5
1. INTRODUCTION
The TS1258 Pressure Pot offers a convenient, easy to use system for dispensing
cyanoacrylates, as well as many solvents, lubricants and other low to medium viscosity materials
directly from the material container/bottle. Air pressure in the chamber forces the material from
the container/bottle through a disposable polyethylene supply tubing to an optional dispensing
valve. An air pressure regulator and pressure gauge control the material flow rate with the
dispense quantity being controlled by the length of time the dispense valve is open.
No cleaning operation is required after a dispensing, because there is no direct contact of
dispense material to the Pressure Pot and tube fittings. The polyethylene tubing may be discarded
after use.
To obtain maximum performance, read and follow these instructions carefully before
operating.
1.1 Receiving Inspection Procedure
For Receiving Inspection, proceed as follows:
1. Carefully remove pressure dispenser from shipping container and examine the items
contained in the carton. These will include the following:
a. Pressure Dispenser Assembly
b. Accessory Pack
2. Inspect the unit for any damage that may have occurred in transit.
3. If damage has occurred, notify the carrier at once.
4. Claims for damage must be made by the consignee to the carrier, and should be reported to
the manufacturer.
1.2 Features
•Compatible with UV cured adhesives with O-Ring Kit # TS1258EPR.
•Up to 100 psi operating pressure.
•Durable stain resistant finish.
•Disposable polyethylene tubing.
•Integrated on/off valve and controller available.
•Aluminum Reservoir for high pressure dispensing (100 psi).
•Relief Valve with pull ring to depressurize after dispense operation.
•One continuous tube for fluid dispensing from container to valve.
