(dbm)
Saturability
(dbm)
AN-UM100
SM-20
1310 -14-7 -34 -3
AN-UM100
SM-40
1310 -9-5 -38 -3
AN-UM100
SM-60
1310 -5-0 -38 -3
AN-UM100
SM-100
1550DFB -5-0 -38 -3
Main features
1. In conformity to IEEE 802.3 10 Base-T standard.
In conformity to IEEE 802.3u 100 Base-TX/FX standard.
2. Max. 2M buffer memory built in chip.
3. Back pressure flow control for full duplex IEEE802.3
Xand half duplex.
4. Automatic identification of MDI/MDI-X cross line.
5. High-performance1.4Gbps memory bandwidth.
6. In conformity to safety code of FCC and 15 CLASS A
and CE MARK.
Technical parameters:
1. Standard Protocol: IEEE802.3 10 Base-T standard
IEEE 802.3u 100Base-TX/FX
standard
2. Connector: one UTP RJ-45 connector, one SC/ST
connector
3. Operation mode: full duplex mode or half duplex mode
4. Power supply parameter: outside: 5V DC 1A
built-in:110-265VAC 48VDC
5. Environmental temperature: 0℃-60 ℃
6. Relative humidity: 5%-90%
8. TP cable: Cat5 UTP cable
9. Transfer fiber: multi-mode:
50/125, 62.5/125 or 100/140μm
single mode::
8.3/125, 8.7/125, 9/125 or 10/125μm
10 Dimensions: External power supply:
26mmx 71mm x 94mm
Built-in power supply: 40mm x 110mm x 140mm
Cautions:
1. This product is suitable for indoor application.
2. Put on the dust cover of fiber interface when not used.
3. It is forbidden to stare at the TX fiber-transfer end with
naked eyes.
4. Single optical fiber transceiver must be used in pair (See
the attachment description in delivery).
Trouble shooting:
1. Device is not matched. Please select the corresponding
network device according to the transfer rate of the product
(10Mbps or 100Mbps) when connected to other network
devices (network card, hub, switch).
2. Line loss is excessive during the fiber wiring. Excessive
loss in connector plug-in and fiber soldering welding, and
excessive intermediate nodes may cause excessive loss rate
or abnormal operation.
Fast Ethernet Optical Transceiver
User manual
(Do not use until you read this manual carefully)
http://www.ad-net.com.tw
