Abit WI-2P Manual de usuario

WI-2P

Dual Socket 604 Workstation Board

User’s Manual

4200-0303-22

Rev. 1.00

The information in this document is subject to change without notice and does not

represent a commitment on part of the vendor, who assumes no liability or

responsibility for any errors that may appear in this manual.

No warranty or representation, either expressed or implied, is made with respect to the

quality, accuracy or fitness for any particular part of this document. In no event shall

the manufacturer be liable for direct, indirect, special, incidental or consequential

damages arising from any defect or error in this manual or product.

Product names appearing in this manual are for identification purpose only and

trademarks and product names or brand names appearing in this document are

property of their respective owners.

This document contains materials protected under International Copyright Laws. All

rights reserved. No part of this manual may be reproduced, transmitted or transcribed

without the expressed written permission of the manufacturer and authors of this

manual.

WI-2P

Contents

Chapter 1. Introduction .................................................... 1-1

1.1. Features & Specifications....................................................... 1-1

1.2. Package Checklist................................................................... 1-3

1.3. Layout Diagram...................................................................... 1-4

Chapter 2. Hardware Setup.............................................. 2-1

2.1. Precautions ............................................................................. 2-1

2.2. Installing the Workstation Board ...........................................2-2

2.3. Install Xeon CPU and Heatsink ............................................. 2-3

2.4. System Memory ..................................................................... 2-4

2.4.1. Memory Configuration Table................................... 2-4

2.4.2. Installing and Removing Memory Modules............. 2-4

2.5. Connectors, Headers, and Switches .......................................2-6

2.5.1. ATXPWR1, ATX12V1: EPS12V Power Connectors

.................................................................................. 2-6

2.5.2. FAN1~6: FAN Connectors....................................... 2-7

2.5.3. CCMOS1: CMOS Memory Clearing Header........... 2-8

2.5.4. FPIO1: Front Panel Switches and Indicators Header

.................................................................................. 2-9

2.5.5. FDC1, IDE0/IDE1 Connectors:.............................. 2-10

2.5.6. PCI1 ~ PCI5: PCI Card Slots: ................................2-11

2.5.7. 6CHAUD1: 5.1-Channel Audio Interface Header . 2-12

2.5.8. USB1/USB3: Additional USB Ports Headers ........ 2-13

2.5.9. CD1, AUX1: Internal Audio Connector................. 2-14

2.5.10. IR1: Infrared Device Header .................................. 2-15

2.5.11. Back Panel Connectors:.......................................... 2-16

2.5.12. J4: RAID Card Connector ......................................2-17

2.5.13. JP4: Terminator/Raptor II RAID Card Selector..... 2-18

2.5.14. SCSI1/SCSI2: Ultra 320 SCSI Channels Connector

................................................................................ 2-19

User’s Manual

Chapter 3. BIOS Setup...................................................... 3-1

3.1. Main Menu ............................................................................. 3-2

3.2. Advanced Menu ..................................................................... 3-6

3.2.1. Advanced BIOS Features ......................................... 3-6

3.2.2. Advanced Chipset Features ...................................... 3-9

3.2.3. Integrated Peripherals ............................................. 3-11

3.2.4. Power Management Setup ...................................... 3-16

3.2.5. PnP/PCI Configurations.......................................... 3-20

3.3. Security Menu ...................................................................... 3-22

3.4. PC Health Menu ................................................................... 3-23

3.5. Clk/Misc. Menu.................................................................... 3-25

3.6. Exit Menu ............................................................................. 3-26

Chapter 4. Driver Installation .......................................... 4-1

4.1. Setup Items ............................................................................. 4-2

4.2. Installing Ultra320 SCSI Controller....................................... 4-3

4.2.1. Installing Windows 2000 with an Ultra320 SCSI

Controller .................................................................. 4-3

4.2.2. Installing the Driver when Windows 2000 is Already

Installed..................................................................... 4-3

4.2.3. Changing SCSI Boot Controllers in Windows 2000

.................................................................................. 4-4

Appendix A. Trouble Shooting ........................................... A-1

Appendix B. How to Get Technical Support ..................... B-1

WI-2P

Introduction 1-1

Chapter 1. Introduction

1.1. Features & Specifications

CPU

• Supports Dual IntelXeon processor (603-pin or 604-pin)

Chipset

• IntelE7505 chipset supports 400MHz/533MHz Front Side Bus

• Intel82801DB (ICH4) supports PCI 2.2, Ultra DMA100 IDE

protocol

• Intel82870P2 (P64H2) supports PCI-X 66/100MHz

Memory

• Six 184-pin DIMM sockets support DDR200/DDR266 RAM module

• Supports up to 12GB (Registered ECC)

• Supports up to 8GB (Unbuffered, Non ECC)

LAN

• Onboard Intel 82545EM (Kenai-64) Gigabit Ethernet Controller

• 10/100/1000 Mb Ethernet

Graphics

• AGP8x/4x AGP Pro

SCSI

• Adaptec AIC-7902, Dual channel Ultra 320 controller on board.

• Support Adaptec SCSI RAID card - 2015S (Raptor II) or “Terminator”

System BIOS

• AWARD Plug and Play BIOS supports APM, DMI, and ACPI

• Write-Protect Anti-Virus function by AWARD BIOS

• 4M-bit Flash ROM

I/O Slot

• 2 PCI 33MHz/32bit PCI slots

• 1 PCI-X 100MHz/64bit slot

User’s Manual

1-2 Chapter 1

• 2 PCI-X 100MHz/64bit slots (JP4 pin-1 and pin-2 shorted for Adaptec

Terminator RAID card -- Default)

or 2 PCI 66MHz/64bit (JP4 pin-2 and pin-3 shorted Adaptec Raptor II

RAID card)

• 1 AGP Pro slot

Multi I/O Functions

• 1 floppy port

• 2 channels of bus master IDE ports supporting up to four Ultra

DMA100 devices

• 1 parallel port, 2 serial ports and 1 game port

• PS/2 keyboard and PS/2 mouse connectors

• Support 6 USB ports

• Support AC97, 5.1Channel (Option)

• Support S/PDIF (Option)

Miscellaneous

• 24-pin and 8-pin EPS 12V power connectors

• Extend ATX form factor (12” x 13”)

 Specifications and information contained herein are subject to change

without notice.

WI-2P

Introduction 1-3

1.2. Package Checklist

 (1) WI-2P Workstation board

 (1) Brief Installation Guide

 (1) Driver & Utilities CD

 (1) Ribbon cable for (1) 3.5” floppy disk drive

 (2) Ribbon cables for master and slave IDE drives

 (1) 68-pin LVD/SE SCSI cable with terminator for 5 Ultra 320 SCSI devices

 (2) CPU Retention Mechanism

 (2) Retention Clips for 603-pin CPU

 (2) Retention Clips for 604-pin CPU

 (1) I/O Shield

 (1) 2-port USB 2.0 cable

User’s Manual

1-4 Chapter 1

1.3. Layout Diagram

WI-2P

Introduction 1-5

Jumpers Description Default Setting

CCMOS1 CMOS Clear Pins 1-2 Closed (Normal)

JP4 RAID Card Selector

(Terminator/Raptor II)

Pins 1-2 Closed

(“Terminator” RAID Card)

Connectors Description

6CHAUD1 Optional ABIT CA-20 Interface Connector

AGP1 Slot for AGP8x/4x AGP Pro Display Card

ATX12V1 8-pin EPS12V Power Connector

ATXPWR1 24-pin EPS12V Power Connector

CD1/AUX1 Internal Audio Sources Connectors

DIMM 0~5 DDR DIMM Slots

FAN1 CPU1 Fan Connector (Speed monitoring support)

FAN2 CPU2 Fan Connector (Speed monitoring support)

FAN3 System Fan Connector (Speed monitoring support)

FAN4/5/6 System Fan Connector (No speed monitoring support in BIOS

menu)

FDC1 Floppy Disk Drive Connector

FPIO1 Front Panel Switches & Indicators Headers

IDE0/IDE1 Hard Disk Drive Connectors

IR1 Optional Infrared Devices Connector

J4 Adaptec Zero Channel RAID Card Connector

JP3 Chassis Intrusion Header

PCI1/2 PCI 33MHz/32bit

PCI3 PCI-X 100MHz/64bit

PCI4/PCI5 PCI-X 100MHz/64bit (JP4 pin1-2 shorted)

or PCI 66MHz/64bit (JP4 pin2-3 shorted)

SCSI1 Ultra 320 SCSI Channel A Connector

SCSI2 Ultra 320 SCSI Channel B Connector

SMB1 System Management Bus (SMBus) Header

USB1/USB3 Additional USB Ports Connectors

User’s Manual

1-6 Chapter 1

WI-2P

Tabla de contenidos

Otros manuales de Placa madre de Abit

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario