, your caller will again be able to hear

your voice.

Ringer Volume Control

The RINGER switch allows you to turn the telephone ringer OFF,

or set it to ring at LO or HI volume. You can dial or answer calls

normally when the ringer is off. Other telephones in your home

will still ring; they are not affected by the switch.

Temporary Tone Dialing

Temporary tone dialing is used only when you have rotary

service. This is useful if you need to send tone signals for

access for telephone banking or long-distance services.

To change from pulse (rotary) to tone dialing during a call:

1. With the Dial Mode switch set to

DP (dial pulse), dial a telephone

number.

2. Press ; all buttons pressed

after this will send tone signals.

3. After you hang up, the phone auto-

matically returns to rotary service.

TONE

MUTE

REDIAL

If you have difficulty operating this phone, try the

suggestions below.

No Dial Tone

☞Make sure all plugs are connected properly. Inspect the

line cord connections at the modular jack and at the

telephone. Also inspect the coiled handset cord

connections at both ends.

☞Unplug the telephone and connect it to another modular

jack. If it still does not work, try another telephone; if

neither telephone works, the problem is not in this

telephone. The trouble may be caused by local

telephone company lines, central office equipment, or

the wiring in your home.

Calls Cannot Be Dialed, Or Are Dialed Slowly

This product comes set in the tone (TT) mode. Make sure

you choose the correct dialing method (TT/DP); touch tone

dialing will not work if you have dial pulse service.

Telephone Does Not Ring

☞Make sure the RINGER Volume switch is not set to OFF.

☞If there are several other phones on the same line, try

disconnecting some of the other telephones. Having too

many telephones can also create problems such as low

ringer volume or impaired quality during calls.

Manuales populares de Teléfono de otras marcas

GE 2-9480 Manual de usuario

Geemarc

Geemarc PHOTOPHONE 155 Manual de usuario

D-Link

D-Link DWR-720/PW Manual de usuario

Interquartz

Interquartz Gemini IQ333 Manual de usuario

SSS Siedle

SSS Siedle HT 840-0 Manual de usuario

Motorola

Motorola TITANIUM Manual de usuario

Panasonic

Panasonic ICX Manual de usuario

LG H870DS Manual de usuario

Samsung

Samsung GT-I9500 Manual de usuario

Selta

Selta zenyth 600 Manual de usuario

Doro

Doro AFTI 20 Manual de usuario

UNIQCELL

UNIQCELL A1 Manual de usuario

Panasonic

Panasonic KX Series Manual de usuario

Jabra

Jabra SP5050 - Bluetooth hands-free Speakerphone Manual de usuario

BT Decor 425 Manual de usuario

NEC

NEC SV8500 Manual de usuario

Teledex

Teledex PEARL Manual de usuario

Ericsson

Ericsson Dialog 3213 Manual de usuario