Alcovisor Saturn Manual de usuario
MODEL: Saturn
Instruction Manual
(Use with Smartphone App)
TABLE OF CONTENTS
STRUCTURES ..................................................................................... 4
INSTRUMENT FEATURES ................................................................... 5
ICON DESCRIPTION ........................................................................... 6
TOUCH SCREEN CALIBRATION .......................................................... 6
INTRODUCTION ................................................................................ 7
OPERATING INSTRUCTIONS .............................................................. 8
P. 4
STRUCTURES
Operator needs to read operation manual and familiar with the
operation before using. Retain the manual for future reference.
P. 5
INSTRUMENT FEATURES
PLEASE REFER TO DIAGRAME ON PAGE 1
1. DISPOSABLE MOUTHPIECE
For sanitary reason, each mouthpiece is individually packed and sealed.
New mouthpiece should be attached to sample port for each test to prevent
any contamination from the previous sample.
2. SAMPLING CUP
Sampling Cup is reusable. Attach sampling cup to the sample port. Do not
touch the sampling cup with the mouth while providing a breath sample.
Remove the sampling cup after use and clean it for next use.
3. BUTTON TO REMOVE MOUTHPIECE
For sanitary reason, the mouthpiece can be removed by push the button on
the back of the device.
4. TOUCH SCREEN DISPLAY
A touch screen display that will display corresponding instructions and alcohol
concentration of the subject being test.
5. ON/OFF BUTTON
Press and hold the On/Off button to turn on or turn off the device.
6. BATTERY CHARGING
Rechargeable batteries can be used and charged inside the device. The
battery charging indicator turns red when charging, when the batteries are fully
charged, the indicator turns off.
7. EXTERNAL POWER CONNECTORS
Connectors for 12V car (cigarette) adapter or optional 12V power transformer.
Battery can be charged inside the device.
8. USB connector
Use an USB cable to upload test records stored in the memory and upgrade
the software.
P. 6
ICON DESCRIPTION
1 Time Indicator 7 Test
2 GPS Indicator 8 Test Records
3 Bluetooth Connection Indicator 9 Settings
4 Battery Indicator 10 Total Number of Tests
5 Weekday Indicator 11 Next Calibration Date
6 Date Indicator
TOUCH SCREEN CALIBRATION
If the touch screen is not sensitive enough, please calibrate the screen. Switch
off the device, press and hold the On/Off button (middle button) and then press
the left button immediately. Use a stylus pen and follow the instruction on the
screen to calibrate the screen.
P. 7
INTRODUCTION
It is a state of the art instrument used to detect Ethyl Alcohol from a valid breath
sample. It uses an electrochemical fuel cell to measure the concentration of
alcohol from the sample of the expired breath from a human subject. If alcohol
is present, a corresponding voltage is generated from the fuel cell, which is
proportional to the alcohol content of the sample provided by a human subject.
This voltage is then sent to the CPU and converted to a subject’s BAC which is
then displayed.
Instrument Features:
1. Test record storage is more than 16,000 entries depending on the length of
the records being stored. Capability of uploading test records for record
keeping.
2. Use disposable mouthpieces or sampling cups to prevent foreign matter from
entering.
3. A plastic case is included for storing the device and accessories for easy
transport. When not in use, the device and accessories should be stored in
this plastic case to prevent damage.
4. Ability to run as often as needed. Recovery time between tests on average
is 30 seconds between positive tests.
5. Powered by 4 AA alkaline batteries or rechargeable batteries. Batteries are
located behind the sliding cover on the back of the device. The level of power
left in the batteries is indicated on the screen. A cigarette plug adapter is also
included for use by the operator.
6. Rechargeable batteries can be used and charged inside the device. The
battery charging indicator turns red when charging, when the batteries are fully
charged, the indicator turns off.
7. Storage temperature range is -25°C to 70°C, storage humidity is 15% to 90%,
inappropriate storage of the device will shorten the lifespan of the fuel cell
sensor.
P. 8
OPERATING INSTRUCTIONS
Pre-test Conditions
1. Operating temperature range is -10°C to 50°C. Use within this temperature
range will limit condensation from a subject breath to insure an accurate
reading from a breath sample.
2. It is recommended that the operator to observe a subject for about 20 minutes
before administering the breath test to insure that nothing is consumed or
expelled from the mouth of the subject. Following this procedure will
eliminate reading from mouth alcohol.
Test
1. Attach a disposable mouthpiece onto the sample port.
2. Input information in touch screen.
NOTE: Maximum 16 characters for each input.
3. When displays “Please Blow”, take a deep breath and blow until BEEP tone
stops.
4. Test result displays on the display.
5. If printer is using, select “Print” to print the test result.
6. Select “Retest” to start another test.
7. If testee did not blow within 30 seconds, tester can select “Refuse” to confirm
the testee refused to do the test; or select “Test Again” to allow testee to do
the test again.
8. If testee failed to give a valid breath sample, tester can select “Discontinue”
to confirm; or select “Test Again” to allow testee to do the test again.
9. A passive test can be performed by select “Manual” during the testee is
blowing.
10. Push the mouthpiece removal button to remove the mouthpiece.
11. 16,000 test records can be stored, if memory limit is reached, new test is not
available. Send the device to service centre to upload test results to PC
and clear out all memories and use it again.
P. 9
Screening Test
1. To perform screening test, select “On” in the “Screening” option in “Setting”
2. Attach a sampling cup onto the sample port.
3. When displays “Please Blow”, take a deep breath and blow to the sampling
cup until BEEP tone stops.
4. “Alcohol Detected” or “No Alcohol” displays on the display.
5. A passive test can be performed by select “Manual” during the testee is
blowing.
6. Select “Retest” to start another test.
7. If “Alcohol Present”, use mouthpiece to perform a standard test to obtain an
accurate test result with reading.
NOTE: This mode is only used for screening purpose to check whether alcohol
is found in the breath sample. An accurate test result can only be obtained
by standard test.
NOTE: This mode is disabled when connecting to the mobile phone App.
Test with Smartphone App
1. The Android and IOS mobile APP “Alcovisor Elite” can be used with the
device, compatible with Android version 4.3+ and IOS 9.0+, and the internal
bluetooth module of the mobile is 4.0+
2. Switch on the device, and open the App “Alcovisor Elite”. Both Bluetooth
signal and connection signal is shown when it is successfully connected with
the App.
3. Once the device is connected with the App, the device will be controlled by the
App, all buttons on the screen will be disabled.
4. Attach a disposable mouthpiece onto the sample port.
5. Press “Tap to begin” on the mobile phone screen to start the test. The serial
number of the device will be shown on the device screen.
6. Face the mobile phone camera, make sure the face and serial number is
clearly shown on the mobile phone screen.
7. Take a deep breath and blow until BEEP tone stops.
8. Test result will be shown on both the device and the App.
P. 10
Android
iPhone
Icon Function
Show last test record
Back to home menu
Test record history
Settings
Disclaimer
Android
iPhone
Icon Function
Android: Listing Menu
iPhone: The menu is at the bottom
Disconnected
Connecting
Connected
Tap the middle of the icon to start a test.
Reminder: Manual test is not available when
test with the App.
There must be an interval of at least 15 minutes
after alcohol has been taken into the mouth.
Residues of alcohol in the mouth may give false
measurements.
Tabla de contenidos
Otros manuales de Equipo de prueba de Alcovisor
Alcovisor
Alcovisor BAC-100 Manual de usuario
Alcovisor
Alcovisor BAC-100 Manual de usuario
Alcovisor
Alcovisor Mercury Manual de usuario
Alcovisor
Alcovisor Jupiter Manual de usuario
Alcovisor
Alcovisor Jupiter Manual de usuario
Alcovisor
Alcovisor Alpha Manual de usuario
Alcovisor
Alcovisor Mercury Manual de usuario
Alcovisor
Alcovisor Satellite Manual de usuario
Alcovisor
Alcovisor Mark X Manual de usuario
Alcovisor
Alcovisor Beta Manual de usuario
Manuales populares de Equipo de prueba de otras marcas
SMART
SMART KANAAD SBT XTREME 3G Series Manual de usuario
Agilent Technologies
Agilent Technologies BERT Serial Manual de usuario
Agilent Technologies
Agilent Technologies N3280A Manual de usuario
Vernier
Vernier Go Direct Voltage Manual de usuario
Lifeloc
Lifeloc R.A.D.A.R. Manual de usuario
Fluke
Fluke T5-600 Instrucciones de funcionamiento e instalación
