6
$
•
Once the mounting, plumbing, power connection and water filling i done, then only
the power upply hould be given. The tep need to be followed a per the u er
guide.
Thi water heater i heavy , hence will require at lea t 2 per on to carry and in tall,
otherwi e it may cau e injury .
Di a embly and a embly by u er i prohibited.
Thi water heater hould be in talled at a location that i clo e to power ocket, floor drain and
water utili ation point. A the outlet of the relief valve might di charge water during the
operation of the water heater , therefore the floor drain hould be provided near the water
heater . In the in tallation area, it hould be en ured that the water leakage of the water heater
or pipeline joint hould not cau e damage to the article in adjacent region or lower layer of
the building. While in talling the water heater, plea e be ure for mounting the water inlet and
outlet pipe at the bottom of the water heater.
Vertical in tallation of the water heater i trictly prohibited.
$ Hot water over 50°C will cau e cald. In order to protect you and your family,
e pecially the afety of children, if you et the temperature exceeding 50°C, plea e
take care.
The in talling urface mu t be capable of upporting at lea t four time the weight of the water
heater when filled with water. If the water heater i not in talled on the bearing wall or i
mounted on hollow brick wall, corre ponding protective mea ure mu t be provided, for
example upporting rack, through-wall crew, mounting of back plate, etc.
Prior to confirming the po ition of bolt hole , retain at lea t 300 mm pace on the right ide of
the water heater , to open the ide cover for repair .
If the water heater i embedded into a gu et plate, the plate on the right ide hould be
moveable for convenience to di mantle the end cover for repair and maintenance.
The water heater hould not be located outdoor or in an area ubjected to freezing.
environment. If freezing occur , the container and water pipe will break, cau ing cald or
leakage.
$
Thi water heater hould be in talled with the fixing acce orie provided.
The water heater hould be hung until the acce orie are fixed firmly or el e the heater may
fall off and eriou injury accident might be cau ed.
For the Unit with maximum rated power 1200W, hence a ingle dedicated power upply circuit
i propo ed, the core area of electric upply wire hould not be le than 1.5 mm .
2
For the Unit with maximum rated power 3000W, hence a ingle dedicated power upply circuit
i propo ed, the core area of electric upply wire hould not be le than 2.5 mm .
2
