Anko 43310852 Manual de usuario

200x280mm

front

anko尺寸 35X11.2mm最小字体高度：2.1mm

ASSEMBLY INSTRUCTIONS

43310852 LOW VOLTAGE 1.2M CHRISTMAS LIGHT UP TINSEL TREE

1. Choose a location where the tree is to be displayed. Take all the components out of the

carton to assemble. Ensure this is placed on a flat, level surface.

2. Carefully insert the tree base pole (Part C) and slide each leg (Part A) upward into the

corresponding slot on the tree base. (See Step 1)

3. Insert all the remaining poles (Part D) into the tree base pole (Part C) one by one and push

down into position. (See Step 2, 3 & 4 )

4. Hold the tree vertically and place the tree section (Part B) at the top of pole (Part D) and let

tree fall around pole to make the tree shape as per the images on the product box. Ensure

the poles (Part D) pass through all the supporting rings at the middle of each tree layer

(Part B). (See Step 5, 6 & 7)

5. The assembled tree picture has been shown in Step 8.

Step 1

Step 2

Step 3

Step 4 Step 7 Step 8

• Please read this assembly instruction carefully and check parts against the list below before assembling your tree.

• Take a few moments to familiarise yourself with the contents.

• Please retain this assembly instruction and box for future reference and storage purpose.

Assembly

Part list

INSERT

POLE

HERE

AAA

Step 6

Step 5

(BOTTOM)

plastic

stopper

Part

Component Quantity

Light Chain (with power adaptor)

AC/DC adaptor (Do Not Cover) warning

These instructions are for your safety. Please read through them thoroughly before use

and retain for future reference.

Before You Start

● Decide on an appropriate location for your product (see Installation instructions below).

● If you have any doubt about installing this product, consult a qualified electrician.

IMPORTANT SAFETY INSTRUCTIONS:

1. The light chain is suitable for INDOOR USE.

2. This product is NOT designed for permanent or long-term use.

3. The power adaptor MUST be installed INDOORS away from weather.

4. The supplied adaptor is suitable for operation of LED Modules only.

5. Only operate this light chain with the supplied power adaptor. Model: YF-AS-30V3.6W

6. Do not connect this light chain electrically to another light chain.

7. Do not connect this light chain to the power supply while it is in the packaging.

8. DO NOT attempt to replace the non-replaceable bulbs in this light chain.

9. Never allow any part of the set to come into contact with a source of heat or flame.

10. Care must be taken to avoid damage the cable or fittings.

11. If any part of light set or cable is damaged, the light set MUST be discarded.

12. This product is for use as a decoration only. Not to be used by children as a toy.

Keep out of reach of children.

13. Do not position this light chain where it will be exposed to extreme wet weather or

submerged in water.

14. Always switch off this light set or unplug an adaptor if unattended.

15. DO NOT overload power sockets or extension leads.

16. DO NOT pierce the cable when securing in place, bend or stand on the light chain,

as this will damage the bulbs or wiring.

17. Please refer to the packing or product rating label for product class, specifications, and rating.

LED Bulbs

This light set is constructed with non-replaceable bulbs. DO NOT attempt to replace any of the

bulbs in the light set.

LED Driver (AC/DC Adaptor) Manual

1. Do not open the cover of the equipment.

2. For use with LED lighting equipment.

3. The input and output voltage should be checked before use to ensure correct use.

4. This is a Class II product, only for indoor use.

5. The product is not a toy, keep it where children cannot reach.

6. The lamp control gear does not rely upon the luminaire enclosure for protection

against accidental contact with live parts.

7. If applicable an indication that the controlgear is suitable for operation with LED modules.

8. Do-not-cover classification

The power supply (LED Drive) that can be used where normally

flammable materials including building insulation,

are or may be present, but cannot be abutted against any material and cannot be covered in normal.

back

200x280mm

Tabla de contenidos

Otros manuales de Pino artificial de anko

anko

anko JT-DC12V7.2W-E4 Manual de usuario

Manuales populares de Pino artificial de otras marcas

Trim a Home

Trim a Home TY-S6-250L Manual de usuario

Polygroup

Polygroup TG7600NVQC03 Manual de usuario

Sears

Sears Donner & Blitzen M44814 Manual de usuario

BETHLEHEM LIGHTING

BETHLEHEM LIGHTING 6.5’ Tinsel Tree Manual de usuario

Home Accents Holiday

Home Accents Holiday TG76P3D93L08 Manual de usuario

Polygroup

Polygroup TG76M3S45C02 Manual de usuario

Polygroup

Polygroup TG90P3693L00 Manual de usuario

Costway

Costway CM23595US Manual de usuario

Polygroup

Polygroup TV46M3ADVC05 Manual de usuario

Home Accents Holiday

Home Accents Holiday TG76P4C15D03 Manual de usuario

Polygroup

Polygroup TV46P7001X00 Manual de usuario

Holiday Living

Holiday Living TV40EH339C01 Manual de usuario

Polygroup

Polygroup TGC000NY1C00 Manual de usuario

CASARIA

CASARIA DBGB001 Manual de usuario

Alpine

Alpine CRD100L-WT Manual de usuario

Home Accents Holiday

Home Accents Holiday TG76M3W89C00 Manual de usuario

CASARIA

CASARIA 104006 Manual de usuario

Polygroup

Polygroup TG70P3D94D00 Manual de usuario

anko 43310852 Manual de usuario

Manuales populares de Pino artificial de otras marcas