4 Operating and installation instruction EPO.D
Picture 1 View
No filter[12] on water supply
(picture 3) can damage the
heater.
This appliance should be instal-
led and started-up by a profes-
sional person.
This heater must be installed
with the outlet and inlet pipes
at the top.
Electric and water supplies have
to be cut off during any installa-
tion work.
Diagram 2 Domestic water system
Diagram 3 Water connection
7 - inlet - cold water
8 - outlet - hot water
12 - filter
16 - screw
U - gasket
ZW - cold water feed
CW - hot water outflow
3
Recommendations
- as an economy measure the he-
ater should be installed close to
the most frequently used tap;
- the appliance can be connected
to a cold water supply pipe
only;
- a non-return valve cannot be in-
stalled on the supply pipe;
- inlet and outlet pipes should not
be made of plastic;
- the heater works in conjunction
with taps and mixers without a
thermostat.
Assembly
1. Bring the domestic water and
the electricity supply, observing
normal safety standards, to the-
point where the heater is to be
mounted. Diagram No.2 shows
how to connect the heater with
the water installation.
2. Remove the heater's outer case;
undo the screws [16], slide the
case off starting from the top.
3. Fix the heater on supplied hooks
after inserting the electric wires
through the entry access [14].
4. Connect cold water [ZW] to the
inlet pipe[7] inserting a filter
in between[12]; connect hot
water outlet[8] to a pipe [CW]
(picture 3).
5. Flood the heater with cold water
and check connections for le-
aks.
1
Installation
2
