SS91A-M GSM Door Phone 8 Revision 2.20, April 2011
User: (Manager Mode)
There are 3 different modes under manager mode.
Enter Listener Monitoring Mode
1. Call the telephone number to which the door phone is connected.
2. This device will then verify your phone number with your predefined numbers.
3. You will hear a “Do” tone to enter listener monitoring mode by pressing [12# ]where 12 is the
password.
4. You are now in the” listener monitoring mode”.
5. Under this mode speaker is OFF.( 35#:speaker ON)
6. You can still control the relay output when you are under listener monitoring mode.
EnterAccess Control Mode
1. Call the telephone number to which the door phone is connected.
2. This device will then verify your phone number with your predefined numbers.
3. You will hear a “Do” tone to enter access control mode by pressing [*33*5678#] where 5678
is the password.
4. Your door will be opened after enter the correct password
Enter Programming Mode (programming by dial in)
1. Call the mobile number (SIM card ) to which the door phone is fitted with.
2. This device will then verify your phone number with your predefined numbers.
3. You will hear a “Do” tone when the Door Phone answers the call. To enter into programming mode
by pressing * 12 * 1234#where 1234 is the password.
4. You are now in the “programming mode”
Note: At the end of each command there can be one of the two indications:
successful: a long “Do” tone, failed program instruction: three short “Do” tone.
5. To make changes on settings please refer to the function code table below.
6. To end programming just hang up.
Note:
To be successful in programming, originate a call from a land line and enter the digits slowly.
Programming can be carried out either by text message or by dialing into the intercom.
If the number is programmed to open the door but you still would like to use the same number to
dial in for programming but not for door open, then you can disable Caller ID display on the
