5) Throttle/Brake control
Push forward “finger dial of throttle” to control forward. Pull backward “finger dial of throttle” to control brake.
Make sure the finger dial of throttle is in neutal position before power on, or else it will affect the use experience. The screen
will remind to return throttle in neutral position if it is not when power on. Please operate as per instruction.
6) Switch direction of skateboard
In the state of forward, double click “Button B”, the remote control will short vibrate once(short vibrate for 100ms, the same
below), the direction icon changes to“Backward arrow”;
In the state of backward, double click “Button B”, the remote control will short vibrate once, the direction icon changes
to“Forward arrow”.
Note: This operation will be valid when the throttle trigger is in neutral position(zero throttle) and the speed is less than 3km/h.
9) Gear switch
Short press button B, the remote control switches to the next gear, with a short vibration. The gear icon will change accordingly.
Note: This operation will be valid when the throttle trigger is in neutral position(zero throttle).
11) Charging
①Charging remote control: When charging the remote control, it vibrates short. The remote control screen displays the charging
progress in real time in the form of flowing water light;
Note: It can not be operated when charging the remote control. It will automatically power off after unplug the charging wire and
short vibrate once.
②Charging battery of skateboard: When power off, the skateboard enters into charging state automatically if connects the charger.
The red indicator light is on. When power on, connect the charger to enter into charging state, the red indicator light is on, it will
automatically power off after unplug the charging wire.
Note: When in the state of charging, part of motor and ESC will stop working if the skateboard is not connected with remote
control, or does not accept operation instruction.
4：Malfunction warning instruction:
Battery voltage warning
If the battery of remote of control is less than 10%(It can be used for 30 minutes at most), the screen of remote control
indicates that the power is less than 10%, with a double long vibration. When the battery is only 5%(It can be used for 15
minutes). The remote control reminds the battery is less than 5% again, with a double long vibration. When the battery is
lower than safe voltage(3.4V) and connected with skateboard, if the skateboard stops, the remote control vibrates once and
powers off automatically.
When the battery of skateboard is lower than 25%, the screen of remote control indicates the battery is lower than 25%, with
a double long vibration. When the battery of skateboard is lower than 10%, the remote control will indicates the battery is
lower than 10%, with a double long vibration. When the voltage is lower than safe voltage, close power output, brake
immediately at this time.
Note: when the battery of remote control or skateboard starts to remind for the second time, you’d better stop using it and chare
related devices to avoid damage lithium battery due to over discharge.
Signal loss warning
When the signal is lost suddenly, the screen of the remote control indicates disconnection, with a short vibration. If the skateboard is
accelerating, first the acceleration will stop slowly, then brake slowly automatically. If the skateboard is not accelerating, it
will brkae slowly. If the signal is lost, the remote control will search the device of skateboard, if it succeeds in searching and
reconnecting, the remote control will short vibrate, the brake will be cancelled and return to normal operation.
Lock-up warning
When the motor is lock-up or completely struck, the remote control will short vibrate continuously and intermittently, the screen
of remote control indicates lock-up. If that happens, the user should stop running skateboard and check whether there is foreign
matter struck in it, clear the foreign matter and run it again.
