ADTRAN NetVanta E1/FE1 + G.703 Network Interface... Manual de usuario

NETVANTA E1 W/ G.703 DROP NETWORK INTERFACE MODULE (NIM) P/N 1200878L1

For more detailed documentation, visit us online at www.adtran.com

Quick Start Guide

SPECIFICATIONS

E1/FE1

Interface

Line Rate: 2.048 Mbps +/- 50 PPM

Line Code: AMI or HDB3

Framing: FAS with optional CRC-4

FE1 Line Rate: Timeslot, channelized

(in multiples of 64 kbps)

Receiver Sensitivity: -30 dB

Connector: RJ-48C

G.703

Interface

Line Interface: Per ITU-T G.703

Receiver Sensitivity:-30 dB

Line Rate: 2.048 Mbps, +/- 50 PPM

Capacity: 1 to 31 timeslots

If timeslot 16 signaling is used on the drop port, a

maximum of 15 timeslots can be mapped to router

(1-15 or 17-31).

Line Code: AMI or HDB3

Framing: FAS with Optional CRC-4

Connector: RJ-48C

Clock Source Network, internal, and through

Diagnostics Test pattern generation and detection

(QRSS, 511)

Network loopbacks

Alarm generation and detection

Network performance data (15 minutes and 24 hours)

WAN-E1 G.703 DBU

INSTALLATION INSTRUCTIONS

1. Remove power from the unit.

2. Slide the Network Interface Module (NIM) into the

option slot until the NIM is firmly seated against the

front of the chassis.

3. Secure the pins at both edges of the NIM.

4. Connect the cables to the associated device(s).

5. Complete the installation of the base unit.

6. Restore power to the unit.

WAN-E1 NETWORK (RJ-48C) CONNECTION PINOUT

Pin Name Description

1 R1 Receive data from the network

2 T1 Receive data from the network

3 — Unused

4 R Transmit data toward the network

5 T Transmit data toward the network

6-8 — Unused

G.703 (RJ-48C) CONNECTION PINOUT

Pin Name Description

1 R Transmit data toward the DTE

2 T Transmit data toward the DTE

3 — Unused

4 R1 Receive data from the DTE

5 T1 Receive data from the DTE

6-8 — Unused

NETVANTA E1 W/ G.703 DROP NETWORK INTERFACE MODULE (NIM) P/N 1200878L1

For more detailed documentation, visit us online at www.adtran.com

Quick Start Guide

DBU (RJ-48C) CONNECTION PINOUT

Pin Name Description

1-2 — Unused

3 R1 Network-Ring1

4 R Network-Ring

5 T Network-Tip

6T1Network-Tip1

7-8 — Unused

An optional Dial Backup Interface Module (DIM) is

required for dial backup applications.

E1/FE1 + G.703 NIM COMMANDS

clock source {line* | internal | through}

Configures the source timing used for the interface.

line* Recovers clock from the E1 circuit.

internal Provides clocking using the internal oscillator.

through Recovers clock from the circuit connected

to the G.703 interface.

coding {ami | hdb3}

Configures the line coding for the E1 or G.703 physical interface. This setting must

match the line coding supplied on the circuit by the service provider.

ami Alternate mark inversion

hdb3* High-density bipolar 3

description <text>

Comment line to provide an identifier for this interface (for example, circuit ID, contact

information, etc.).

framing {crc4}

Configures the framing format of the E1 interface.

crc4 CRC4 framing enabled

loopback network {line | payload}

Initiates a loopback on the interface toward the network. Deactivate using the

no loopback network command.

line Initiates a metallic loopback of the physical E1 network

interface.

payload Initiates a loopback of the E1 framer (CSU portion) of the

E1 network interface.

shutdown

Turns off the interface. The no version of this command turns the interface on and

allows it to pass data.

snmp trap {line-status | link-status}

Enables the unit interface to send SNMP traps when there is an interface status change.

tdm-group <group#> timeslots <1-24> speed [56 | 64]

Creates a group of contiguous DS0s on this interface to be used during the

cross-connect process.

<group#> Number label to identify this TDM group

<DS0 range> DS0s in this group in the form: <starting DS0 - ending

DS0>

test pattern {ones | zeros}

Initiates sending the specified test pattern.

ones Generate continuous ones

zeros Generate continuous zeros

test-pattern clear

Clears the test pattern error count.

test-pattern insert

Inserts an error into currently active test pattern.

* Indicates default values.

Tabla de contenidos

Otros manuales de Hardware de red de ADTRAN

ADTRAN

ADTRAN U-BR1TE Manual de usuario

ADTRAN

ADTRAN OSU 300 Manual de usuario

ADTRAN

ADTRAN eSBC Manual de usuario

ADTRAN

ADTRAN HD-10 BRI MUX Manual de instrucciones

ADTRAN

ADTRAN Total Access 1248 Manual de usuario

ADTRAN

ADTRAN QDFR Unit Manual de instrucciones

ADTRAN

ADTRAN DS3 NIU3 Manual de usuario

ADTRAN

ADTRAN Total Access 850 Manual de usuario

ADTRAN

ADTRAN TSU ESP Manual de usuario

ADTRAN

ADTRAN jobAid+ 1200482G1 Manual de usuario

ADTRAN

ADTRAN E1 Manual de usuario

ADTRAN

ADTRAN MX2820-48 VDC M13 MUX Manual de usuario

ADTRAN

ADTRAN SFP Manual de usuario

ADTRAN

ADTRAN DSU IV ESP Manual de usuario

ADTRAN

ADTRAN TRACER 4102 Guía del usuario

ADTRAN

ADTRAN Total Access 5006 Manual de usuario

ADTRAN

ADTRAN 4202023L1 Manual de usuario

ADTRAN

ADTRAN 850-VoDSL Manual de usuario

ADTRAN

ADTRAN DSU IQ Manual de usuario

ADTRAN

ADTRAN 1442703PG2 Manual de usuario

ADTRAN

ADTRAN NetVantaE1/FE1 Manual de usuario

ADTRAN

ADTRAN ISU 512 Manual de usuario

ADTRAN

ADTRAN TOTAL ACCESS 1200 Manual de usuario

ADTRAN

ADTRAN 3.125 Gigabit Ethernet Manual de usuario

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

D-Link

D-Link ShareCenter DNS-320L Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

D-Link

D-Link ShareCenter DNS-343 Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario