Altronix LPS3 Manual de servicio

Overview:

The LPS3 Linear Power Supply / Charger will convert a low voltage AC input to a low voltage 12/24VDC

output. This power supply is specifically designed to provide to power needed by the most demanding security

and access control applications.

Specifications:

• Field selectable 12/24VDC power limited output.

• 2.5 amps continuous supply current.

• Filtered and electronically regulated output.

• Built-in charger for sealed lead acid or gel type batteries.

• Maximum charge current 500mA.

• Automatic switch over to stand-by battery.

• AC input and DC output LED indicators.

• Over voltage protection.

• Thermal overload and short circuit protection.

• Fused battery protection (circuit breaker available).

• Efficient switch mode design.

• Includes battery leads.

Board Dimensions: 6.5”L x 3.5”W x 1.75”H

Specified at 25˚ C ambient.

Voltage Output/Transformer Selection Table:

Output Voltage Switch Transformer Requirements

Position (Recommended Altronix Part #’s)

12VDC Closed 16VAC / 56 VA (T1656)

24VDC Open 28VAC / 100 VA (T2885)

Note: Transformers with higher VA ratings may be used.

Installation Instructions:

The LPS3 should be installed in accordance with The National Electrical Code

and all applicable Local Regulations.

1. Mount the LPS3 in desired location / enclosure.

2. Set DC output voltage using switch SW2 (refer to voltage output/transformer selection table).

3. Connect proper transformer to terminals marked AC (refer to voltage output/transformer selection table).

4. Connect devices to be powered to terminals marked [---DC +].

Note: It is good operating practice to measure and verify output voltage before

connecting devices to ensure proper operation of equipment.

5. When the use of stand-by batteries are desired, they must be lead acid or gel type.

Connect battery to terminals [+ BAT ---] as marked on the unit (battery leads included).

Use two (2) 12VDC batteries connected in series for 24VDC operation.

Note: When batteries are not used a loss of AC will result in the loss of output voltage.

IILPS3-Rev.122198

LPS3 - Linear Power Supply/Charger

Altronix®

AC DC

AC AC - DC + - BAT +

ALTRONIX CORP. “LPS3 POWER SUPPLY”

12V Closed

24V Open

SW1

LED Diagnostics:

Red (DC) Green (AC) Power Supply Status

ON ON Normal operating condition

ON OFF Loss of AC, Stand-by battery supplying power

OFF ON No DC output. Short circuit or thermal overload condition

or defective unit.

OFF OFF No DC output. Loss of AC. Discharged or no battery present.

Terminal Identification:

Terminal Function/Description

Legend

AC/ AC Low voltage AC input (see voltage output/transformer selection table).

For 12VDC output use 16VAC with 56VA power rating or higher.

For 24VDC output use 28VAC with 85VA power rating or higher.

- DC + 12-24VDC @ 2.5 amps continuous power limited output.

+ BAT - Stand-by battery connections. Maximum charge rate 350mA.

Altronix Corp.

140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056

web site: www.altronix.com, e-mail: [email protected], Lifetime Warranty, Made in U.S.A.

MEMBER

Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.

AC DC

AC AC - DC + - BAT +

ALTRONIX CORP. “LPS3 POWER SUPPLY”

12V Closed

24V Open

SW1

Tabla de contenidos

Otros manuales de Fuente de alimentación de Altronix

Altronix

Altronix AL400ULPD8 Manual de usuario

Altronix

Altronix AL175UL Manual de usuario

Altronix

Altronix AL300ULM Manual de usuario

Altronix

Altronix OLS20220 Manual de usuario

Altronix

Altronix 220VAC Series Manual de usuario

Altronix

Altronix Trove T1MK1F4 Manual de usuario

Altronix

Altronix Vertiline8C Manual de usuario

Altronix

Altronix ALTV244UL3 Series Manual de usuario

Altronix

Altronix AL400ULPD4CB Manual de usuario

Altronix

Altronix ALTV2432220 Instrucciones de funcionamiento y mantenimiento

Altronix

Altronix PoE201 Manual de usuario

Altronix

Altronix AL1024NK8 Series Manual de usuario

Altronix

Altronix T2428100CP Manual de usuario

Altronix

Altronix Rack Mount Series Manual de usuario

Altronix

Altronix AL100UL Manual de usuario

Altronix

Altronix TROVE T1KE34D Manual de usuario

Altronix

Altronix R2416UL Manual de usuario

Altronix

Altronix AL300ULXJ Instrucciones de funcionamiento y mantenimiento

Altronix

Altronix ALTV2416300UL Instrucciones de funcionamiento y mantenimiento

Altronix

Altronix AL300ULXD Manual de usuario

Altronix

Altronix SMP5 Manual de usuario

Altronix

Altronix eFlow3NB Manual de usuario

Altronix

Altronix Vertiline3D Manual de usuario

Altronix

Altronix Trove1V1 Manual de usuario

Manuales populares de Fuente de alimentación de otras marcas

Monacor

Monacor PS-12CCD Manual de usuario

VOLTIMA

VOLTIMA MagicBox 15 Manual de usuario

Agilent Technologies

Agilent Technologies 6032A Manual de usuario

Miller

Miller Auto Deltaweld 452 Manual de usuario

BCP

BCP PUOUBK Hoja de instrucciones

HC 2210 Manual de usuario

Puls

Puls CT5.241 Manual de usuario

OCZ

OCZ ZX1250W Manual de usuario

iseg

iseg ECH 238 Manual de usuario

Power

Power XXL A Series Manual de usuario

Agilent Technologies

Agilent Technologies 6631B Manual de usuario

Renogy

Renogy PHOENIX 300 Manual de usuario

HP 6200B Manual de servicio

Epson

Epson Stylus Scan 2500 Manual de funcionamiento

Pulsar

Pulsar GREEN POWER CCTV PoE POE044816 Manual de usuario

Puls

Puls MiniLine ML50.100 Manual de usuario

Puls

Puls AS-Interface SLA4.100 Manual de usuario

Kenwood

Kenwood PS-60 Manual de usuario