ALLPOWER 1350 Manual de usuario

USER MANUAL

INVERTER GENERATOR

OPERATING INSTRUCTIONS

PLEASE READ THIS MANUAL CAREFULLY

BEFORE USING THE MACHINE

ALLPOWER INDUSTRIESAUSTRALIA

A.B.N 46 650 681 742

Unit 5, 102-128 Bridge Road, Keysborough, VIC 3173, Australia

Telephone: +61 38726 1444 / 1800 333 428

Email: sales@allpower.com.au

www.allpower.com.au

ALLPOWER INDUSTRIES NEW ZEALAND

IRD: 101-149-803

PO Box 97100

Manukau City, 2241, Auckland, New Zealand

Telephone: +64 9 256 0730

Email: sales@allpower.co.nz

www.allpower.co.nz

CONTENT

1. Quick Start ………………………………………………3

2. The Safe Operation …………………………………….5

3. Safety precautions label position………………………7

4. Parts Identification……………………………………….8

5. Pre Checks…….………………………………………...9

6. Start the Engine…………………………………………12

7. Use of the generator……………………………………14

8. Switch off the engine……………………………………19

9. Maintenance……………………………………………..20

10.Transportation/Warehousing………………………….25

11.Troubleshooting………………………………………..26

12.Specifications…………………………………………..29

1. Quick start

Warning

Only activate outdoors. Generator of toxic carbon monoxide, a colorless, odorless gas that

can cause death or serious injury.

Ensure that the generator is placed horizontally.

Do not operate the generator in the rain, snow or other humid environments.

Refuel away from cigarettes and sparks to avoid fire or explosion.

Checks before start

1. Remove the oil access door; unscrew the dipstick to check the oil. If oil level is below the

bottom of the dipstick, add the recommended oil (oil capacity: 0.4L). Use a strong detergency,

four-stroke engine oil and choose proper viscosity of the oil according to your area's average

temperature.

2. Install side access panel.

3. Unscrew the fuel tank cap to add petrol to the fuel tank. Please use unleaded

petrol or above 91 octane petrol. Not add too fast, so as not to spill petrol and to prevent dirt,

dust or water from getting into the tank. Tighten the fuel tank cap after the addition

is complete.

Be careful

Do not use two-stroke petrol or dirty petrol.

Start the generator

4. Follow the below steps to start the generator

A．Recoil start:

i. Open the fuel switch.

ii. Turn on the start switch.

iii. Gently pull the lever to start to feel resistance, and then quickly pull the handle to start,

start the generator.

5. When the output indicator lights up on the control panel, the generator can

be used. Before connecting any load, the generator should be grounded. Please use a thick

cable to ground the terminal on the generator. Control panel is connected to an external

ground source.

6. Make sure all equipment is turned off and the switch in order to ensure that the equipment is

intact, confirm the use of electrical appliances does not exceed the total power rating of the

generator.

7. Connect your device to a suitable outlet generator control panel.

Turn off Generator

Note

When the start switch on the control panel is turned off, the generator will stop immediately.

1. Turn off the generator in the following manner.

i. Turn off the connected device switch, unplug it.

ii. Turn off start switch.

iii. Close fuel switch.

Foreword

Thank you for purchasing our Inverter generator

The book includes XG1350, XG2600 and XG3600 intelligent inverter generator operation and

maintenance information consistent with the latest product.All contents were correct at the time of print.

This book serves as a fixed part of the generator. If the generator is sold again, it should remain with the

generator. Copyright of this manual belongs with Allpower. No reproductions are allowed without prior

permission.

Please pay special attention to the following text:

Warning

If you do not follow the correct operation of this book where this symbol is displayed, it will lead to serious

personal injury and other accidents including death.

Note

If you do not follow the correct operation of this book where this symbol is displayed, it will lead to serious

personal injury and other accidents including death.

If you have any questions about the generator, please contact your dealer.

Be careful

If you operate the generator In accordance with the operating manual, your generator will function safely

and reliably. Be sure to read and understand the instructions before use, otherwise incorrect operation

could result in personal injury, equipment damage or death.

2. The safe operation

Warning

If you operate the generator in accordance with the operating

manual, your generator will run safely and reliably. Before operating the

generator, carefully read and understand this manual, otherwise it may

cause personal injury, damage to equipment or death.

Warning

Exhaust contains poisonous carbon monoxide. Do not operate the

generator in poorly ventilated place. Ensure that the generator is operated

in a dry, airy, clean place to work. DO not use indoors.

Warning

The muffler is very hot during while the generator is running or just after

shutdown, be careful not to touch it. Store the generator away only after it

has cooled down.

The exhaust system is very hot while the generator is running or just after

shutdown. To avoid burns, please pay attention to the warning labels

attached to the generator.

Warning

Do not parallel the wires in the socket. Use an application-specific cable

before parallel connection, or it may lead to electric shocks.

Matters ensure safe operation

Warning

Under certain conditions, extremely flammable gas. Always refuel in well-ventilated place,

turn off the engine before refueling.

Stay away from cigarettes, sparks when refueling. Refuel in well-ventilated place.

Warning

If the unit is used as a building backup power generator connected to its power system

operation by a qualified electrician, and must comply with relevant laws and electrical

codes. Otherwise, electricity may back on the power line, if the power company employees or

other people in contact with the power transmission might cause death; at the same time due

to the impact of electricity, the generator may explode burn or cause electricity building

equipment fire.

Warning

In order to avoid accidents and damage to the equipment, you must do a start test each time

before you start the equipment.

Run generator at least 1m away from buildings and other equipment.

The generator must be level when it is running if the generator is tilted it may cause fuel

overflow.

Operator of the generator shall be trained to know how to quickly turn off the generator, and

understand the operation of all control components. Never allow untrained persons to operate

the generator.

Children and pets must stay away from the operating area.

When the engine is running, you must stay away from its rotating parts.

The generator has the potential to e dangerous if operated incorrectly. Do not operate the

generator with wet hands.

To prevent getting the generator wet, do not operate in the rain or snow.

3．Safety Precautions label position

These decals details tips that may help you avoid serious injury or accidents.

Please read this manual carefully, paying careful attention to safety and caution details.

Fire ban labels

Parameter labels

Noise stickers

Anti-hot stickers

Oil switch stickers

4．Parts Identification

Control panel

Top access panel

Battery access panel

Fuel tank cap

Fuel switch

Side access panel

Outlet cover

Start Handle

Control panel

AC socket

Engine sw

itch

DC socket

Ground

Output

Oil alarm

Overload

DC protector

5．Pre checks

Be careful

Be sure to check whether the generator is level place and ensure the engine is turned off.

1.Check the oil level

Be careful

Using non-detergency oil or 2-stroke engine oil could shorten the engine life. Recommended

oil is SAE10W30.

Use a strong detergency, high-quality 4-stroke engine oil, which must meet or exceed US

automobile manufacturer's requirements of the American Petroleum Institute

classification SG, SF levels.

Select the appropriate viscosity of the oil according to the average temperature in your area.

SAE viscosity grade as follows:

Loosen the screws of the side access panel to remove the cover.

Remove the dipstick with a clean rag to wipe the oil dipstick, without tightening the dipstick and

insert it into the oil port to check the oil level.

If the oil level is below the bottom of the dipstick, add the recommended oil.

Be careful

Operating the engine when the oil is low may seriously damage the engine.

Oil alert system will shut down the engine automatically before oil level falls under the safety

line. In order to avoid inconveniences caused by unexpected halt, we recommend you check

the oil level regularly.

Single Viscosity

Multi-viscosity

2.Check the fuel level

Use automotive petrol (preferably unleaded or 91 octane unleaded petrol to reduce choke

combustion and reduce environmental pollution).

When the fuel level is too low, add fuel to a predetermined level.

Do not use a mixture of oil and petrol or dirty petrol.

Prevent dirty water from getting into the tank.

After the completion of refueling tighten fuel cap.

Warning

Petrol is explosive under certain conditions.

Please refuel in a well ventilated area and turn off the engine when refueling. Flames and

sparks are strictly prohibited from the petrol generator fuel storage area.

Never add fuel when the generator is running, that’s very dangerous.

Do not spill (there should be no fuel above the neck). After the completion of refueling tighten

fuel tank cap.

Be careful not to spill fuel when refueling, to prevent fuel spills and ignition. If there is an

overflow of fuel ensure that the area of fuel has evaporated before starting the engine.

Avoid prolonged, repeated exposure to petrol or inhaling mist. Do not let the generator come

into reach of children.

Fuel tank cap

Dipstick

Oil injection port

Top line

Bottom line

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Generador portátil de ALLPOWER

ALLPOWER

ALLPOWER APGG12000GLCS Manual de usuario

ALLPOWER

ALLPOWER APG3009 Manual de usuario

ALLPOWER

ALLPOWER APG3101 Manual de usuario

ALLPOWER

ALLPOWER APG3075 Manual de usuario

ALLPOWER

ALLPOWER APG3004D Manual de usuario

ALLPOWER

ALLPOWER APG3090 Manual de usuario

ALLPOWER

ALLPOWER APGG7500 Manual de usuario

ALLPOWER

ALLPOWER APGG7500 Manual de usuario

ALLPOWER

ALLPOWER APG3202 Manual de usuario

ALLPOWER

ALLPOWER APGG4000 Manual de usuario

ALLPOWER

ALLPOWER APG3304 Manual de usuario

ALLPOWER

ALLPOWER APG3009 Manual de usuario

ALLPOWER

ALLPOWER APG3008 Manual de usuario

ALLPOWER

ALLPOWER APGG10000GL Manual de usuario

ALLPOWER

ALLPOWER APG3009 Manual de usuario

ALLPOWER

ALLPOWER APG3014 Manual de usuario

ALLPOWER

ALLPOWER APG3303 Manual de usuario

ALLPOWER

ALLPOWER APGG10000 Manual de usuario

ALLPOWER

ALLPOWER APG3201N Manual de usuario

ALLPOWER

ALLPOWER APG3006 Manual de usuario

ALLPOWER

ALLPOWER APG3010 Manual de usuario

ALLPOWER

ALLPOWER APG3090 Manual de usuario

ALLPOWER

ALLPOWER APG3002S Manual de usuario

ALLPOWER

ALLPOWER APG3535 Manual de usuario

Manuales populares de Generador portátil de otras marcas

Kohler

Kohler 20EORZ Manual de instrucciones

Powerhorse

Powerhorse 83171 Manual de usuario

HURST

HURST ML-630-SI Manual de usuario

ETQ

ETQ TG4000 Manual de usuario

Briggs & Stratton

Briggs & Stratton 40265 Guía de configuración

ConMed

ConMed 7550 Manual de usuario

Owon

Owon Waveform Generator Manual de usuario

evertz

evertz 7700 Series Manual de usuario

Power Stroke

Power Stroke PS906025 Manual de usuario

Firefly

Firefly Cygnus CYG2400/460/24 Manual de usuario

Draper

Draper PG950S Actualización de firmware

PowerBoss

PowerBoss PowerBoss Manual de usuario

SDMO

SDMO SH 4000 Manual de usuario

EINHELL

EINHELL STE 5500 Manual de usuario

Wanco

Wanco WI3000P Manual de usuario

Full Boar

Full Boar FBT-3300 Manual de usuario

Dwyer Instruments

Dwyer Instruments ASG Manual de usuario

Westinghouse

Westinghouse WH1000i Series Manual de usuario