Asus Blitz Formula Manual de usuario
Installing Fusion Block System accessory 1
Installing Fusion Block System accessory
Install your watercooling system to the motherboard using the bundled accessories
to obtain the best thermal solution.
Package contents
12
For watercooling system with 3/8” ID tubes
1. Firmlypressatubeclipandtthetubeintotheclip.
2. Press the clip and connect the tube to the waterblock. When done, release
the clip to tighten the two together.
3. Repeat Step 1 and 2 for another tube. Make sure that both tubes are well
connectedtopreventleak,andthenllthecoolantintothereservoir.
3/8” ID tubes x 2 1/2”to3/8”IDttingsx2 10mmto3/8”IDttingsx2
1/2” ID tube clips x 2tube clips x 2 3/8” ID tube clips x 6
2 Installing Fusion Block System accessory
56
5. Press the clip and connect the assembled tube to the waterblock. When
done, release the clip to tighten the two together.
6. Repeat Step 1 to 5 for another tube. Make sure that both tubes are well
connectedtopreventleak,andthenllthecoolantintothereservoir.The
picture shows a watercooling system installed to the motherboard.
3
2
14
For watercooling system with 1/2” or 10mm ID tubes
1. Insertatting(1/2”to3/8”IDor10mmto3/8”ID)intothetube.
Your watercooling system may come with tube clips. Use the clips to fasten the
ttingsandthetubestogether.
2. Connectasupplied3/8”IDtubetothetting.
3. Firmly press a tube clip and hitch it to the bottom end of the 3/8” ID tube.
4. Press another clip and hitch it to the top end of the 3/8” ID tube.
Otros manuales para Blitz Formula
1
Tabla de contenidos
Otros manuales de Accesorios de Asus
Asus
Asus Pen 2.0 Manual de usuario
Asus
Asus ABTU016 Manual de usuario
Asus
Asus Xtion Manual de usuario
Asus
Asus Active Stylus SA200H Manual de usuario
Asus
Asus ZenPower PD 10000 Manual de usuario
Asus
Asus ESC4000 G2 GPU Manual de usuario
Asus
Asus ROG RYUO III ARGB Series Manual de usuario
Asus
Asus MS101 Manual de usuario
Asus
Asus Xtion 2 Manual de usuario
Asus
Asus ABTU001 Manual de usuario
