AIR SOURCE HEAT PUMP WATER HEATER
3
5
Status Inquiry
When shutdown remote control displays the current temperature When ture
on the unit Remote control displays the current temperature and set
temperature On the press or can check from
0-11 parameter. Under status quiry If for 5 seconds without key operation, the
automatic exit status query Interface, return to the main interface
Query and set parameters
Under standby status, press and hold and for 3 seconds it will
ring then will entering the required parameter setting interface and hold
or can set the parameter hold or for 3 seconds in the same
time it will ring then confirm the parameter.On the parameter settingsor query
interface if for 5 seconds without key operation,
On press SET”will enter the timing setting interface. In
and then press SET” the HOUR will twinkling
press ot can set the hour.After set the part of hour press
SET” the MINUTE will twinkling and press or can set the
minute.after set the minute press SET”again then can confirm the time and
return to the main interface
On the main interface Press enter timing setting interface: and press
ageain,that the number of hour(ture on the unit) will twinkling,and press
or that can set the hour to turn on the unit.then press it again, the
number of minute will twinkling.then press or then
, ,
,
；, “▲” “ ▼”,
，
；
,“▲”“▼”,
,“▲”
“▼” ; “▲” “▼”
,
，
，“；
，“， ，
“▲” “▼”，，
“， ， “▲”“▼”，
,“ , ,
；
；
，
“▲”
“▼”，
“▲” “▼”，
the main interface
the automatic exit status
query Interface, return to the main interface
the main interface
the timing setting interface
if for 5 seconds without key operation, the
automatic exit timing setting Interface, return to the main interface
；
Time Setting
Set turn on/off timing
set the minute
to turn on the unit. Press it again to set the timing of ture off the unit.After set the
timing,press it again to confirm the time, and return the main interface. On the
timing setting interface,if for 5 seconds without key operation, the automatic
exit timing setting Interface, return to the main interface；
2 2How to set operation paramrer.
