3Com AccessBuilder 4000 Manual de usuario
®
A
CCESS
B
UILDER
4000
I
NSTALLATION
G
UIDE
Part No.09-0753-001
Published June 1996
3Com Corporation
■
5400 Bayfront Plaza
■
Santa Clara,California
■
95052-8145
3Com Corporation,1995.All rights reserved.No part of this documentation may be reproduced in any form or by any means or used to make
any derivative work (such as translation,transformation,or adaptation) without permission from 3Com Corporation.
3Com Corporation reserves the right to revise this documentation and to make changes in content from time to time without obligation on the
part of 3Com Corporation to provide notification of such revision or change.
3Com Corporation provides this documentation without warranty of any kind,either implied or expressed,including,but not limited to,the
implied warranties of merchantability and fitness for a particular purpose.3Com may make improvements or changes in the product(s) and/or
the program(s) described in this documentation at any time.
UNITED STATES GOVERNMENT LEGENDS:
If you are a United States government agency, then this documentation and the software described herein are provided to you subject to the
following restricted rights:
For units of the Department of Defense:
Restricted Rights Legend:
Use,duplication or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) (1) (ii) for
restricted Rights in Technical Data and Computer Software clause at 48 C.F.R.52.227-7013.3Com Corporation, 5400 Bayfront Plaza,Santa Clara,
California 95052-8145.
For civilian agencies:
Restricted Rights Legend:
Use,reproduction or disclosure is subject to restrictions set forth in subparagraph (a) through (d) of the Commercial
Computer Software - Restricted Rights Clause at 48 C.F.R.52.227-19 and the limitations set forth in 3Com Corporation’s standard commercial
agreement for the software.Unpublished rights reserved under the copyright laws of the United States.
Unless otherwise indicated,3Com registered trademarks are registered in the United States and may or may not be registered in other countries.
CompuServe is a registered trademark of CompuServe,Inc.
3Com, Boundary Routing, CardFacts, LanScanner, LinkBuilder, NETBuilder, NETBuilder II, NetFacts, Parallel Tasking,ViewBuilder, EtherDisk,
EtherLink, EtherLink Plus, EtherLink II,TokenLink,TokenLink Plus, and TokenDisk, are registered trademarks of 3Com Corporation. 3TECH,
AccessBuilder, CacheCard, FDDILink, FMS, NetProbe, SmartAgent, Star-Tek, SuperStack, and Transcend are trademarks of 3Com Corporation.
3ComFacts,Ask3Com,and CardBoard are service marks of 3Com Corporation.
Other brand and product names may be registered trademarks or trademarks of their respective holders.
Guide written and produced by Gary Halverson.Technical illustration by Chris Beatrice.
A
BOUT
T
HIS
G
UIDE
Introduction
This guide describes how to install the AccessBuilder 4000.It will also tell
you what information you need to obtain in order to prepare for installation,
how to perform the hardware installation,and how to install theTranscend
AccessBuilder Manager (TABM) configuration utility.Once you have installed
TABM,you will then configure your AccessBuilder using the on-line help
information available withinTABM.
If the information in the Release Notes shipped with your product differs
from the information in this guide,follow the Release Notes.
How to Use This
Guide
The following table shows where to find specific information.
If you are looking for: Turn to:
An overview of the AccessBuilder 4000 Chapter1
Unpacking the AccessBuilder 4000 Chapter2
An overview of the installation process Chapter2
Electrical installation Chapter2
Installing Transcend AccessBuilder Manager Chapter3
An overview of Transcend AccessBuilder Manager Chapter3
Troubleshooting the installation Chapter4
AccessBuilder 4000 specifications AppendixA
Software updating procedures AppendixB
Installing I/O Cards AppendixC
Configuration Worksheets AppendixD
Technical support information AppendixE
iv
A
BOUT
T
HIS
G
UIDE
Conventions
The following tables list conventions that are used throughout this guide.
Related
Documentation
The following additional AccessBuilder documentation may be of value to
the system administrator and is available through your normal 3Com
ordering channel:
■
AccessBuilder Remote Client Quick Installation Guide (09-0752-000)
■
AccessBuilder Server Configuration Guide (09-0751-000,optional) contains
information about configuring the server using the command line interface.
■
AccessBuilder Server Administrator’s Guide ((09-0750-000,optional) provides
detailed information about all AccessBuilder command line menus,
individual commands,parameters,and examples of specific configurations.
Table1
Text Conventions
Convention Description
“Enter” vs. “Type” When the word “enter” is used in this guide, it means type your
input, then press the Return or Enter key. Do not press the
Return or Enter key when an instruction simply says “type.”
Keys When specific keys are referred
to in the text, they are called out
by their labels, such as “the Return key” or “the Escape key,” or
they may be shown as [Return] or [Esc].
If two or more keys are to be pressed simultaneously, the keys
are linked with a plus sign (+), for example:
Press [Ctrl]+[Alt]+[Del].
Italics Italics
are used to denote
new terms
or
emphasis
.
Table2
Notice Icons
Icon Type Description
Information Note Information notes call attention to important features or
instructions.
Caution Cautions contain directions that you must follow to avoid
immediate system damage or loss of data.
Warning Warnings contain directions that you must follow for
your personal safety. Follow all instructions carefully.
C
ONTENTS
A
BOUT
T
HIS
G
UIDE
Introduction iii
How to Use This Guide iii
Conventions iv
Related Documentation iv
1
I
NTRODUCTION
General 1–1
Configuration 1–2
System Description 1–3
Hardware Description 1–4
Front Panel 1–4
Rear Panel 1–4
Main Processor and I/O Card Slots 1–4
Power Supply 1–6
Power Switch and Receptacle 1–6
Flash Memory 1–6
Console Port 1–6
2
G
ETTING
S
TARTED
AccessBuilder Configuration: Windows or Command Line UI 2–1
Preparation 2–2
Modems/ISDN TAs 2–3
User List 2–4
Network Basics 2–4
AccessBuilder Management 2–5
Unpacking the System 2–5
Hardware Installation 2–6
Stand Alone 2–7
Rack Mounting 2–7
LAN Connection (Mandatory) 2–7
Ethernet 2–7
Token Ring 2–9
Power Up 2–9
Console/Modem Configuration (Optional) 2–10
For Terminal Connection 2–10
For Modem Connection 2–11
(Remote AccessBuilder Management Only) 2–11
Telnet Users 2–11
SNMP Management 2–11
3
C
ONFIGURATION
U
SING
T
RANSCEND
A
CCESS
B
UILDER
M
ANAGER
(TABM)
General 3–1
System Requirements 3–2
Hardware 3–2
Software 3–2
IP Networks 3–2
IPX Networks 3–3
TABM Software Installation 3–3
About the TABM Application 3–9
Autodiscovery 3–9
IP Networks 3–9
IPX Networks 3–9
Main Window (All Servers List View) 3–10
AccessBuilder Server External View 3–10
Tool Bar Icons 3–11
Copy Server Configuration 3–11
Verify Configuration 3–11
Download/Upload File 3–12
System Configuration Parameters 3–12
Protocols 3–12
Modem Scripts 3–12
Async Ports 3–12
Remote Users 3–12
SNMP 3–12
Conventions 3–12
Port Color Conventions 3–12
@ Symbol 3–13
Starting the TABM Application 3–13
Starting Up a New AccessBuilder Server 3–14
IP Networks 3–14
IPX Networks 3–14
What’s Next? 3–14
Basic Configuration 3–15
Configuring an AccessBuilder Using Guided Configuration 3–16
Remote Client Configuration 3–16
AppleTalk Clients 3–16
PPP/SLIP Clients 3–17
PC Clients 3–17
4
T
ROUBLESHOOTING
System Does Not Power On 4–1
TABM Not Communicating with an AccessBuilder 4–1
IP Networks 4–2
IPX Networks 4–2
Attached Terminal or Modem Does Not Operate 4–3
System Does Not Respond to Terminal Commands 4–3
LED Functions 4–4
Error Messages 4–4
A
S
PECIFICATIONS
Hardware Specifications A–1
Approvals A–1
NOS Support A–3
Internet Protocol Support A–4
B
R
EMOTE
S
OFTWARE
U
P
/D
OWNLOADING
P
ROCEDURES
Getting Started B–1
TABM B–2
TABM Procedures B–2
What To Do If An Image Download Fails B–3
Telnet B–4
Telnet Procedures B–4
B–5
Console Port B–5
Local PC B–6
Initial Setup B–7
General B–7
PC Terminal Emulator Setup B–7
Console Port Procedures B–8
AccessBuilder 4000 Software Image Download Procedure B–8
C
I
NSTALLING
I/O C
ARDS
Descriptions of I/O Cards C–1
Asynchronous I/O Cards C–1
Synchronous I/O Card C–2
ISDN Cards C–3
Installation Overview C–4
Installation Procedure C–4
Attaching I/O Cables C–7
Asynchronous Cards C–7
Synchronous Card C–7
ISDN Card C–9
D
C
ONFIGURATION
W
ORKSHEETS
Instructions D–1
TABM Workstation Worksheets D–1
AccessBuilder Server Worksheets D–1
AccessBuilder Client Worksheets D–1
TABM Workstation D–2
TABM Workstation on IP Network D–2
TABM Workstation on IPX Network D–3
AccessBuilder Server D–4
General Information D–4
ISDN Information D–5
IP Network Information D–6
IPX Network Information D–6
AppleTalk Network Information D–6
User Table D–7
Remote Client (Version 5.1) D–8
Equipment Types D–8
Version 6.0 Screens D–10
E
T
ECHNICAL
S
UPPORT
L
IMITED
W
ARRANTY
Otros manuales para AccessBuilder 4000
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Servidor de 3Com
