Algoma Net 6800 Guía de instalación

Model #6800

Deluxe Hammock Lounge With Canopy

Assembly & Care Instructions

Do Not Return This Item Back To

The Store.

For customer service or replacement parts, please call

800-295-6758 Monday through Friday 8am-4pm CST

or email customer service at:

customerser[email protected]

Contents

-Customer service information

-Safety, Use and Care information

-Assembly Instructions

WARNING

-Maximum weight capacity 350 lbs.

-Do not allow children to play on the

hammock lounge. It is designed for

adult lounging only.

IMPORTANT INSTRUCTIONS AND WARNINGS

WARNING

Set up

•Please read and understand this entire manual before attempting to assemble the product.

•This unit must be assembled and disassembled by adults only.

•Keep small children and pets away from hammock lounge during assembly.

•Hammock must be assembled and used on level ground. Sloping or uneven ground will put

stress on joints which could cause joints to become loose and the hammock unstable which

may result in serious injury.

Use

•Read Instructions and all accompanying literature and follow it carefully before using.

•Always inspect the hammock for proper tightness of fasteners. Loose fasteners or snap-pins

could cause the unit to malfunction causing potential collapse or injuries.

•Close adult supervision is required when children are using the hammock lounge.

•Place the hammock in a location with a minimum safe distance from open fire, electrical wires,

or any other hazard that could cause the hammock to malfunction or become damaged.

•Avoid jumping or bouncing on hammock. Enter the hammock by gently sitting then laying on

hammock bed.

•Do not exceed maximum weight limit of 350 lbs.

•Do not stand on the hammock. You could lose balance resulting in a fall and injury.

•Do not allow anyone or a pet under the hammock when it is being used.

Care and Maintenance

•Wash frame parts and fabric with mild soap and water. Rinse thoroughly and wipe frame dry

with clean towel. Allow the fabric to air dry.

•Do not use bleach, acid, or other solvents on the fabric or frame parts.

•In order to prolong the life and beauty of your hammock lounge we recommend that the

hammock lounge be stored in a dry area when not in use or during inclement weather such as

wet or rainy days.

•Check all parts before each use to assure safe and secure use.

•The manufacturer will not accept responsibility for unauthorized repair or modifications to the

hammock.

•Always remove the canopy in windy conditions, otherwise the canopy may tip over or

otherwise be damaged.

•This product is manufactured with UV resistant material. Despite this, it is exposed to the

outdoor elements including sunlight, wind, rain, snow, and wildlife. Please inspect all

connections and the entire product for overall integrity. If there are any signs of excessive

wear, damage, stretching, cracking, looseness, brittleness or other losses in integrity, do not

use the hammock.

PARTS LIST

PACKAGE CONTENTS

PARTS LIST (continued)

PACKAGE CONTENTS

Part Description Qty Part Description

Qty

Part Description Qty

A Plastic Feet 4 G Foot end Stand Support

1 M Canopy Middle

Support 1

B Long Leg Braces 2 H Fabric Canopy 1 N Hanging Chains with

Lock Hooks 4

C Leg Cross Braces 2 I Canopy Upright

Supports 2 O Hammock Bed With

Attached Pillow 1

D Plastic Leg Joint

Protectors 4 J Canopy Frame End

Support Base 1 P Fabric Chain

Protectors 4

E Uprights 4 K Canopy Frame Sides 2

F Head end Stand

Support 1 L Canopy Frame End

Support Front 1

BEFORE ASSEMBLING

•Place all parts from box in a cleared area and position them on the ground or floor in front of

you.

•Remove all packaging materials from your area and place them back into the box.

•Do not dispose of the packing materials until assembly is complete.

•Read each step carefully before beginning.

•Item is heavy. Handle with care.

•Although assembly can be done with one person, a second person will make assembly easier.

•Make sure all lock-pins are completely inserted and engaged into the appropriate lock-pin

holes.

Estimated Assembly Time: 30 minutes

SECURING FOR SAFE USE

•After you have finished assembling the hammock, go back over the entire unit to make sure all

lock-pins are fully engaged and hardware is locked onto hammock stand. Repeat this

procedure prior to any use.

•Do not use the canopy in windy conditions. The wind could cause the canopy to blow off or

put excessive wear on the canopy attachments resulting in its failure. The hammock lounge

can be used without the canopy by removing the entire canopy frame from the head end stand

support.

ASSEMBLY INSTRUCTIONS

STEP 1

Locate the 4 plastic foot pieces (PartA), and place onto the ends of the 2 long leg braces (Part B)

Part A Part A

Part B

STEP 2

Place the completed leg sections across from each other with the side protrusions facing each

other. Locate the 2 leg cross braces(Part C) and insert each end into the side protrusions

located on Part B making sure the lock-pin aligns with the hole and become fully engaged

through the lock-pin hole.

Part B

Part C

Step 2 Completed

STEP 3

Locate the 4 plastic leg joint protectors (Part D). Place one on each of the upright protrusions on

leg brace (Part B) aligning the hole in Part D over the hole in the upright protrusion.

Part D

Part D in place

ASSEMBLY INSTRUCTIONS

STEP 4

Locate the 4 upright pieces (Part E). Place either end of part E into part B of the base, through the

plastic joint protector part D, making sure the lock pin on part E fully engages in the lock-pin hole.

Part E E

B Step 4 Completed

STEP 5

Locate the head end stand support (Part F). Choose either end of the base and slip Part F onto

the 2 part E uprights making sure the lock-pins fully engage the lock-pin holes.

Part F

STEP 6

Locate the foot end stand support (Part G). Slip part G onto opposite 2 uprights part E making

sure the lock-pins fully engage the lock-pin holes.

Part G

ASSEMBLY INSTRUCTIONS

STEP 6

Locate the fabric canopy (Part H). Unfold the canopy and locate the holes on the back end of

the canopy. Place the canopy onto the two upright protrusions of the head end stand support

by having the protrusion supports go through the two holes. Make sure the sewn in corner

pockets on the canopy face away from the frame. Allow the canopy to hang and go to next

step.

STEP 7

Locate the two canopy upright supports (Part I). Slip parts I onto the canopy protrusions on

the head end frame support (Part F) making sure the lock-pins fully engage into the lock-pin

holes.

STEP 8

Locate the canopy frame pieces Parts J, K, L, & M. Slip the canopy frame side supports (Part K) onto

both canopy frame ends (Part J & L) making sure the lock-pins fully engage into the lock pin holes.

Then place the canopy middle support (Part M) and hold it between the holes on the frame side

supports. Place the screw-knob through the side support into the end of the middle support.

Repeat this procedure on the opposite end of the middle canopy support.

Part H

Upright protrusion

Sewn in corner pocket

Part I

Canopy Upright

Supports in place

Part J

Part K

Part L

Part M

ASSEMBLY INSTRUCTIONS

STEP 11

Locate the 4 hanging chains with lock hooks (Part N). Also locate the hammock bed with attached

pillow (Part O). Hook one end of each chain to the steel attachment brackets on each end of the

hammock bed. Hook the other end of the chain to the welded attachment loops on the head and

foot end stand supports. Pillow end of the hammock should be hooked up under the canopy end

of the hammock. Adjust hook and chain to give the hammock bed a level and taught resting area.

Part N

STEP 12

Once the hanging chains are set where you want them, locate the 4 fabric chain protectors (Part

P). Wrap each chain protector over the hanging chain and secure with the hook and loop strip.

After this is complete, inspect all lock-pins and hooks to assure everything is in place. Enjoy!

Part P

I I

STEP 9

Place completed canopy frame onto the canopy uprights (Part I) by placing the frame protrusions

on the canopy base (Part J) making sure the lock-pins are fully engaged

STEP 10

Pull the fabric canopy up the canopy uprights and over the canopy frame. Attach the fabric canopy

to the canopy frame by tucking the sewn in pockets on the canopy over the canopy frame corners

Tabla de contenidos

Otros manuales de Hamaca de Algoma Net

Algoma Net

Algoma Net Soft Comfort Hoja de datos

Manuales populares de Hamaca de otras marcas

Costway

Costway Patiojoy NP10175 Manual de usuario

Astonica

Astonica 50104226 Manual de usuario

Texsport

Texsport La Paz 14258 Manual de usuario

Hatteras Hammocks

Hatteras Hammocks L-EKD Manual de usuario

Coopers of Stortford

Coopers of Stortford 10568 Manual de usuario

Texsport

Texsport Daydreamer 14265 Manual de usuario

Pimiento

Pimiento CrazyChair LAZY Manual de usuario

Exped

Exped Scout Manual de usuario

IKEA

IKEA GARO Manual de usuario

Costway

Costway OP70649 Manual de usuario

MyCoSiga

MyCoSiga MOON Manual de usuario

CMi

CMi 3280385 Manual de usuario

LIVARNO

LIVARNO 385209 2107 Manual de usuario

Marquee

Marquee 0215108 Manual de usuario

Bliss Hammocks

Bliss Hammocks BHC-412FR Manual de usuario

La Siesta

La Siesta Joki Manual de usuario

Exped

Exped TRAVEL HAMMOCK LITE KIT Manual de usuario

Kammok

Kammok Bobcat 45 Manual de usuario