Akai APRC90AT Manual de usuario
APRC90AT manual
Table of contents
1. Safety
o1.1. Intended use
o1.2. Labels in this manual
o1.3. General safety instructions
2. Preparations for use
o2.1. Unpacking
o2.2. Package contents
3. Installation
o3.1. Connecting to the mains
o3.2. Install batteries
4. Functions
o4.1. APRC90AT
5. Operation
o5.1. Quick start
o5.2. Radio functions
o5.3. CD functions
o5.4. USB functions
o5.5. AUX IN
o5.6. Auto Power System (APS)
6. Cleaning and maintenance
o6.1. Handle and care of a disc
7. Technical data
8. Disposal of used electrical and electronic equipment
1.Safety
1.1. Intended use
The device functions as a portable radio/CD audio player. The device can play music (MP3) via CD and USB. It is
also possible to play music via the AUX port.
Read the manual carefully before the first use.
1.2. Labels in this manual
WARNING A warning means that injury or death is possible if the instructions are not obeyed.
CAUTION A caution means that damage to the equipment is possible.
A note gives additional information, e.g. for a procedure.
1.3. General safety instructions
WARNING Do not put force on the appliance. The appliance can fall and can cause serious injury.
CAUTION Do not spill any liquid on the appliance.
WARNING Do not insert any objects in the ventilation holes.
CAUTION Do not block the ventilation holes.
This appliance is double insulated; therefore no earth wire is required. Always check that the mains voltage
corresponds to the voltage on the rating plate.
2.Preparations for use
2.1. Unpacking
Unpack the appliance carefully.
Check the package contents as described below. If any item is missing, please contact your reseller.
Remove the labels from the front panel carefully if present.
We recommend that you retain the original carton and packing materials in case it ever becomes necessary to
return your product for service. This is the only way to safely protect the product against damage in transit. If you
do dispose of the carton and the packing materials, please remember to recycle with due care to the environment.
2.2. Package contents
The following items are included in the received package:
1 x Quick start guide
1 x Mains cable
If any item is missing, please contact your reseller.
3.Installation
Put the appliance on a horizontal flat surface.
Connect the appliance to the mains.
CAUTION Do not put the appliance near a heat source.
CAUTION Do not expose the appliance to direct sunlight.
This appliance is equipped with rubber feet to prevent it from moving. The feet are made from non-migrating
material specially formulated to avoid leaving any marks or stains on furniture. However, certain types of furniture
polishes, wood preservatives or cleaning sprays cause the rubber to soften and leave marks or a residue on the
furniture, and potentially risk the surface to become damaged. To prevent damage to wooden surfaces, we
recommend that you apply self-adhesive pads to the bottom of the rubber feet before installation.
3.1. Connecting to the mains
Connect the 8-shaped connector of the power cable to the device's power connection.
Connect the mains plug to a wall socket.
3.2. Install batteries
The appliance can also be operated on battery power. For this purpose, the appliance uses six batteries (UM-1 /
D).
Please note: these batteries are not included.
Batteries are not necessary for normal operation.
If you do not use the appliance for an extended period, remove the batteries.
Install batteries
Remove the battery cover.
Insert the batteries matching the (+) and (-) polarity markings.
Re-install the battery cover.
CAUTION Incorrect installation can cause battery leakage and corrosion which will damage the appliance.
Corrosion, oxidation, battery leakage and any other gradually acidic defect of this nature will invalidate the
guarantee.
4.Functions
4.1. APRC90AT
1. FUNCTION switch (RADIO-CD/MP3-USB-AUX)
2. Headphone jack
3. USB slot
4. VOLUME dial
5. BASS button
6. CD compartment
7. POWER/STANDBY button
8. TUNING dial
9. AUX IN jack
10. BAND switch (AM/FM/FM ST.)
11. Display
12. 10+/FOLDER button
13. PREV button
14. STOP button
15. PLAY/PAUSE button
16. NEXT button
17. PROGRAM/REPEAT button
18. REPEAT iFM STEREO
19. REPEAT iSTANDBY
5.Operation
5.1. Quick start
General functions
To switch on the appliance, press the STANDBY button . To switch back to the standby mode, press the
STANDBY button again.
To select the source mode (RADIO-CD/MP3-USB-AUX), slide the FUNCTION switch ((1)) to the desired
position.
To adjust the volume level, turn the VOLUME dial (4) until the desired level is set.
To enable the enhanced bass, press the BASS button (5). Press the button again to disable the enhanced
bass.
Radio functions
To select the radio function, slide the FUNCTION switch (1) to the radio position.
Slide out the antenna
To adjust the frequency, turn the TUNING knob (8) until the desired frequency is reached.
For extended instructions, read the paragraph "Radio functions" further on in this manual.
CD functions
To select the CD function, slide the FUNCTION switch (1) to the CD position.
To insert a CD:
Press the CD compartment (6) to open the appliance
Insert the CD with the label upwards
Close the CD compartment
To start playback, press the PLAY/PAUSE button (15) once.
For extended instructions, read the paragraph "CD functions" further on in this manual.
USB functions
To select the USB function, slide the FUNCTION switch (1) to USB.
Insert the USB device in the slot (3). The device can only be connected one way.
To start playback, press the PLAY/PAUSE button (15) once.
For extended instructions, read the paragraph "USB functions" further on in this manual.
AUX IN jack
To use the AUX-IN port, slide the FUNCTION switch (1) to the position
To connect an external audio device, insert the cable plug in the AUX IN jack (2).
For extended instructions, read the paragraph "AUX INۥ" further on in this manual.
5.2. Radio functions
Slide out the antenna
To select the radio function, slide the FUNCTION switch (1) to the radio position.
Use the switch BAND (10) to switch between AM, FM and FM Stereo.
To adjust the frequency, turn the TUNING knob (8) until the desired frequency is reached.
The frequency is shown on the display
5.3. CD functions
To insert a CD:
Press the CD compartment (6) to open the appliance
Insert the CD with the label upwards
Close the CD compartment (6)
Playing a CD:
To select the CD function, slide the FUNCTION switch (1) to the CD position.
To start playback, press the PLAY/ PAUSE button (15) once.
During playback, the following functions are available:
To select a track, press the PREV button (13) or the NEXT button (16) until the desired track is set.
To search for a specific point on the disc, hold the PREV button (13) or the NEXT button (16) until the point
is reached and release the button.
To pause playback, press the PLAY/PAUSE button (15) once; to resume playback, press the button again.
To stop playback, press the STOP button (14).
Hold down the button 10+/F+ (12) to go to the following 10 numbers.
Press the button 10+/F+ (12) to select the next folder on an MP3 disc or a USB flash drive
Otros manuales para APRC90AT
1
Tabla de contenidos
Otros manuales de Sistema estéreo de Akai
Akai
Akai QX-D4300 Manual de usuario
Akai
Akai GX-266D Manual de usuario
Akai
Akai AHC1600 Manual de usuario
Akai
Akai AMN250UC Guía
Akai
Akai APRC60AT Manual de usuario
Akai
Akai AMD20 Manual de usuario
Akai
Akai AMD340 Manual de usuario
Akai
Akai AT-2650 Manual de usuario
Akai
Akai QX-3700DV Manual de usuario
Akai
Akai MPC 5000 Manual de usuario
Akai
Akai AMD60 Manual de usuario
Akai
Akai KHS888W1 Manual de usuario
Akai
Akai MPC Manual de usuario
Akai
Akai AMD60 Manual de usuario
Akai
Akai AMD350 Manual de usuario
Akai
Akai AX-M430 Manual de usuario
Akai
Akai CEU5000-BT Manual de usuario
Akai
Akai CEU5000-BT Manual de usuario
Akai
Akai AMC320 Manual de usuario
Akai
Akai QX-3700 Manual de usuario
