Aqara WL-S02D Manual de usuario
누수�감지�센서 T1 사용자�매뉴얼
水漏れセンサー T1 取扱説明書
Instrukcja obsługi Czujniki zalania T1
Water Leak Sensor T1 User Manual
Capteur de fuite d’eau T1Manuel d’utilisation
Sensore di perdite d'acqua T1Manuale di Istruzioni
Bedienungsanleitung fürWassersensor T1
Manual de instrucciones paraSensor de inundación T1
Датчик протечки T1 Руководство по эксплуатации
·01
·10
·18
·25
·32
·38
·44
·48
·52
·57
水浸感測器 T1使用說明書
Aqara Water Leak Sensor T1 is a device that may detect water
leakage and soaking based on the Zigbee 3.0wireless
communication protocol. It may detect two states, namely
from waterless to water, from water to water-break. When
leakage or soaking occurs, it may timely push the alarm
information through the app, and control other smart
hardware products through the linkage of the hub device.
*An Aqara hub is required. Some functions require specific models of the
Aqara hub. Please visitwww.aqara.com/supportfor more details.
01
Long Press of 5s: Reset/Connect to Network
Single Press: Effective Range Test
Product Introduction
Indicator Light
Reset Button
Inductive Probe
* If the connection fails, please move the accessory closer to the Hub and
try again
Before activating the accessory, please make sure you have
the Aqara Home downloaded and Aqara hub installed.
Please open the app,"tap Home"and then tap"+"in the top
right corner to enter"Add Device (Accessory)"page.
Select"Water Leak Sensor T1", and add it according to
instructions.
For details, please see www.aqara.com/support or scan the
QR code below to get the detailed electronic manual.
1.
2.
3.
Device Binding & Initialization
Product Specifications
Water Leak Sensor T1
Model:WL-S02D Battery:CR2032
02
Manufacturer:LumiUnited Technology Co., Ltd.
Address:Room 801-804, Building 1, Chongwen Park, Nanshan
iPark, No. 3370, Liuxian Avenue, Fuguang Community, Taoyuan
Residential District, Nanshan District, Shenzhen, China
Online Customer Service:www.aqara.com/support
Email:[email protected]om
This product is NOT a toy. Please keep children away from
this product.
This product is designed for indoor use only. Do NOT use
outdoors.
Do NOT place this product near a heat source. Do NOT place
it in an enclosure unless there is normal ventilation.
1.
2.
3.
Warnings
03
Wireless Protocols:Zigbee 3.0
Dimensions:⌀50×50×15mm (1.97×1.97×0.59in.)
Zigbee Operation Frequency: 2405-2480MHz
Zigbee Maximum Output Power ≤ 13 dBm
Operating Temperature:-10°C ~55°C (14°F ~131°F)
Operating Humidity: 0 ~100% RH, no condensation
What is in the Box:Water Leak Sensor T1× 1, User Manual × 1
4.
5.
Risk of explosion if the battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Do not ingest battery, Chemical Burn Hazard.
This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe
internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop
using the product and keep it away from children.
If you think batteries might have been swallowed or placed
1.
2.
3.
4.
5.
6.
Caution
04
Do NOT attempt to repair this product by yourself. All
repairs should be performed by an authorized professional.
This product is only suitable for improving the
entertainment, convenience of your home life and
reminding you about the device status. It should NOT be
used as security equipment for home, building, warehouse
or any other places. If a user violates the product use
instructions, the manufacturer will NOT be liable for any
risks and property losses.
7.
8.
9.
10.
Hereby, [Lumi United Technology Co., Ltd] declares
that the radio equipment type [Water Leak Sensor T1,
WL-S02D] is in compliance with Directive 2014/53/EU. The full
text of the EU declaration of conformity is available at the
following internet address:https://www.aqara.com/DoC/
EU Declaration of Conformity
05
inside any part of the body, seek immediate medical
attention.
Disposal of a battery into fire or a hot oven, or mechanically
crushing or cutting of a battery, that can result in an
explosion.
Leaving a battery in an extremely high temperature
surrounding environment that can result in an explosion or
the leakage of flammable liquid or gas.
A battery subjected to extremely low air pressure that may
result in an explosion or the leakage of flammable liquid or gas.
The equipment is only suitable for mounting at heights≤ 2 m.
Under normal use of condition, this equipment should be kept
a separation distance of at least 20cm between the antenna and
the body of the user.
Hereby, [Lumi United Technology Co., Ltd] declares
that the radio equipment type [Water Leak Sensor T1,
WL-S02D] is in compliance with Directive 2017 (SI 2017 No.
1206, as amended by SI 2019 No. 696).
The full text of the UK declaration of conformity is available at
the following internet address:http://www.aqara.com/DoC/.
UK Declaration of Conformity
All products bearing this symbol are waste electrical
and electronic equipment (WEEE as in directive
2012/19/EU) which should not be mixed with unsorted
household waste. Instead, you should protect human health
and the environment by handing over your waste equipment to
a designated collection point for the recycling of waste
electrical and electronic equipment, appointed by the
government or local authorities. Correct disposal and recycling
will help prevent potential negative consequences to the
environment and human health.
Please contact the installer or local authorities for more
information about the location as well as terms and conditions
of such collection points.
WEEE Disposal and Recycling Information
06
1.
2.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
Federal Communications Commission (FCC) compliance
statement:
Symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over
to the applicable collection point for the
recycling of electrical and electronic equipment.
FCC ID:2AKIT-AS014
07
Tabla de contenidos
Idiomas:
Otros manuales de Sensor de seguridad de Aqara
