5
Installation & Operation Manual | Sigma Pro| General Safety Instructions
General Safety Instructions
•Amiad Water Systems Ltd. ("Amiad") filtration products operate as components in a larger system. It is
essential for the system designers, installers, and operators to comply with all the relevant safety standards
and regulations, including the use and wear of appropriate safety equipment.
•Prior to installation, operation, maintenance, or any other type of action carried out on the filter, carefully
read the safety, installation, operation and warranty instructions.
•During installation, operation, commissioning, or maintenance of the filter, all conventional safety
instructions should be observed to avoid danger to any person, including the workers performing the said
activity, or to property in the vicinity.
•Please note: the filter enters a flushing mode automatically, without warning.
•Manual cleaning of filter element using high water pressure or steam should be performed in accordance
with the cleaning system instructions, the local standards, and regulations.
•Manual cleaning of filter element using acid or other chemical agents should be performed in accordance
with the relevant material safety instructions, the local standards, and regulations.
Observe and act according to the requirements detailed in the safety stickers on the filter, if any.
Tools needed for installation
Use only appropriate standard tools and equipment operated by qualified operators when installing,
operating and maintaining the filter.
*Amiad supplies the Sigma Pro multi-tool only.
Grease
760190-000127 Flathead screwdriver Open wrench
11mm (1/4'')
Sigma Pro multi-tool
710101-001445
Use only with
Rinse controller
