Amrotec MiB-1 Manual de usuario
MiB-1
Single Pocket - Currency Discriminating Counter
w/ Multi-Currencies in a Single-Pass
Operator’s Manual V.10
Table of Contents
Chapter 1. Introduction..................................................................................................................1
Compliance Statement ........................................................................................................................................ 1
Abbreviations and Acronyms.............................................................................................................................. 2
Safety Precautions ............................................................................................................................................. 2
Chapter 2. Overview of
MIB-1
...................................................................................................3
MIB-1
at a Glance ........................................................................................................................................... 4
Overview of Control Panel ................................................................................................................................. 5
Overview of LCD Display .................................................................................................................................. 5
Chapter 3. Operating
MIB-1
......................................................................................................6
Power On / Off.................................................................................................................................................... 7
Placing Banknotes............................................................................................................................................... 7
Counting Speed …………………………………………………………………………………………………8
Selecting Currency, Auto and Multi-Currency ................................................................................................... 8
Single Currency…….................................................................................................................................8 - 9
Auto Currency…………………....................................................................................................................
9
Multi-Currency ............................................................................................................................................. 9
Batch Counting ............................................................................................................................................ 9 - 10
Denomination Batch Setting (DB).........................................................................................................10 - 11
Add Mode…………….......................................................................................................................................11
Auto / Manual Start Mode……………..............................................................................................................11
Auto-Print………………………………………………………………………………………………….11 - 12
Counterfeit Detection (CFD) .......................................................................................................................... ..12
Discrimination and Count Modes ..................................................................................................................... 13
Counting Operation in Various Modes……………………………………………………………….……14 - 18
Manual Entry Function……………………………………………………………………………….…....14 - 15
Counting Results & Display Content.……………………………………………………………………..18 - 19
Printing the Summary………………………………………………………………………………………….19
Chapter 4. Setting
MIB-1
..........................................................................................................20
Function and Environmental Settings............................................................................................................... 21
Service Menu.................................................................................................................................................21
Version Information ......................................................................................................................................21
Current Time Setting
.................................................................................................................................................
22
Setting DB (Denomination Batch).................................................................................................................22
Stacker Capacity............................................................................................................................................22
Chapter 5. Maintaining
MIB-1
.................................................................................................23
Open Bill Path................................................................................................................................................... 24
Cleaning (Exterior, Bill Path) of MIB-1 ..................................................................................................24 – 25
Error Codes…………………………………………………………………………………………………….26
Appendix. Specification..................................................................................................................27
Limited Warranty, Disclaimer, Service……………………………………………………………28
Chapter 1. Introduction
Introduction......................................................................................................................................................... 1
Compliance Statement ........................................................................................................................................ 1
Abbreviations and Acronyms.............................................................................................................................. 2
Safety Precaution………………………………………………………………………………………………..2
Page | 1
Introduction
This guide covers the installation, operation and troubleshooting of MIB-1 Currency Counter.
We recommend reading this guide thoroughly before operating the Currency Counter. Then, as you
become more familiar with MIB-1,use it as a reference guide to look up information when you need
it.
Compliance Statement
THIS DEVICE COMPLIES WITH PART 15 OF FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
CONDITIONS:
1. THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND
2. THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATIO
N.
FCC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and emits radio frequency energy and, if not installed and used in
accordance with the instruction manual may cause harmful interference in radio communications.
Operation of this equipment in a residence area is likely to cause harmful interference in which
case the users will be required to correct the interference at their own expense.
Changes or modifications of this product not
expressly approved by manufacturer, could void the
user’s authority to operate the equipment.
Abbreviations and Acronyms
U
SB
Universal Serial Bus
IR
MR / MT
Infrared detector sensor
Magneto
-
Resistive sensor
/ Metal Thread
MG Magnetic head sensor
MB
Megabyte
PC
Pe
rsonal Computer
Page | 2
Safety Precautions
Please read the safety precautions below before operating
MIB-1
Currency Counter device.
These safety precautions guideline must be observed to avoid any potential hazards that could
resulted in personal injuries or damage to
MIB-1
Currency Counter.
Electrical Safety!
To avoid the risk of electrical shock, fire, or damage to the Currency Counter:
Do not remove the side, and bottom covers in any situation.
Do not disassemble the device by yourself.
Do not use damaged or worn power cords or plugs. Use the power cord supplied inside the
original packaging carton and connect to a properly grounded power outlet or to a power
strip. The power source for the device is between AC 100-240V AC, ±10%, 50/60Hz, 1.8A.
Keep metal objects, such as paper clips, away from the hopper and stacker. If an object does
fall into the unit, turn off the power and unplug the device immediately. Contact your
authorized
MIB-1
service provider for assistance.
Keep liquids away from the device. Do not operate the Currency Counter if it is wet. Also,
do not touch the Currency Counter if you are wet. If a spill occurs, turn off the power and
unplug the device immediately. Contact our authorized
MIB-1
service provider for help.
Warning!
The Currency Counter may start operating accidentally in certain circumstances as described
below. Therefore, it is important to always follow these below precautions:
Do not wear loose clothing or jewelry while operating the Currency Counter.
Make sure that your hair does not touch the Currency Counter.
Do not touch banknotes that have been placed in the stacker while the motor is running.
Turn off the power before performing any maintenance or error corrections that require you
to put your hands into the device.
Keep the device away from magnets, activated cellular phones, electrical appliances, or
speakers within 13 cm / 5 inch.
Cautions!
Keep drinks, food, and other foreign objects away from the
Currency Counter.
Placing foreign objects on or into the Currency Counter can
interr
upt
o
peration of the device.
Page | 3
Chapter 2. Overview of MIB-1
MIB-1
at a Glance................................................................................................................................
4
Overview of Control Panel ....................................................................................................................
5
Overview of LCD Display.....................................................................................................................
5
Page | 4
MIB-1 at a Glance
Power
Switch
Power
So
cke
t
N
o
te
Guide
Hopper
10
-
Key
Pad
3.5
”
TFT LCD
Stacker
Page | 5
Overview of Control Panel
Overview of LCD Display
10
-
Keys Pad and
respective Functions 3.5” TFT LCD
Display Navi ation /
Browsin Keys
START/STOP
/ ESC keys
Currency Name
Auto
start /
Manual
s
tart
Piece (Qty)
Count
Count
Results
$ Value
Counting
Modes
Cou
n
t
ing
Speed
Addition
Mode
Variabl
e atc
h
o
r
Denomination (D ) atch
Page | 6
Chapter 3. Operating
MIB-1
Power On / Off.................................................................................................................................................... 7
Placing Banknotes............................................................................................................................................... 7
Counting Speed …………………………………………………………………………………………………8
Selecting Currency, Auto and Multi-Currency ................................................................................................... 8
Single Currency…….................................................................................................................................8 - 9
Auto Currency…………………....................................................................................................................
9
Multi-Currency ............................................................................................................................................. 9
Batch Counting ............................................................................................................................................ 9 - 10
Denomination Batch Setting..................................................................................................................10 - 11
Add Mode…………….......................................................................................................................................11
Auto / Manual Start Mode……………..............................................................................................................11
Auto-Print…………………………………………………………………………………………………11 - 12
Counterfeit Detection (CFD) .......................................................................................................................... ..12
Discrimination and Count Modes ..................................................................................................................... 13
Counting Operation in Various Modes…………………………………………………………………….14 - 18
Manual Entry Function…………………………………………………………………………………….14 - 15
Counting Results & Display Content.……………………………………………………………………..18 - 19
Printing the Summary…………………………………………………………………………………………..19
Page | 7
Power On / Off
To power on
MIB-1
:
Plug in the A/C power cord to the Power Socket.
Press the Power Switch button (I/O) on the rear side of
MIB-1.
After System initialization stage is completed,
MIB-1
enters into main display screen and ready.
To power off
MIB-1:
Prior powering off, make sure that all counting results are
saved to memory.
Press the power switch button (O/I) to turn off the device.
Placing Banknotes
To operate the currency Discriminator device efficiently, please follow the below instructions:
Avoid counting wet, excessively dirty, or spoiled banknotes.
Check for foreign object mixed with banknotes, i.e.: paper chips, rubber bands, clips, dust, etc.
which will jam the bill path or even may damage the sensors.
Prior counting, remove severely folded or curled banknotes from the stack of banknotes to be
counted.
Align all corners and edges of banknotes to avoid excessive rejection of banknotes to reject stacker
for recognition errors.
Put all banknotes in the middle of the note hopper and adjust the hopper guide for better alignment
and feeding of banknotes.
Otros manuales para MiB-1
2
Tabla de contenidos
Manuales populares de Contadora de billetes de otras marcas
Safescan
Safescan 2660-S Manual de usuario
PRO Intellect Technology
PRO Intellect Technology PRO 95U Manual de usuario
Dors
Dors 600 Manual de usuario
radiotec
radiotec rapidcount S 575 Manual de usuario
CUMMINS ALLISON
CUMMINS ALLISON JetScan Manual de usuario
PRO Intellect Technology
PRO Intellect Technology 40 NEO Manual de usuario
