WSS6 Series - IOM
WSS6 SERIES – IOM (REV. A 4/21) 6
GENERAL INFORMATION
CAUTION
DO NOT use these units as a source of heating or
cooling during the construction process. Mechanical
components and filters can become clogged with dirt
and debris, which can cause damage to the system.
The manufacture does not warrant equipment
subjected to abuse. Construction debris can void
warranties and liability for equipment failure, personal
injury, and property damage.
WARNING
ELECTRIC SHOCK HAZARD
Before servicing equipment, ALWAYS turn off all power
to the unit. There may be more than one disconnect
switch. Electrical shock can cause injury or death.
Clear surrounding area of all tools, equipment, and
debris before operating this unit.
Unit must never be operated under any circumstances
without an air filter in place.
These instructions are given for the installation of the
WSS6 Water source heat pump specifically. For any
other related equipment, refer to the appropriate
manufacturer’s instructions.
NOTE
Material in this shipment has been inspected at the
factory and released to the transportation agency in
good condition. When received, a visual inspection of all
cartons should be made immediately. Any evidence of
rough handling or apparent damage should be noted on
the delivery receipt in the presence of the carrier’s
representative. If damage is found, a claim should be
immediately filed against the carrier.
These models are designed for indoor installation only.
Installation of this equipment, wiring, ducts, and any
related components must conform to current agency
codes, state laws, and local codes. Such regulations take
precedence over general instructions contained in this
manual.
CAUTION
Extreme caution must be taken that no internal damage
will result from screws that are drilled into the cabinet.
INTRODUCTION
The Hydrotech WSS6 model water to air heat pumps
provide the best combination of performance, efficiency
and reliability in a compact form factor. The heat pump
comes standard with ECM blowers for high efficiency
and comfort and features a removable condensing
section design to allow for easy servicing of the unit.
All WSS6 models are certified to AHRI ISO Standard
13256-1. The WSS6 models are designed to operate with
fluid temperatures between 50°F to 110°F in cooling
mode and 50°F to 90°F in heating mode for continuous
operation.
STORAGE
Equipment should be stored in a clean dry, conditioned
area with maximum temperatures up to 120°F and
minimum temperatures to 32°F. Units should be stored
upright and in an indoor environment. It is
recommended to leave packaging on the unit until the
installation is to begin.
CAUTION
Stacking of the WSS6 systems is strictly prohibitive.
Failure to do so may result in system and/or property
damage.
DO NOT use these units as a source of heating or cooling
during the construction process. Mechanical
components and filters could become clogged with dirt
and debris, which can cause damage to the system.
The manufacture does not warrant equipment subjected
to abuse. Construction debris can void warranties and
liability for equipment failure, personal injury, and
property damage.
