Ask Proxima Impact WSX Manual de usuario
USER
GUIDE
IMPACT WSX
801.130B
USG/WSX/AE-B
02.08.95
Not the actual front page
USER
GUIDE
IMPACT WSX
USER GUIDE LCD PANEL
2
USER GUIDE LCD PANEL
3
TABLE OF CONTENTS
INTRODUCTION .....................................................................................5
MAIN FEATURES....................................................................................5
SUPPLIED MATERIAL.............................................................................6
OPTIONAL MATERIAL............................................................................6
SETTING UP THE LCD PANEL ...............................................................7
COMPUTER...............................................................................8
MOUSE......................................................................................9
USING THE LCD PANEL....................................................................... 10
REMOTE CONTROL................................................................ 10
FRONT PANEL ........................................................................ 12
CONNECTORS........................................................................ 12
FEATURES............................................................................................ 13
PRACTICAL HINTS AND TIPS............................................................... 16
MAINTENANCE..................................................................................... 18
SERVICE............................................................................................... 18
TECHNICAL DATA ................................................................................ 18
CONNECTORS ..................................................................................... 23
FCC STATEMENT................................................................................. 24
ENVIRONMENTAL STATEMENT........................................................... 25
SERVICE INFORMATION...................................................................... 26
CONNECTION LAYOUT........................................................................ 27
(Foldout Page)
USER GUIDE LCD PANEL
4
This publication is printed on recycled paper.
The information contained in this user guide is preliminary, and the products described
herein are subject to change without prior notice.
The symbols and are used in this publication to indicate
Warning and Note respectively.
USER GUIDE LCD PANEL
5
1INTRODUCTION
The LCD panel is a state of the art projection device that can be connected
to most computers.
The ability to display a multitude of colors simultaneously, makes it the
ideal choice for presenting computer generated text and graphics.
Applications include presentations, software training, educational use,
advertising, information boards and other situations where a small or large
audience shares information.
2MAIN FEATURES
-16.7 million colors
-640x480 to 1280x1024 image resolution
-BatMouse™, infrared remote mouse
-User settings memorized
-Individual settings for all modes
- Housing footprint fits OHP glass exactly
-Low weight
-Intelligent Safecool system
-False light blocking
-4 meter cable
-Scale/pan option
USER GUIDE LCD PANEL
6
3SUPPLIED MATERIAL
A complete set includes the following components :
1. LCD Panel 6. Power Cord
2. VGA-Cable 7. BatMouse Remote Control
3. Mouse Cable 8. Batteries
4. Mouse Adapter PC 9. Attachè Case
5. Power -5, 12, 5 V 10. User Guide
4OPTIONAL MATERIAL
Optional cables and adapters are available for special computer sources.
USER GUIDE LCD PANEL
7
5SETTING UP THE LCD PANEL
Switch off all equipment before connecting the components. Be aware of
static electricity that may build up, especially in the dry season and when
operating on synthetic carpets. Discharge any static electricity by touching
a metallic surface before you start.
Place the LCD panel on top of a transmissive overhead projector (OHP).
Select a high intensity type projector, for instance 400W halogen or metal-
halide. Best results are obtained in a dimmed room with no direct sunlight.
The following are guidelines for first time set-up:
Connect the cables and power supply as described in the rear foldout page
(see Connection Layout).
Attach power to the LCD panel, then turn the overhead projector and
computer on.
Do not switch on the OHP unless the LCD panel is powered, as
this may cause permanent damage.
If you are going to use a mouse, make sure to power the LCD panel first.
For more information on set-up see the following sections on
Computer/Mouse.
USER GUIDE LCD PANEL
8
5.1 COMPUTER
Connect the LCD panel, computer, monitor and power supply as shown in
the rear foldout.
Connect cable (1) between the LCD panel and the computer.
If you have a workstation, insert applicable adapter (4) as described in the
table below.
Connect the power supply to the LCD panel (3).
APPLICABLE ADAPTERS :
COMPUTER ADAPTER
VGA None *)
MACII and newer MAC (option)
SUN 13W3 (option)
HP None or BNC (option)
IBM RS6000 BNC (option)
Silicon Graphics 13W3 (option)
DEC BNC (option)
*) The cable is connected directly without a special adapter.
TO SET UP FROM THE BATMOUSE REMOTE CONTROL :
Use a chequered background when setting up in direct (1:1) mode to
ensure correct frequency setting.
STEP OPERATION
1Press RESET for default settings
2Adjust FREQUENCY if chequered image is not regular
3Adjust TUNE for a stable image
4Press POSITION, then use cursor keys to position the image
5Adjust CONTRAST and BRIGHTNESS as desired
USER GUIDE LCD PANEL
9
5.2 MOUSE
Connect the mouse to the LCD panel using the appropriate adapter (6) as
described in the table below. Then connect the adapter (6) to the mouse
cable at the computer end. Finally, connect the mouse cable to the LCD
panel (2).
For the computer to recognise the mouse, connect the mouse before
power is applied.
A Y-split is provided with the PC and MAC adapters that enables parallel
use of the local computer mouse and the remote mouse. The local and
remote mice should however not be operated simultaneously, as this may
lead to unpredictable positioning of the mouse pointer.
If you have a Macintosh, make sure to connect your Mac mouse adapter
via the keyboard.
The PS/2 adapter does not have a Y-split.
To use the mouse function with workstations requires workstation
compatibility with one of the mice defined below.
APPLICABLE ADAPTERS :
MOUSE ADAPTER
Microsoft 2 key compatible (9 pin serial port) PC
PS/2 compatible mouse PS/2 (option)
Macintosh ADB-bus mouse MAC (option)
USING THE BATMOUSE :
STEP OPERATION
1Control mouse pointer directly with the cursor keys
2Press LEFT to activate (emulates the left mouse key)
3Press DRAG to tag an object, move it using the cursor keys,
then press DRAG again (or wait 5 seconds) to release the
object.
4Press RIGHT if your application requires emulation of the
right mouse key.
The centre key of three-key mice is not emulated.
If double-click does not work properly, try to adjust the double-click rate
within the computer application in use.
Tabla de contenidos
Otros manuales de Proyector de Ask Proxima
Ask Proxima
Ask Proxima E1655-A Manual de usuario
Ask Proxima
Ask Proxima M9 Manual de usuario
Ask Proxima
Ask Proxima Impact 21 Manual de instrucciones
Ask Proxima
Ask Proxima C3000 Series Manual de usuario
Ask Proxima
Ask Proxima C310 Manual de usuario
Ask Proxima
Ask Proxima C250 Manual de usuario
Ask Proxima
Ask Proxima M1 Manual de usuario
Ask Proxima
Ask Proxima Impact 21 Manual de usuario
Ask Proxima
Ask Proxima C310 Manual de usuario
Ask Proxima
Ask Proxima C420 C420 C420 Manual de usuario
Ask Proxima
Ask Proxima C5 Compact Manual de instrucciones
Ask Proxima
Ask Proxima A1100 Manual de usuario
Ask Proxima
Ask Proxima DP6860 Manual de usuario
Ask Proxima
Ask Proxima A6 Compact Manual de usuario
Ask Proxima
Ask Proxima C250 Manual de usuario
Ask Proxima
Ask Proxima A3100 - Manual de usuario
Ask Proxima
Ask Proxima M2+ Manual de usuario
Ask Proxima
Ask Proxima DP6100 Manual de instrucciones
Ask Proxima
Ask Proxima M8 Manual de usuario
Ask Proxima
Ask Proxima Ultralight S520 Manual de instrucciones
