Aqualisa Visage Manual de usuario
Visage
Digital
Remote control
Installation guide
TM
Visage Digital remote control installation instructions Page 1
Visage Digital remote control
VSD.B3.DS.14
Visage Digital remote control installation instructions Page 2
Visage Digital remote control
Visage Digital remote control installation instructions Page 3
Literature not shown
Com onents
Visage Digital remote control installation instructions Page 4
Important information
The Visage Digital remote control is a remote button which provides a secondary method of ‘Start/stop’ for Visage
Digital shower systems. When used with the Visage Digital diverter system, the remote can operate each outlet by
pushing and holding the ‘Start/stop’ button for a few seconds as required. The remote control may be sited inside
the showering area, as long as it is not subjected to continuous spray, or it can be sited outside the showering area –
up to 10 metres from the Digital processor.
The Visage Digital remote control is not suitable for use with any other Aqualisa Digital product range.
THIS PRODUCT UST BE INSTALLED BY A CO PETENT PERSON IN ACCORDANCE WITH ALL RELEVANT CURRENT
WATER AND ELECTRICAL SUPPLY REGULATIONS.
ALL SHOWERS REQUIRING AN ELECTRICAL CONNECTION UST BE INSTALLED BY A QUALIFIED PERSON
FOLLOWING THE LATEST REVISION OF BS7671 (WIRING REGULATIONS) AND CERTIFIED TO CURRENT BUILDING
REGULATIONS.
This product is suitable for domestic use only.
This product is supplied complete with a 2 year guarantee.
Visage Digital remote control installation instructions Page 5
Installation instructions
Visage Digital remote control
In addition to the guide below it is essential that the written
instructions below are read and understood and that you have all
the necessary components (shown overleaf) before commencing
installation. Failure to install the product in accordance with these
instructions may adversely affect the warranty terms and
conditions. Do not undertake any part of this installation unless you
are competent to do so. Prior to starting, ensure that you are
familiar with the necessary plumbing regulations required to install
the product correctly and safely.
THE DIGITAL PROCESSOR UST BE ISOLATED FRO THE AINS
POWER SUPPLY PRIOR TO INSTALLING THE VISAGE DIGITAL
RE OTE CONTROL.
!
Single outlet
IF FITTING THIS PRODUCT WITH A VISAGE DIGITAL SINGLE
OUTLET SHOWER SYSTE , PLEASE FOLLOW THE FITTING
INSTRUCTIONS BELOW.
!
Visage Digital remote control installation instructions Page 6
Using the back plate as a
template, mark the position of
the fixing screws and a Ø16mm
hole for the data cable entry
point. The cable entry point
should be made in the top right
hand corner of the back plate re-
cess, to ensure the two holes are
kept separate.
1
Prepare suitable wall fixings to accommodate no. 8 non-rusting
countersunk head screws of a suitable length (not included).
2
Wiring diagram
10m Data
Cable
10m Data
Cable
Visage Digital remote control installation instructions Page 7
Prepare a suitable route and install
the 10m low voltage data cable
leaving a working end of at least
70mm including the connector plug.
The end of the data cable closest to
the processor should terminate at
a maximum of 500mm from the
processor to allow for connection to the data cable connection
block.
3
DATA CABLES UST BE PROTECTED BY SUITABLE SHEATHING OR
CONDUIT IN THE EVENT OF SERVICING AND AINTENANCE.
!
Pull the data cable through
before securing the back plate
to the wall using suitable no. 8
non-rusting countersunk screws.
4
Visage Digital remote control installation instructions Page 8
Push the data cable plug into the
back of the button fully home to
ensure a water tight seal making
sure the seal is no longer visible.
5
Locate the slot at the bottom of
the button assembly, onto the
locating peg at the bottom of the
back plate assembly, and offer
the button into position.
6
Visage Digital remote control installation instructions Page 9
Secure the button to the back plate
by carefully but firmly pushing the
button assembly onto the locking
clip at the top of the back plate.
7
Apply a thin bead of mastic to
the groove at the rear of the wall
plate.
8
To release the button, insert a small
flat bladed screw driver into the
small slot at the top of the button
assembly, to release the locking
clip, taking care to avoid damaging
the plated surface. Carefully lift the
button out and up off of the back
plate bottom locating peg.
!
Place the wall plate into position
and push flush to the finished wall
surface, taking care to avoid any
transfer of mastic from the wall
plate onto the button assembly.
9
BEFORE ANY ELECTRICAL ADJUST ENT IS ATTE PTED, THE
ELECTRICITY SUPPLY UST BE TURNED OFF AT THE AINS
SWITCH.
ELECTRICAL INSTALLATION AY ONLY BE CARRIED OUT BY
A QUALIFIED PERSON.
!
Visage Digital remote control installation instructions Page 10
The Digital processor features a
secondary data cable socket next
to the main data cable connection
for use with the Digital remote
control secondary ‘Start/stop’
button. Carefully snap and remove
the entry pillar and connect the cable
to the socket as shown.
10
Prior to commissioning the Visage Digital remote control following
the procedure overleaf, please refer to the installation instructions
provided with the main Visage Digital product to complete the
installation of the Digital processor.
11
If using a Digital Divert system, the cable plugs into the diverter
using the splitter box provided.
If using with a Divert product, refer to the Digital Divert
instructions opposite.
!
IF FITTING THIS PRODUCT WITH A VISAGE DIGITAL DIVERT
SHOWER SYSTE , PLEASE FOLLOW THE FITTING INSTRUCTIONS
BELOW.
!
Dual outlet
Otros manuales para Visage
4
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Mando a distancia de Aqualisa
Aqualisa
Aqualisa ilux Manual de usuario
Aqualisa
Aqualisa QUARTZ DIGITAL SERIES Manual de usuario
Aqualisa
Aqualisa Optic Q WR.BL.CP.20 Guía
Aqualisa
Aqualisa iSys ISD.B3.DS.14 Manual de usuario
Aqualisa
Aqualisa Quartz QZ.B3.WR.05 Manual de usuario
Aqualisa
Aqualisa Quartz Digital QZD.B3.DS.14 Manual de usuario
Aqualisa
Aqualisa AQLS Manual de usuario
