Doc Neos 1.1
NEOS 150 Folding User Manual | 6
ASSEMBLY INSTRUCTIONS
NEOS 150
Folding
The ALLEGRO range of patient lifting and transfer hoists are fully
asse bled, load tested and certified at the factory before being partially
dis antled for packing and shipping.
Use the instructions below as a guide to asse ble your
NEOS 150
Folding
hoist
.
1. Re ove lifter co ponents fro protective packing and lay out
on a s ooth surface to prevent da age to powder coating on
lifter sub asse blies.
2. Lift the ast asse bly and slide into ast holder receiving
socket on base chassis. Ensure the ast asse bly is
co pletely engaged in the ast socket. Insert the locating bolt
through the chassis and base and tighten the locking levers to
prevent ove ent between ast and base chassis.
3. Attach lift actuator to jib, by aligning actuator clevis with actuator
ount bracket. Insert bolt and tighten nylock nut.
4. Attach push handle asse bly with bolts supplied with handle
asse bly.
5. Attach battery by clipping battery pack on top of control box.
6. Plug the lift actuator cable into port 1 positioned on the
underside of the control box, ensuring it is driven fir ly ho e in
the socket.
7. Your
NEOS 150 Folding
hoist
uses a anual leg
adjust ent via a foot pedal. This leg adjuster does not need any
further asse bly.
8. Plug the handset lead into the large socket on underside of
control box. (See next diagra ) ensure align ent of tongue on
handset plug with groove in control box handset connection
port. When aligned press ho e fir ly. A s ear of Vaseline on
the o ring ay assist if plug is tight.
9. Check operation of lifter via handset, ensuring that the RED
EMERGENCY STOP BUTTON ON THE CONTROL BOX IS
RELEASED. Turn the knob quarter turn clockwise to release.
