anko BH9267 Manual de usuario
1
Frozen Drink Maker
BH9267
User Manual
PLEASE READ AND SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE
2
1. NEVER immerse the FROZEN DRINK MAKER motor housing, cord or plug in water or
any other liquid.
2. NEVER use near water or use it outdoors.
3. NEVER leave the unit unattended if used near children.
4. NEVER use a scouring pad on the appliance when cleaning.
5. NEVER use an abrasive sponge or harsh cleaning products on the appliance.
6. NEVER use for anything other than making frozen drinks.
7. Avoid contact with moving parts during use.
8. DO NOT operate this appliance with a damaged cord or plug, or if the product is
damaged.
9. DO NOT place motor base in the dishwasher.
10. The appliance is for use with food and liquids only.
11. Keep out of reach of children.
12. Unplug the appliance from electrical outlet when not in use, before putting on or
removing parts, and before cleaning. Remove plug by gripping the plug body and pulling
out of the outlet. Never yank or twist cord to unplug the unit.
13. This appliance is NOT A TOY. DO NOT allow children to play with the appliance.
WARNING: To prevent damage to the electric motor, the continuous operating time is
2 minutes. Allow the appliance to rest at least 1 minute between each cycle.
IMPORTANT PRECAUTIONS
3
When using electrical appliances, basic safety precautions should always be followed,
including:
1. Read all instructions before operating this appliance.
2. NEVER put fingers or utensils into feed or discharge areas.
3. Keep hands away from blade mechanism. Blades are sharp. DO NOT touch.
4. Keep hands and utensils out of container while blending to reduce the risk of severe
personal injury or damage to the appliance.
5. To protect against electrical shock do not immerse cord, pug or main unit in water or
other liquids.
6. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they are supervised and are given instructions concerning use of the appliance by a
person responsible for their safety.
7. Children should be supervised to ensure that they do not play with the appliance.
IMPORTANT! Unplug from mains power outlet when not in use and before attaching
or removing parts for cleaning.
8. Switch off the appliance and disconnect from mains power before removing
accessories or approaching parts that move in use.
9. If the supply cord is damaged, DO NOT use. For electrical safety, any repairs to the
product should only be carried out by a qualified electrical person only or the product
must be disposed.
10. The use of attachments not supplied with the product may cause a risk of injury to
persons.
11. Do not use outdoors. FOR HOUSEHOLD USE ONLY NOT FOR COOMERCIAL USE.
IMPORTANT SAFEGUARDS
4
12. DO NOT use if shaving blade is loose, cracked, bent or damaged.
13. DO NOT let the cord touch hot surfaces.
14. DO NOT place on or near a hot gas or electric burner, or in a heated oven.
15. Extreme caution must be used when moving this appliance with liquids inside.
16. This appliance must be on a level surface to operate properly.
17. DO NOT use this appliance for other than its intended use.
18. DO NOT leave the appliance unattended while in use or when plugged into mains
power.
19. Check the inside of the ice shaving chamber for foreign objects prior to use.
20. A short power supply cord is provided to reduce the risk of becoming entangled or
tripping over a long cord.
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
5
1
2
3
4
5
6
7
This all-in-one frozen drink maker will make perfect slush drinks, margaritas,
daiquiris, smoothies and more every time! The two ice shaving options allow you to
choose a fine or coarse shaved ice texture. Making one or multiple servings is easy,
with the serving sizes indicated right one the pitcher. Use the included recipes to
make delicious drinks or create your own. With the frozen drink maker, creating
refreshing icy drinks is fun and easy!
KNOW YOUR FROZEN DRINK MAKER
INTRODUCTION
1. Motor housing
2. Selector knob
3. Ice shaving chamber
4. Lid
5. Mixing paddle
6. Pitcher
7. Base
6
CAUTION: The frozen drink maker has a sharp stainless steel blade that can cut and
cause injury. Use EXTREME CAUTION when handling the appliance. Keep fingers clear
from blade and avoid contact at all times when using and cleaning.
Note: When using the appliance for the first time, carefully remove all internal and
external packaging, protective film and accessories.
Before first use, thoroughly wash the ice shaving chamber lid, pitcher and
mixing paddle in warm, soapy water with a non-abrasive sponge or cloth. Dry
thoroughly. IMPORTANT! DO NOT put motor housing or base in water.
Wipe clean the exterior motor housing, base and inside of the unit with a non-
abrasive moist sponge or a damp cloth followed by a non-abrasive dry towel.
After cleaning the inside, put the ice shaving chamber into the motor housing
so it is seated on the shaft. Twist the shaft in the direction of the arrow to lock
into position.
Insert the mixing paddle into the slot in the center of the pitcher.
The cord is located at the base of the unit. Turn the base over, slightly force the
2 clips to the middle and open the cord storage door. Take out the cord and
plug.
Now the frozen drink maker is ready for use.
BEFORE FIRST USE
7
1. Place the appliance on a flat stable, water-resistant surface near an electrical
outlet before starting. Make sure the cord is away from any water source. It is
acceptable to use an extension cord if needed. DO NOT plug in the appliance
into mains power at this time.
2. Place the ice shaving chamber into the motor housing so it is seated on the
shaft. Twist the shaft in the direction of the arrow to lock into position. Make
sure that the ice shaving chamber is free from any foreign objects.
3. Insert the mixing paddle into the slot in the center of the pitcher.
4. Fill the pitcher with your favorite beverage, liquor, juice or drink mix.
NOTE: Use the lines indicated on the side of the pitcher as a guide for how much
liquid to add. You may choose to make a small or large serving.
5. Slide pitcher into place on base and turn clockwise until it stops. This will allow
the mixing paddle to mix ice and ingredients once the operation begins.
6. Turn the selector knob to the desired setting. SLUSH produces a finely shaved
ice; SNOW produces a coarser textured ice.
7. Place ice in ice shaving chamber. Add enough ice cubes, but not above the top
of ice shaving chamber.
BE CAREFUL when placing ice cubes in ice shaving chamber. The blade is very
sharp.
8. Plug cord into a mains power outlet.
9. When you are ready to start making your frozen drink, place the lid on the
appliance and turn counter-clockwise to engage the interlock switch (to turn
power ON/OFF).
OPERATION
8
WARNING: The continuous operating time is 2 minutes. Please rest at least 1
minute between each cycle to prevent the appliance from overheating.
10. The unit will immediately start and begin shaving ice.
Note: it may be necessary to remove the lid during shaving to redistribute the ice.
11. Turn lid clockwise to stop the frozen drink maker from shaving ice. Stop unit
when shaved ice reaches desired shaved ice level indicated on the pitcher. DO
NOT shave ice above max line.
12. To remove pitcher, turn counter-clockwise, slide out and serve your frozen
drink.
By following these simple instructions, you can use your frozen drink maker to make
delightful treats for family and friends!
1. Ice cubes should sit a short while before putting them in the ice shaving chamber.
If ice has a frosty appearance, it is too hard to shave. Let the ice sit until it is
translucent and wet to the touch. Then it is ready to put in the ice shaving chamber.
2. If ice is not shaving, try one of the following:
Turn the appliance off by removing the lid. Redistribute the ice in the ice shaving
chamber. BE CAREFUL to avoid contact with the shaving blade.
Make sure the lid is properly locked to activate the interlock switch to start the unit.
3. If the mixing paddle is not turning, make sure the pitcher has been turned
clockwise on the base until it stops. The mixing paddle must be properly affixed to
the bottom of the pitcher and the top of the appliance in order to mix ice and
ingredients.
HELPFUL TIPS
9
4. It may appear that your frozen drink maker is leaking when unshaven ice melts
and drips onto the base. This is normal. Wipe the base dry with a soft cloth.
IMPORTANT! To prevent water damage to the bench top, ensure the frozen drink
maker is placed on a water-resistant surface.
1. After using your frozen drink maker, disconnect from electrical power outlet.
Remove plug by gripping the plug body and pulling out of the outlet. Never yank or
twist cord to unplug the appliance.
2. Thoroughly wash the lid, ice shaving chamber, mixing paddle and pitcher in
warm, soapy water. Rinse and dry thoroughly. DO NOT place the appliance or any
parts in a dishwasher.
Use EXTREME CAUTION when handling the appliance. Keep fingers clear from
blade and avoid contact at all times when using and cleaning.
3. Use a damp, non-abrasive cloth to wipe exterior motor housing, base and inside
of the appliance. Dry with non-abrasive towel. DO NOT put the motor housing or
base in water or other liquid.
4. Once washing and drying is complete, reassemble your frozen drink maker. Place
the appliance in a clean, dry place.
CLEANING & MAINTENANCE
10
RECIPES
DRINKS
BASIC MARGARITA
2 shots tequila
1 shot triple sec
350ml margarita mix
1 shot freshly squeezed lime juice
Salt & lime wedge for garnish
Ice
OPERATION
Place all ingredients in pitcher with
mixing paddle, except salt, lime
wedge and ice.
Shave ice on SLUSH setting. Refer to
OPERATION section for complete
instructions.
Serves one
STRAWBERRY MANGO MAGRARITA
1 shot tequila
240ml mango juice
3 large fresh strawberries, chopped
Salt for rimming glass (optional)
Ice
Place all ingredients in pitcher with
mixing paddle, except salt, lime
wedge and ice.
Shave ice on SLUSH setting. Refer to
OPERATION section for complete
instructions.
Serves one
Tabla de contenidos
Otros manuales de Mezclador de anko
