• ReadyourOwner’sManualthoroughlybeforeusingtheinversiontable.
• Test thetableforsmoothand steady rotationbeforeinverting.
• Foryourreference,thetable’sserialnumbercanbefoundonastickermountedto the motor housing.
• Pleasecomplete and mail your warrantycard, or submit it on-lineat www.TeeterHangUps.com.
You are finished assembling your Power IITM Inversion Table. Please remember:
ASSEMBLY
Figure 2
STEP THREE
Secure main shaft (P1-2100) to bed frame assembly (P1-1000)
• Removethe locking knobs (P1-1003) fromthe holes in the mainshaft
(theyarepre-assembledforshippingpurposes).
• Insert the main shaft into the bed frame assembly. (See Figure 2)
• Line up the holes on the back of the bed with those on the main shaft.
Insert and tighten both locking knobs to secure the main shaft to the bed
frameassembly.
STEP FIVE
Connect cord to the power source
• Connectthe cord to your power source* androtate the bed upright using
the power control switch. Make sure the table operates smoothly.
* GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or breakdown, grounding provides a
path of least resistance for electric current to reduce the risk of electric shock. This product
is equipped with a cord having an equipment-grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances. DANGER - Improper connection of the
equipment-grounding conductor can result in a risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as to whether the product is properly grounded.
Do not modify the plug provided with the product - if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
STEP FOUR
Secure handles (P1-1015) to bed frame assembly (P1-1000)
• Insert and tighten the handles into the arms on both sides of the bed frame
assembly. (See Figure 3)
Figure 3
Assembly Instructions #LP1025 Pg. 2
For information about the Teeter Hang Ups®2-year warranty, or if you have any problems assembling the
equipment or questions about its use, please contact Customer Service at the appropriate location below:
USA & Canada:
STL Inc.
9902 162nd St. Ct. E., Puyallup, WA98375
Toll Free (Phone) 800-847-0143 (Fax) 800-847-0188
Local (Phone) 253-840-5252 (Fax) 253-840-5757
(email) Info26@TeeterHangUps.com
(web) www.TeeterHangUps.com
Patentapplies.
TeeterHangUps®isaregisteredtrademarkofSTL
Inc.andInversionInternational,Ltd.
Specificationssubjecttochangewithoutnotice.
©COPYRIGHT2004,STLInc.and
InversionInternational,Ltd.
InternationalLawProhibitsAnyCopying,01/04-1
International:
Inversion International, Ltd.
PO Box: AP 59245, New Providence Island, Bahamas
(Phone) +1-242-362-1001
(Fax) +1-242-362-1002
(web) www.InversionInternational.com
front frame
rear frame
Figure 4
