Advantech UTC-W101E Manual de usuario

User Manual

UTC-W101E

UTC-W101E User Manual ii

The documentation and the software included with this product are copyrighted 2009

by Advantech Co., Ltd. All rights are reserved. Advantech Co., Ltd. reserves the right

to make improvements in the products described in this manual at any time without

notice. No part of this manual may be reproduced, copied, translated or transmitted

in any form or by any means without the prior written permission of Advantech Co.,

Ltd. Information provided in this manual is intended to be accurate and reliable. How-

ever, Advantech Co., Ltd. assumes no responsibility for its use, nor for any infringe-

ments of the rights of third parties, which may result from its use.

Acknowledgements

Intel and Pentium are trademarks of Intel Corporation.

Microsoft Windows and MS-DOS are registered trademarks of Microsoft Corp.

All other product names or trademarks are properties of their respective owners.

Declaration of Conformity

FCC Class B

Note: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installa-

tion. This equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful inter-

ference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interfer-

ence to radio or television reception, which can be determined by turning the equip-

ment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

!Reorient or relocate the receiving antenna.

!Increase the separation between the equipment and receiver.

!Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

!Consult the dealer or an experienced radio/TV technician for help.

Part No. 2008W10110 Edition 1

Printed in Taiwan December 2009

Warning! Any changes or modifications made to the equipment which are not

expressly approved by the relevant standards authority could void your

authority to operate the equipment.

Caution! Danger of explosion if battery is incorrectly replaced. Replace only with

the same or equivalent type recommended by the manufacturer. Dis-

pose of used batteries according to the manufacturer’s instructions.

iii UTC-W101E User Manual

Technical Support and Assistance

1. Visit the Advantech web site at www.advantech.com/support where you can find

the latest information about the product.

2. Contact your distributor, sales representative, or Advantech's customer service

center for technical support if you need additional assistance. Please have the

following information ready before you call:

–Product name and serial number

–Description of your peripheral attachments

–Description of your software (operating system, version, application software,

etc.)

–A complete description of the problem

–The exact wording of any error messages

Warning! 1. Input voltage rated 12-19 VDC, 3.75 ~ 2.63 A (DC Mode).

2. Packing: please carry the unit with both hands, handle with care.

3. Maintenance: to properly maintain and clean the surfaces, use only

approved products or clean with a dry applicator.

UTC-W101E User Manual iv

Safety Instructions

1. Read these safety instructions carefully.

2. Keep this User Manual for later reference.

3. Disconnect this equipment from any AC outlet before cleaning. Use a damp

cloth. Do not use liquid or spray detergents for cleaning.

4. For plug-in equipment, the power outlet socket must be located near the equip-

ment and must be easily accessible.

5. Keep this equipment away from humidity.

6. Put this equipment on a reliable surface during installation. Dropping it or letting

it fall may cause damage.

7. The openings on the enclosure are for air convection. Protect the equipment

from overheating. DO NOT COVER THE OPENINGS.

8. Make sure the voltage of the power source is correct before connecting the

equipment to the power outlet.

9. Position the power cord so that people cannot step on it. Do not place anything

over the power cord.

10. All cautions and warnings on the equipment should be noted.

11. If the equipment is not used for a long time, disconnect it from the power source

to avoid damage by transient overvoltage.

12. Never pour any liquid into an opening. This may cause fire or electrical shock.

13. Never open the equipment. For safety reasons, the equipment should be

opened only by qualified service personnel.

14. If one of the following situations arises, get the equipment checked by service

personnel:

a. The power cord or plug is damaged.

b. Liquid has penetrated into the equipment.

c. The equipment has been exposed to moisture.

d. The equipment does not work well, or you cannot get it to work according to

the user's manual.

e. The equipment has been dropped and damaged.

f. The equipment has obvious signs of breakage.

15. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE

STORAGE TEMPERATURE MAY GO BELOW -20° C (-4° F) OR ABOVE 60° C

(140° F). THIS COULD DAMAGE THE EQUIPMENT. THE EQUIPMENT

SHOULD BE IN A CONTROLLED ENVIRONMENT.

16. If your computer is losing dramatic time or the BIOS configuration reset to

default, the battery has no power.

Caution! 1. Do not replace power adaptor yourself. Please contact a qualified

technician or your retail.

2. The computer is provided with a battery-powered real-time clock

circuit. There is a danger of explosion if battery is incorrectly

replaced. Replace only with same or equivalent type recom-

mended by the manufacture. Discard used batteries according to

the manufacturer’s instructions.

v UTC-W101E User Manual

17. CLASSIFICATION:

–Supply by Class I adapter

–No applied part

–Continuous Operation

–Not AP or APG category

18. Follow the national requirement to dispose unit.

19. Maintenance: to properly maintain and clean the surfaces, use only the

approved products or clean with a dry cloth.

20. Contact information:

No.1, Alley 20, Lane 26, Rueiguang Road Neihu District, Taipei, Taiwan 114,

R.O.C

TEL: (02)27927818

21.

22. This equipment shall not be used as a life support system.

23. Accessory equipment connected to the analog and digital interfaces must be in

compliance with the respective nationally harmonized IEC standards (i.e. IEC

60950 for data processing equipment, IEC 60065 for video equipment, IEC

61010-1 for laboratory equipment, and IEC 60601-1 for medical equipment.)

Furthermore all configurations shall comply with the system standard IEC

60601-1-1. Anyone who connects additional equipment to the signal input part

or signal output part is configuring a medical system, and is therefore, responsi-

ble that the system complies with the requirements of the system standard IEC

60601-1-1. The unit is for exclusive interconnection with IEC 60601-1 certified

equipment in the patient environment and IEC 60XXX certified equipment out-

side of the patient environment. If in doubt, consult the technical services

department or your local representative.

24. User not to connect SIP/SOPs and the patient at the same time.

25. The sound pressure level at the operator's position according to IEC 704-1:1982

is no more than 70dB (A).

DISCLAIMER: This set of instructions is given according to IEC 704-1. Advantech

disclaims all responsibility for the accuracy of any statements contained herein.

Note! Attention, consult ACCOMPANYING DOCUMENTS.

UTC-W101E User Manual vi

vii UTC-W101E User Manual

Contents

Chapter 1 Introduction..........................................1

1.1 Overview ................................................................................................... 2

1.2 System Configuration................................................................................ 3

Chapter 2 Hardware Description .........................5

2.1 General Specifications .............................................................................. 6

2.1.1 Standard PC Functions................................................................. 6

2.1.2 Power Environmental.................................................................... 6

2.2 Mechanical Specifications......................................................................... 7

2.2.1 Mechanical Specifications (Terminal) ........................................... 7

2.2.2 Mechanical Drawing for Button I/O ............................................... 7

2.3 Appearance............................................................................................... 8

Chapter 3 Design Requirements..........................9

3.1 Environmental Specifications .................................................................. 10

3.2 Reliability................................................................................................. 10

UTC-W101E User Manual viii

Chapter 1

1Introduction

This Chapter briefly introduces

the UTC-W101E product.

UTC-W101E User Manual 2

1.1 Overview

The UTC-W101E is an Intel® AtomTM based, fanless all-in-one PC. It has a 10.1",

wide format, resistive touch-based LCD panel. Not only is it cost effective, but it’s also

a versatile solution designed to meet the vast demand emerging from the market. Hot

keys on the bezel provide Instant access to functions; its simple and elegant indus-

trial design blends perfectly into eServices scenarios.

Tabla de contenidos

Otros manuales de Panel táctil de Advantech

Advantech

Advantech PPC-3100-RE9A Manual de instalación y operación

Advantech

Advantech ITA-8100 Manual de usuario

Advantech

Advantech TPC-1251T-Exxx Series Manual de usuario

Advantech

Advantech PPC-3150SW Manual de instalación y operación

Advantech

Advantech PPC-4151W Manual de usuario

Advantech

Advantech PPC-3150-XE4BE Manual de instalación y operación

Advantech

Advantech PPC-150T-RT Manual de usuario

Advantech

Advantech PPC-177T Manual de usuario

Advantech

Advantech IPPC-6172F Series Manual de usuario

Advantech

Advantech PPC-318W Manual de instalación y operación

Advantech

Advantech TPC-1550H Manual de usuario

Advantech

Advantech PPC-3150SW-PN4A Manual de usuario

Advantech

Advantech PPC-415W Manual de instalación y operación

Advantech

Advantech IPPC-6152A Manual de usuario

Advantech

Advantech POC-174 Manual de usuario

Advantech

Advantech TPC-1250H Manual de usuario

Advantech

Advantech PPC-3150 Manual de usuario

Advantech

Advantech PPC-105 Manual de usuario

Advantech

Advantech PPC-L61T Manual de usuario

Advantech

Advantech POC-W152 Manual de instrucciones

Advantech

Advantech PPC-153 Manual de usuario

Advantech

Advantech PPC-3150 Manual de usuario

Advantech

Advantech POC-128 Manual de instrucciones

Advantech

Advantech POC-621 Series Manual de usuario

Manuales populares de Panel táctil de otras marcas

FlowLine

FlowLine Data loop Manual de usuario

ALPEX

ALPEX AEx-8 P Series Manual de usuario

Ltech

Ltech E5S Manual de usuario

Harman

Harman AMX MODERO S MSD-701-L2 Manual de usuario

Acnodes

Acnodes PC 1150 Manual de usuario

AIS

AIS IP10IA99 series Manual de usuario

IBASE Technology

IBASE Technology ASTUT-152-RE1S Manual de usuario

YASKAWA

YASKAWA TP 610C Manual de usuario

B&R

B&R Power Panel C Series Manual de usuario

Beijer Electronics

Beijer Electronics X2 control Manual de usuario

AXIOMTEK

AXIOMTEK GOT321W-521 Manual de usuario

TRIDONIC.ATCO

TRIDONIC.ATCO x-touchBOX Manual de usuario

Qomo

Qomo QIT1386 Manual de usuario

DFI

DFI KS104-CD Manual de usuario

AMX

AMX AXP-PPC Guía

Sartorius

Sartorius X3 PR 5410 Manual de usuario

AMX

AMX Modero X Series Manual de usuario

B&R Industries

B&R Industries MAPPC900-ENG Manual de usuario