Access Lighting 20351 Manual de usuario

CERTIFICATION: cULus WET NO. 20351

INSTALLATION INSTRUCTIONS

IMPORTANT

Before assembling your ACCESS LIGHTING fixture, please make

sure that you carefully read through this instruction sheet. Save this

instruction sheet and refer to it when additions to or changes in the

fixture configuration are made.

Enregistrer cette feuille d'instructions et de s'y référer lorsque les

ajouts ou changements dans la configuration de montage sont

faites

Consider having your fixture installed by a qualified licensed

electrician.

NOTE: The important safeguards and instructions that appear in

this manual are not meant to cover all possible conditions and

situations that may occur. It must be understood that common sense,

caution and care are factors that can’t be built into any product.

These factors must be supplied by the person(s) caring for and

operating the fixture

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to standard 4” x 2 ½” metal octagon outlet box. The box

must be directly supported by the building structure and U.L

Recognized

STEP-BY-STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off

the Circuit Breaker or by removing the fuse at the fuse box. Just

turning the light off at the light switch is not sufficient to prevent

electrical shock.

APPLICATION

Indoor Wall Spotlight

MODEL NO.

20351

COLLECTION

PREPARE FIXTURE

If there is an existing fixture remove it.

Expose the supply wires from the outlet

box. Screw the supplied crossbar to the

junction box using the supplied screws (1).

Gently pull the supply wires through the

center hole in the crossbar. Slide the fixture

wires through the hole in the back plate.

WHAT WE PROVIDE

Fixture Housing

Gasket

Back Plate

Crossbar

Cover

Mounting Hardware

1 x GU-10/35W

Bulbs

WHAT YOU NEED

Screwdriver

Wire Cutters

Wiring Supplies as

Specified by the

Electrical Code

Supply Wires from outlet box

Washers

IMPORTANT SAFETY INSTRUCTION

MESURES DE SECURITE A RESPECTURE

Consult a qualified electrician to ensure correct branch

circuit conductor.

Consulter un electricien qualifie pour vous assurer

que les conducteurs de la derivation sont adequats

This product must be installed in accordance with the

applicable installation code by a person familiar with

the contstruction and operation of the product and the

hazards involved.

Ce produit doit etre installe selon le code d’installation

pertinent, par une personne qui connait bien le produit

et son fonctionnement ainsi que les risques inherents

Do not install this fixture in hazardous locations.

N'installez pas cet appareil dans des emplacements

dangereux

Do not install fixture assembly closer than 6 inches from

any curtain or similar combustible material.

Laisser une distance d’au moins 6 pouces entre ce

luminaire et la toute surface combustible.

WARNING: Risk of Fire and Electric Shock

CAUTION: Risque d’ Incendie et de Choc Electriques

CERTIFICATION: cULus WET NO. 20351

CONNECT THE WIRES

Connect the black supply wire to the black fixture

wire. Secure with the supplied wire nuts. Connect

the white supply wires to the fixture wire. Secure

with the supplied wire nuts. Either wrap the outlet

box grounding (green) wire around the green

hexagonal screw provided on the mounting plate or

connect it to the supply ground wire provided with

the fixture. Secure all wires with U.L Certified

electrical tape (not supplied).

Tuck all wires carefully into the J-box.

MOUNT THE CANOPY

Since the application for this fixture is indoors, the

gaskets are not required and their use is optional.

Attach the back plate to the crossbar with the

supplied screws (3). Attach the fixture assembly to

the back plate by aligning the designated holes on

both the back plate and fixture assembly. Secure

with supplied screws (4).

Insert the supplied bulbs into the sockets.

Do not exceed the wattage stated on the warning label.

SECURE THE GLASS COVER

Fit the cover over the bulb and screw onto the

base to secure.

RESTORE THE ELECTRICITY AND

CHECK THE OPERATION OF

YOUR NEW ACCESS LIGHTING

FIXTURE

CAUTION

Please ensure that the fitting is cool and switched off

before replacing the bulb.DO NOT use bulbs that might

exceed the maximum wattage as stated on caution

label.

Otros manuales de Luz exterior de Access Lighting

Access Lighting

Access Lighting Bermuda Series Manual de usuario

Access Lighting

Access Lighting TRIDENT 20389LEDDMGLP Manual de usuario

Access Lighting

Access Lighting NAUTICUS 20290LEDDLP Manual de usuario

Access Lighting

Access Lighting Oslo 62580LEDDLP Manual de usuario

Access Lighting

Access Lighting Nostalgia 23766 Manual de usuario

Access Lighting

Access Lighting SLANT DLC 20786LED Manual de usuario

Access Lighting

Access Lighting 20370MG Instrucciones de instalación

Access Lighting

Access Lighting Nauticus 20294LEDDLP Manual de usuario

Access Lighting

Access Lighting SQUARE 20399LEDMG Manual de usuario

Access Lighting

Access Lighting 20043LEDDMG Manual de usuario

Manuales populares de Luz exterior de otras marcas

Sealey

Sealey LED37 Manual de usuario

nordlux

nordlux VEJERS Guía del usuario

SImx

SImx ELITE LED LHTC637 Manual de usuario

GEV

GEV CAROLINE 10833 Manual de usuario

NEBO

NEBO NEB-LSP-0020 Manual de usuario

WE-EF

WE-EF PFL540 LED Manual de usuario

Lindby

Lindby 9949029 Manual de usuario

HEPER

HEPER DOGO Side LW6048.585-US Instrucciones de instalación y funcionamiento

HEPER

HEPER LW8034.003-US Instrucciones de instalación y funcionamiento

Maretti

Maretti VIBE S 14.6080.04.A Manual de usuario

BEGA

BEGA 84 253 Manual

HEPER

HEPER MINIMO Instrucciones de instalación y funcionamiento

LIGMAN

LIGMAN BAMBOO 3 Manual de usuario

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manual de usuario

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manual de usuario

urban ambiance

urban ambiance UQL1273 Manual de usuario

TotalPond

TotalPond 52238 Manual de usuario

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manual de usuario