Advance acoustic PACEMAKER 17/20 Manual de usuario

1HIENNAiIONALHEA00UIRIER3, Phma^MN E5H74108

EUPOPE, GUnuisinl, Pontwiu q M(6(3lampqan CF7 L1Z W^Im, UnMeO K^qdan

CANA OA, t E95 GGUUawn Givw. Mistiuwpa Onlulo lA W tA9

61988, Advance Machine Company

Source: https://www.industrydocuments.ucsf.edu/docs/pzmx0000

INTRODUCTION

This manual has been prepared to help you get

the most from your PACEMAKER/MATADOR. Read

it thoroughly before operating the machine;

A SAFETY'- PRECAUTIONS

OWARNING

00 NOT USE THIS MACHINE IN AREAS. WHERE FLAMMABLE

LIQUIDS OR VAPORS ARE PRESENT.

^.._.

AWARNING

DISCONNECT POWER FROM-MACHINE BEFORE ATTEMPTING

ANY SERVIGE OR-MAINTENANCE WORK.

OWARNiNG

00 NOT EXPOSE TO RAIN.`STORE INDOORS.

NOTE:

For additional information, cautions and

warnings, read operator's manual before running

machine.

Source: https://www.industrydocuments.ucsf.edu/docs/pzmx0000

AWARNING

THIS MACHINE MUST BE PROPERLY GROUNDED TO PROTECT THE OPERATOR

FROM ELECTRICAL SHOCK. READ TEE SAFETY INSTRUCTIONS BELOW BEFORE

OPERATING THIS MACHINE.

115 or 120 VOLT MACHINES HAVE

THIS KIND OF 3 PRONG PLUG AT

THE END OF A 3 WIRE ELECTRICAL

CORD.

THE GROUNDING PIN•ON

THIS PLUG GROUNDS THE MACHINE

WHEN IT IS PLUGGED INTO A 3

PRONG OUTLET. .

A GROUNDING ADAPTER MUST BE

INSTALLED, AS SHOWN HERE^IF

ONLY 2 PRONG OUTLETS ARE

AVAILABLE.

THE OUTLET BOX

MUST BE GROUNDED AND THE

GROUNDING TAB (OR WIRE) ON THE

ADAPTER MUST BE INSTALLED

UNDER THE HEAD OF THE SCREW IN

THE CENTER OF THE OUTLET COVER.

GROUNDING ADAPTERS FOR 115 OR

120 VOLT PLUGS ARE AVAILABLE

AT MOST HARDWARE STORES.

NOTEt

GROUNDING ADAPTERS ARE NOT

APPROVED FOR USE IN CANADA. NOT.

240 VOLTMACHINESHAVE THIS!

<-TYP=:OF3PRONG PLUG, AT;-THB.

END OF

A3 NIRE ELSCTRICAL"'--

CORD. :;TH8,GROUNDINGPIR ON

2^0 YOLT

THISPL'UG GROUNDSrTBEMACBINE,,..

WHEN 'IT 13 PLUGGEO . INTO ^A 3

140 VOLT PLUGS. ..

(ROUND)

3 PRONG GROUNDED

OUTLET

".GROUNDED

OUTLET

BOX

ADAPTERS ARE NOT AVAILABLE FOR

GROUNDING PIN

REPLACE THE PLUG IF THE GROUNDING PIN IS DAMAGED OR BROKEN.

THE GREEN (OR GREEN AND YELLOW ) WIRE IN THE CORD IS THE GROUNDING

WIRE.

WHEN REPLACING A PLUG, THIS WIRE MUST BE ATTACHED TO THE

GROUNDING PIN ONLY.

EXTENSION CORDS CONNECTED TO THIS M1(CHINE SHOULD BE 12 GAUGE, 3

WIRE CORDS WITH 3 PRONG PLUGS AND OUTLETS. DO NOT,USE EXTENSION

CORDS MORE THAN 50 FT. (15 M) LONG.

Source: https://www.industrydocuments.ucsf.edu/docs/pzmx0000

PREPARING THE MACHINE FOR USE

Attaching the Scrub Brush or Pad Holder

oth the scrub brush

'pad holder are attached

in the same manner. Align lugs with correspond-

ing slots and turn brush or pad holder to lock

in place.

Electrical Cable

Unwrap cable aod plug into proper outlet as

covered in electrical section under warning and

cautions.

Source: https://www.industrydocuments.ucsf.edu/docs/pzmx0000

Spray Buff/Mister (optional)

chemical bottle (2 qts.) with appropriate

chemical.

Check nozzle on machine base for

clogs and ensure proper aiming of mist.

Pressurize bottle by pumping hand lever.

Source: https://www.industrydocuments.ucsf.edu/docs/pzmx0000

C7, -s

N r-.

m o 0

Source: https://www.industrydocuments.ucsf.edu/docs/pzmx0000

OPERATING THE PACEMAKER/MATADOR

With the machine prepared as covered in the pre-

vious section, you are ready to operate the

Pacemaker/Matador.

Handle positioner is located on handle at

operator's right.

Pull on lever to unlock

handle.

Adjust handle lever as required and

release lever.

Source: https://www.industrydocuments.ucsf.edu/docs/pzmx0000

With both hands- on machine', push handle lock

button with forefinger of left hand. Twist

grips forward to start motor.

Machine will move to the operators right and

left as the operating handle is raised and

lowered - Raise to go right - Lower to go

left.

AWARNING

Lateral,-movement* requires only slight raisirtg

.and loweringv-- exaggerated movement of handle

could cause lossof control.

OPERATING TIPS

Work. away from plug outlet to keep cord from

interfering with machine operation.

Source: https://www.industrydocuments.ucsf.edu/docs/pzmx0000

AFTER USING THE PACEMAKER/MATADOR

Flush spray buff system with warm water.

Remove pad holder or brush from machine for

separate storage. Never store machine with

pad holder or brush on machine.

Wash scrub brush and store separately.

Wrap cable around cord hooks.

Wipe entire machine with clean damp cloth -

wipe underside of brush'housing after wet

use..

Source: https://www.industrydocuments.ucsf.edu/docs/pzmx0000

Maintenance of PacemakerAatador .

AWARNING

Disconnect power from machine before attempting

any service or mainteance work.

Circuit Breaker (High Speed Matador) - Designed

to protect motor rom damage by overload condi-

tion.

Normally, trippi.ng of circuit breaker is

caused by one or more of the following condi-

tions:

- Loaded pad when spray cleaning, scrubbing or

polishing

- Excessive use of material when spray cleaning

- Too-aggressive,pad for operation

- Use of other than soft-touch brush for carpet

shampooing.

Too little; or absence of, solution when sham-

pooing or bonnet cleaning carpet

4: :

When cause of circuit breaker tripping is deter-

mined, remedy and re-set external button by push-

ing in to position where it doesn't return,

time_'for cooling and try`again.

NOTE:

Tf button does not stay pushed in, ailow

Source: https://www.industrydocuments.ucsf.edu/docs/pzmx0000

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Depurador de Advance acoustic

Advance acoustic

Advance acoustic SC250 Guía del usuario

Advance acoustic

Advance acoustic SC900 Manual de instrucciones

Advance acoustic

Advance acoustic Captor 4300 Manual de usuario

Advance acoustic

Advance acoustic SC450 Manual de usuario

Advance acoustic

Advance acoustic Micromatic 13E Manual de usuario

Advance acoustic

Advance acoustic Adinity 17ST Manual de usuario

Advance acoustic

Advance acoustic SC750 ST Manual de usuario

Advance acoustic

Advance acoustic Micromatic M17B Manual de usuario

Advance acoustic

Advance acoustic BA 5321 Manual de usuario

Advance acoustic

Advance acoustic SC450 Manual de usuario

Advance acoustic

Advance acoustic Condor XL 56110000 Manual de usuario

Advance acoustic

Advance acoustic SC6000 36C Manual de usuario

Advance acoustic

Advance acoustic Captor 4800B Manual de usuario

Advance acoustic

Advance acoustic 9084417010 Instrucciones de funcionamiento e instalación

Advance acoustic

Advance acoustic ADVANCE RS 501 Manual de usuario

Advance acoustic

Advance acoustic Adfinity 17ST Manual de usuario

Advance acoustic

Advance acoustic BA 5321 Manual de usuario

Advance acoustic

Advance acoustic Convertamatic 24D Manual de usuario

Advance acoustic

Advance acoustic SC6000 Instrucciones de instalación

Advance acoustic

Advance acoustic Warrior ST 56315036 Manual de usuario

Advance acoustic

Advance acoustic Warrior 28D Manual de usuario

Advance acoustic

Advance acoustic SC100 Manual de instrucciones

Advance acoustic

Advance acoustic SC100 Instrucciones de funcionamiento e instalación

Advance acoustic

Advance acoustic Warrior ST Manual de usuario

Manuales populares de Depurador de otras marcas

Olympus

Olympus M200H Manual de usuario

Clarke

Clarke BEXT 100H Manual de instalación y funcionamiento

JOHNY VAC

JOHNY VAC JVC70BCT Manual de usuario

RCm

RCm Elan Series Manual

Kärcher

Kärcher B 120 W Manual de usuario

Truvox

Truvox Orbis MotorScrubber 20 Manual de usuario

Numatic

Numatic TTB 4045/100 Manual de usuario

U.S. Products

U.S. Products PEX 500-C-TICK Instrucciones de funcionamiento

Mclennan

Mclennan C510 Manual de usuario

Tennant

Tennant T20 LPG Manual de usuario

Columbus

Columbus ARA 66 BM 100 Manual de usuario

Numatic

Numatic TTV 678G / 300T Manual de usuario

American-Lincoln

American-Lincoln 505-945 Manual de usuario

FIORENTINI

FIORENTINI ET 65-75 Manual de usuario

Floorpul

Floorpul ruby 48 blt Guía del usuario

Onyx

Onyx RX-34 Manual de usuario

Dustbane

Dustbane Hurricane 400 Manual de usuario

Sana

Sana EUJ-702 Manual de usuario