Clock Menu
When Maestro is internally clocked, the
(clock) button enters a menu to change
clock settings. (high) is a manual reset for
the internal clock. (low) resets the internal
clock tempo to 120bpm. ( ) is a manual
tap tempo for the internal clock. ( )
increases and ( ) decreases the internal
clock tempo by 5bpm. Holding (slow)
while adjusting the tempo moves in 1bpm
increments. (random) sets the internal
clock to a random tempo between 60
and 180bpm. (mute) stops and starts
the internal clock. Pressing (clock) while
inside the clock menu will exit the menu.
Save/Load Menu
The (save) and (load) buttons enter the
save and load menus, respectively. Here,
the entire state of the module is stored in
one of 14 save slots represented by the
middle two rows of buttons. Save data is
stored on the included micro SD card,
and loaded into internal memory when
Maestro is powered on. This allows saves
to be recalled almost instantly and used
as a live performance tool without clock
sync issues. If specific channel buttons
are selected before or while inside the
save menu, data from a save slot will only
be saved or loaded for those channels.
Pressing (save) or (load) while inside the
save or load menu will exit the menu.
Chain Menu
The (chain) button enters the chain
menu, where multiple waveforms can
be chained together and assigned to a
channel to play back in sequence, either
at the channel’s timing setting or a
specific timing for one of the waveforms.
After entering the menu, waveforms are
selected in sequence - if a specific timing
is desired for one of the waveforms, it is
selected before the waveform. Once a
chain of waveforms has been entered, if
one or more channel buttons are selected
pressing (chain) will apply the chain to
those channels. If no channels are
selected, pressing (chain) will prompt
you to select channels. Select a channel
to apply the chain to, and press (chain) to
apply the chain and exit the menu.
maestro
reset I II III IV V VI
clock
mute
1/2
I II III IV V
triplet slow
smooth bipolar
VI
chain
clock
1/4 1/8 1/16
high low square random
1/32
save load
maestro
reset I II III IV V VI
clock
mute
1/2
I II III IV V
triplet slow
smooth bipolar
VI
chain
clock
1/4 1/8 1/16
high low square random
1/32
save load
maestro
reset I II III IV V VI
clock
mute
1/2
I II III IV V
triplet slow
smooth bipolar
VI
chain
clock
1/4 1/8 1/16
high low square random
1/32
save load
timing settings t = triplet s = slow
waveform examples
1/16
1/8
clock pulses
+ smooth + smooth random random + smooth
square chain
1/41/32
1/4t
1/2 1/2t 1/4s 1/4ts 1/8s 1/8ts 1/16s 1/16ts 1/32s
8 16 32 64 128
+ smooth + smooth
