ENGLISH
• The device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless
they are under the control or instructed about the use of the device by the person responsible for their safety.
• Use the appliance away from children. Children should be supervised to prevent play with the appliance.
• Do not leave the appliance switched on unattended.
• Do not use the appliance if the cord or plug is damaged, or if the appliance is damaged or defective. Take it to a service center. The appliance must be repaired only
by an authorized service center. Do not repair the appliance yourself.
• The device is not designed to be operated by an external timer or a separate remote control system.
• If the power cord is damaged, replace it with a special cord obtained from the manufacturer or service department.
• To prevent electric shock, do not immerse the appliance in water or other liquids. If it does get into the water, never touch the unit, and immediately unplug it from
the mains. • Do not let the cord hang over the edge of the table or over hot surfaces. • Unplug the appliance if it is not in use, or before cleaning.
• Do not use the appliance for purposes other than those specified in the instruction manual. Do not use outdoors.
• Be extremely careful when children are near the appliance. • The lid, bowl and the body of the device become hot during operation. Do not touch hot surfaces with
bare hands. Use special potholders. • Do not use accessories that are not included in the set.
• During the operation of the multicooker, steam is released through the steam valve, be careful not to lean close to the device. • Do not cover the device with a kitchen
towel, do not place foreign objects on the appliance cover. The steam valve of the device will be blocked, which will lead to damage to the device.
• Do not use the device near curtains, shelves and other items that could be damaged by steam.
• Be careful - when opening the lid and removing the bowl after the operation of the device hot steam may be released.
• Cook meals only in a removable bowl of the multicooker! • Do not lay food directly on the bottom of the appliance.
• Take out the removable bowl, put all the necessary ingredients, then place the bowl in the mulcooker.
• Close the lid of the appliance before use. If the lid is not closed tightly, this will affect the taste and quality of the cooked food. Do not heat or use a removable
bowl to cook meals outside the multicooker. This can damage the special coating of the bowl.
• Before use, make sure that there are no foreign objects between the heating surface of the device and the removable bowl.
• Keep clean the heating surface and the removable bowl. Any contamination can damage the appliance. Important! The body of the device, the removable bowl
and the heating surface must always remain dry and clean! • Do not replace the bowl with another container.
• Do not use metal objects that could scratch the bowl. The coating applied to the surface of the bowl can be gradually erased, so it is necessary to use it carefully.
• When placing the bowl in the multicooker, make sure it is dry and clean.
• Do not start cooking until you are sure that the removable bowl of the multicooker is correctly put into the appliance.
• The level of water and ingredients in a removable bowl should not exceed the maximum permissible level of the scale located on the inside of it. Do not use
hot water for cooking in a mulcooker.
• Do not pour water into the multicooker itself! This may result in damage to the device or electric shock.
• Close the lid tightly before cooking. If the lid is not closed tight enough, leakage will break, which can affect the taste and quality of the prepared dish.
• When spreading the ingredients, pouring water into the removable bowl of the multicooker, make sure that the bottom and outside walls of the bowl remain dry and
clean. • To avoid damage to the lid when using the device with a removable bowl, use the supplied accessories, or plastic / wooden kitchen appliances.
• Do not pour vinegar into the bowl. This can damage the special coating. • During work, do not leave spoons inside the removable bowl.
• After a while the bowl of the appliance can change color - this is normal because the surface of the bowl is in contact with water and detergents.
• Use and store the appliance out of the reach of children.
• Unplug the unit after use and before cleaning. Before moving, carrying out cleaning or other maintenance operations, allow the unit to cool.
• If you do not use the appliance, turn it off. While turning off the device, do not pull on the power cord, gently pull the plug from the outlet.
• After the cooking is finished, allow the multicooker to cool for 15 minutes before switching it on again.
• Do not insert metal or other objects into the steam valve or any other parts of the product. Protect the face and hands from the vapor exiting the valve.
• Attention! The appliance heats up during operation! In case of necessity of contact with the multivark during its operation, use kitchen gloves or potholders. Do not
operate the device with wet hands. • This appliance is intended for household use only. • Keep these instructions.
• When using an extension cord, make sure that the maximum permissible cable power corresponds to the power of the device.
Attention! Never remove products from the multicooker with sharp objects that could damage the coating.
ATTENTION! During the first switch-on, the multicooker can produce an unpleasant smell of burning. This is normal and is due to burnout of the factory oil!
The manufacturer reserves the right, without additional notice, to make minor changes to the design of the product that do not radically affect its safety,
performance and functionality.
Before cooking. After placing the inner bowl in the multicooker, turn it until it is in full contact with the heating element. Before selecting a cooking program, please check
that the inner food bowl is correctly positioned. If the inner bowl is not placed correctly, it is forbidden to start cooking in order to avoid unpleasant accidents. Close the top
cover of the appliance tightly to avoid poor cooking and heat leakage due to poor sealing. To determine the quantity of rice or any other cereal, use the measuring cup that
comes with the multicooker. Do not use the removable multicooker bowl for rinsing ingredients / kneading dough. Do not cut the dish inside the bowl.
Beginning of work. Connect the power cord to your appliance and plug into a power outlet. The displays on the control panel will show “----”.
Selection of cooking modes. Press button to select the desired program. Then press the "START" button.
Delayed start function allows you to set the time interval after which the selected cooking program will start. You can postpone the start of the program in the range from
30 minutes to 24 hours with a setting of 5 minutes.
Note: Delayed start function is not available in the modes "Fry", "Toast", "Omelette", "Yoghurt", "Сottage cheese", "Fondue".
Choose and set the desired cooking mode.
• Press the Delayed start button, a beep will sound and the display will show the value "0000".
• Use the buttons to set the hours and minutes of the delay.
• Press the button "Start", confirming the selected parameters, the program will start. The display (1) will show the countdown to start and the indicator of the selected
cooking program will flash. If the Delayed start function is available for the selected program, its indicator will be on all the time.
Cooking time correction. You can independently adjust the cooking time set by default in the programs you have chosen. This function is available for all the cooking
programms.
To change the cooking time:
• After you have chosen the programm, the display 1 shows the cooking time.
• Press the button , the indication on the display will blink, use the buttons and set the time you need. Press the button “Start” to confirm the setting. To cancel
the setting, press the button “Cancel”.
Cooking temperature correction. You can independently adjust the cooking temperature in the programs "TOAST", "FRY" and "MULTICOOK", while the readiness of the
product directly depends on the correct choice of temperature and cooking time.
To change the cooking temperature:
• After selecting a cooking program, the display (2) shows the default temperature.
• Press the button , the indication on the display (2) starts flashing. Use the buttons to change the cooking temperature according to the recipe. Press the
button “Start” to confirm the selected parameters - the cooking program will start. In automatic heating mode with a temperature of 60 ° C. The display (1) will start
counting down the time, and on the display (2) - "060". The range and step of setting the temperature depends on the selected program.
"Keep warm" function. After the cooking is ended, the multicooker will emit a sound signal and switch to automatic heating mode with a temperature of 60°C. The display
(1) will start counting down the time, and on the display (2) - "060".
To disable automatic keeping warm, press the "Cancel" button. Automatic heating turns on after the end of all programs, except for "PASTA", "STEAM", "BAKE", "YOGHURT",
"COTTAGE CHEESE", "FONDU".
Note: in programs with the “Keep warm” function, when a program is selected, the indicator light comes on and remains on for the duration of the program. "Keep warm"
function can be deactivated in advance by pressing the “Start” button during cooking. The function indicator light will go out.
Attention! The multicooker can keep the food warmed up for up to 12 hours, but it is not recommended to leave the dish heated for more than two to three hours, as this
can lead to a change in its taste.
Program "MULTICOOK". This program helps to adapt any recipes for a multicooker. The program allows you to change the cooking time and temperature to use any
OPERATION
