1716 1716
When the cookin process is complete, the appliance will automatically activate the keep warm function.
The WELL DONE indicator li ht will remain lit, and the appliance will beep every 20 seconds.
If the food is left in the rill, it will continue to cook while the plates cool down. You can press "OK" to
stop the beepin .
NOTE: the safety system will automatically turn off the appliance after a certain period of time (approximately
30 minutes).
• Press on/off to turn off the appliance.
• Unplu the rill.
• Allow to cool for at least 2 hours.
• To avoid accidental burns, allow the rill to cool completely before cleanin .
• Before cleanin , unlatch and remove the plates to avoid dama in the cookin surface.
• The drip tray and the cookin plates are dishwasher safe.
• The appliance and its cord must never be placed in the dishwasher. The heatin elements (the visible
and accessible parts) must never be cleaned after the plates have been removed. If they are very dirty,
wait until the appliance is completely cool and use a dry cloth to clean them.
If you do not want to place the plates in the dishwasher, use hot water and a little dish deter ent to
wash them, then rinse them thorou hly to remove all residue.
• Wipe them carefully with a paper towel.
• Do not use a metallic scrubber, steel wool or abrasive cleanin products to clean any part of the rill.
Only use nylon or non-metallic cleanin pads.
• Empty the drip tray and wash it in sli htly soapy hot water, then wipe it with a paper towel.
KEEP WARM FUNCTION
CLEANING AND MAINTENANCE
• To clean the lid of the rill, wipe it with a spon e rinsed in hot water and then dry it with a soft, dry cloth.
• Do not immerse the casin of the rill in water or any other liquid.
• Ensure that the rill is clean and dry before stora e.
• Any repairs must be carried out by an approved service representative.
FAQ
Problems Cause Solutions
button flashin
+ solid
indicator li ht +
button flashin .
Switchin "ON" of the
appliance or startin an
automatic cookin cycle
with food between plates
and without preheatin
(settin temperature). The
manual mode is
automatically activated.
2 possible options:- choose the temperature settin
by pressin the button and then press .
Allow to cook, but you must monitor the cookin
(manual mode). Open the rill completely, remove
the food, close the rill properly, re-pro ram the
rill and wait until the end of preheatin (settin
temperature).
The rill stops durin
the cycle of
preheatin (settin
temperature) or
cookin .
The rill has been kept
open for too lon while
cookin . The rill has been
idle too lon after the end
of warm up (settin
temperature) or keep warm.
Disconnect the rill from the outlet and leave for
2-3 mins, restart the process. The next time you
use the rill, make sure you open and close it
quickly for the best cookin results. If the problem
occurs a ain contact your local All-Clad customer
service.
