Albatron KM7025 Manual de usuario

KM7025

All rights are reserved. No part of this publication may be reproduced, transmitted, transcribed,

stored in a retrieval system or translated into any language or computer language, in any form

or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise,

without the prior written permission of the company. Brands and product names are trademarks

or registered trademarks of their respective companies.

The vendor makes no representations or warranties with respect to the contents herein and

especially disclaim any implied warranties of merchantability or fitness for any purpose. Further

the vendor reserves the right to revise this publication and to make changes to the contents

herein without obligation to notify any party beforehand. Duplication of this publication, in part or

in whole, is not allowed without first obtaining the vendor’s approval in writing.

Trademark

All the trademarks or brands in this document are registered by their respective owner.

Disclaimer

We make no warranty of any kind with regard to the content of this user’s manual. The content

is subject to change without notice and we will not be responsible for any mistakes found in this

user’s manual. All the brand and product names are trademarks of their respective companies.

FCC Compliance Statement

This equipment has been tested and found to comply with the limits of a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in which case the user will

be required to correct the interference at his own expense. However, there is no guarantee that

interference will not occur in a particular installation.

CE Mark

The device is in accordance with 89/336 ECC-ENC Directive.

Ver: EG100

KM7025

nVIDIA®nForce 7025

Supports Socket AM2

AMD®AthlonTM 64 FX/ AthlonTM 64 x2 Dual-Core/

AthlonTM 64/ SempronTM Processor

User Manual

Dimensions (ATX Form-Factor):

210 mm x 244 mm ( W x L )

Operating System:

Windows®Vista/ XP/ 2000

Attention- Im

ortant Information

Follow the procedures below…

Troubleshooting Tips

Refer to other sections in this manual…

Things You Should Know

The images and pictures in this manual are for reference only and may vary from the

product you received depending on specific hardware models, third party

components and software versions.

This mainboard contains very delicate IC chips. Always use a grounded wrist strap

when working with the system.

Do not touch any IC chip, lead, connector or other components.

Always unplug the AC power when you install or remove any device on the mainboard

or when confuguring pins and switches.

Packing List

KM7025 mainboard

IDE Cable

I/O Bracket

Serial ATA Cable

Mainboard Setup Driver & User Manual CD

Mainboard Quick Installation Guide

Symbols

Table of Contents

CHAPTER 1. GETTING STARTED ..................................................................1

INTRODUCTION....................................................................................................... 1

SPECIFICATION ....................................................................................................... 2

CONFIGURATION .................................................................................................... 5

Layout of KM7025 .......................................................................................... 5

HARDWARE INSTALLATION ................................................................................... 6

CPU Processor Installation.............................................................................. 6

Memory Installation: DIMM1/2/3/4................................................................ 7

Back Panel Configuration................................................................................ 9

Connectors..................................................................................................... 11

Front Panel Headers: JW_FP, PWRLED, SPEAK ........................................ 11

Headers & Jumpers........................................................................................ 13

Audio Configuration...................................................................................... 15

Slots ............................................................................................................... 15

Power Supply Attachments............................................................................ 16

CHAPTER 2. BIOS SETUP............................................................................ 17

INTRODUCTION..................................................................................................... 17

KEY FUNCTION..................................................................................................... 17

MAIN MENU ......................................................................................................... 18

CHAPTER 3: SOFTWARE SETUP ............................................................... 20

SOFTWARE LIST ................................................................................................... 20

SOFTWARE INSTALLATION ................................................................................... 20

CHAPTER 4: TROUBLESHOOTING ............................................................ 24

APPENDIX I: 8/6/4/2 CHANNEL AUDIO EFFECT SETUP......................................... 27

APPENDIX II: RAID SETUP................................................................................... 28

Mainboard KM7025

Chapter 1. Getting Started

Introduction

Congratulations on choosing the KM7025 Mainboard. It is based on the nVIDIA®nForce 7025

chipset. The mainboard supports the AMD AthlonTM 64 FX/ AthlonTM 64 X2 Dual-Core/ AthlonTM

64/ SempronTM Processor with FSB (Front Side Bus) frequencies of 1000 MHz (2000 MT/s).

The KM7025 provides four DIMM (Dual In-Line Memory Modules) sockets and which with Dual

Channel Technology supported. The sockets allow you to install 240-pin, non-ECC &

unbuffered DDR II 800/ DDR II 667/ DDR II 533 SDRAM, and support a total memory capacity

of 8 GB.

This mainboard provides one PCI-E x16 slot for use with a graphics card. In addition, two

standard PCI slots for use with standard PCI expansion cards are also allowed.

The KM7025 provides one floppy disk drive connector that can be used with 360KB/ 720KB/

1.2MB/ 1.44MB/ 2.88MB drive. It also has one IDE connector for hard drives supporting two

Ultra ATA 133/100/66/33 IDE devices. In addition, the onboard Serial ATA II comes with four

SATA II connectors, which the interface can provide up to 3 Gb/s transmit speed and also

support RAID 0/ 1/ 5/ 0+1/ JBOD mode <See Appendix II>.

The onboard High Definition Audio CODEC (ALC883) supports 8/6/4/2 channel audio play

<See Appendix I>.

The KM7025 also comes with an onboard 10/100/1000 Mbps Ethernet LAN. There is one LAN

port on the back panel of your case that you can directly plug into an internet cable.

In addition, there are maximal ten USB2.0/ 1.1 ports which can be set up on this mainboard.

All the information (including hardware installation and software installation) in this manual are

for reference only. The contents in this manual may be updated without notice. The company

will not assume any responsibility for any errors or mistakes within.

Mainboard KM7025

Specification

CPU:

Supports Socket AM2

Supports AMD AthlonTM 64 FX/ AthlonTM 64 x2 Dual-Core/ AthlonTM 64/ SempronTM

Processor

Supports Hyper-TransportTM Link Technology

Supports 1000 MHz (2000MT/s) FSB (Front Side Bus) Frequencies

Chipset:

Chipset – nVIDIA®nForce 7025

I/O Controller – Fintek®F71882FG

High Definition Aduio Codec – Realtek®ALC883

Gbit LAN Controller – Realtek®RTL8111B 10/100/1000 LAN

Memory:

Four DIMM sockets with Dual Channel Technology supported

Supports a total memory capacity of 8 GB

Supports to use the 240-pin, non-ECC & unbuffered DDR II 800/ 667/ 533 SDRAM

Slots:

One PCI-Express x16 slot supports up to x16 mode with 4 GB/s one-way bandwidth

for one graphics card.

Two PCI slots with 133 MB/s one-way bandwidth per channel for expansion cards

FDD Connector:

One floppy disk drive connector supporting up to two FDDs

Supports 360KB/ 720KB/ 1.2MB/ 1.44MB/ 2.88MB

Onboard IDE Connector:

One IDE connector that support up to two IDE devices

Supports Ultra ATA 133/ 100/ 66/ 33

Supports high capacity hard disk drives

Mainboard KM7025

Serial ATA II Connector:

Four SATA II connectors that support up to four SATA II HDDs

Supports SATA 2.0 specification which provides 3 Gb/s transmit rate

Supports RAID 0/ 1/ 5/ 0+1/ JBOD mode

I/O facility Connectors:

Supports one PS/2 mouse port and one PS/2 keyboard port

Supports one VGA (=D-sub) port

Supports one DVI port

Supports one parallel port（PARALLEL）header and one serial port（COM1）header

with external devices connected

Universal Serial Bus:

Four onboard USB 2.0/ 1.1 ports

Three front USB headers come with this mainboard supporting six additional USB

ports to be set

Supports a maximum of ten USB 2.0/ 1.1 ports for compliant devices

Onboard HD Audio CODEC (ALC883):

High performance CODEC with high S/N ratio (>90 db)

Supports 8/6/4/2 channel playback capability

Supports jack sensing and re-tasking function

Built-in Dolby Digital Live Technology

Onboard LAN Chip:

Supports 10/100/1000 Mbps Ethernet LAN

BIOS:

Phoenix-Award™ BIOS

Supports APM 1.2

Supports ACPI 2.0 power management

Mainboard KM7025

Green Function:

Supports Phoenix-Award™ BIOS power management function

Supports system-wake-from-power-saving-mode by keyboard or mouse touching

Shadow RAM:

Integrated memory controller provides shadow RAM functionality and supports ROM

BIOS

Flash Memory:

Supports flash memory functionality

Supports ESCD functionality

Hardware Monitor Function:

Monitors CPU & System Fan Speed

Monitors CPU & System Temperature

Monitors CPU Voltage

Mainboard KM7025

Configuration

Layout of KM7025

Mainboard KM7025

Hardware Installation

This section will assist you in quickly installing your system hardware. Wear a wrist ground strap

before handling components. Electrostatic discharge may damage your system components.

CPU Processor Installation

This mainboard supports AMD AthlonTM 64 FX/ AthlonTM 64 x2 Dual-Core/ AthlonTM 64/

SempronTM processor and uses a Socket AM2. Before building your system, we suggest you

visit the AMD website and review the processor installation procedures. http://www.amd.com

CPU Socket AM2 Configuration Steps:

1. Locate the CPU socket on your mainboard and nudge the locking lever away from the

socket. Then lift the lever to a 90-degree angle.

2. On the socket, locate the corner which has the “diagonally cut-corner” on the rectangular

shaped pattern of pinholes (see diagram below-left). Match that corner with the “gold

triangle” on the CPU (see diagram below-right) and lower the CPU onto the socket. The

bottom of the CPU should be flush with the face of the socket.

3. Lower the lever until it snaps back into position. This will lock down the CPU.

4. Smear thermal grease on top of the CPU. Lower the CPU fan onto the CPU and use the

clasps on the fan to attach it to the socket. Finally, extend the power cable from the fan and

insert it onto the “CPUFAN” adapter.

ttention

DO NOT touch the CPU pins in case they are damaged. Also, make sure

that you have completed all installation steps before powered on the

system. Finally, double-check that the cooling fan is properly installed and

the CPU fan power cord is securely attached, in case your CPU and other

sensitive components are damaged because of high temperatures.

Tabla de contenidos

Otros manuales de Placa madre de Albatron

Albatron

Albatron K8X250GB PRO Manual de usuario

Albatron

Albatron PM915-478 Manual de usuario

Albatron

Albatron KM400T-8X Series Manual de usuario

Albatron

Albatron PX865PE PRO II Manual de usuario

Albatron

Albatron PMH55 Manual de usuario

Albatron

Albatron KM18G PRO Manual de usuario

Albatron

Albatron KX550 Manual de usuario

Albatron

Albatron K8X890 Series Manual de usuario

Albatron

Albatron K8Ultra-U Series Manual de usuario

Albatron

Albatron PXP965 (V2.0) Manual de usuario

Albatron

Albatron PI965GME Manual de usuario

Albatron

Albatron PI965GME-M Manual de usuario

Albatron

Albatron KM18G PRO Manual de usuario

Albatron

Albatron K8NF4 Series Manual de usuario

Albatron

Albatron kx600s Manual de usuario

Albatron

Albatron KX18D PRO II Manual de usuario

Albatron

Albatron PX845PEV-800 Instrucciones de uso

Albatron

Albatron KM400A series Manual de usuario

Albatron

Albatron KX520LE Manual de usuario

Albatron

Albatron P4M800-775 Manual de usuario

Albatron

Albatron PX915P Series Manual de usuario

Albatron

Albatron PX865PEL-800 Manual de usuario

Albatron

Albatron PXP35 Manual de usuario

Albatron

Albatron K8SLI Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario